verilog functions: DSP or microcontroller to the DPRAM of the FPGA to write a data (no more than 2K bytes, the first two bytes on behalf of the send data length), then gives the start signal send_start, this module automatically read the DPRAM data, set the baud rate specified in the DPRAM length of data sent. Interface signals Description: the send_start: Start FPGA serial send the pulse sys_rst: system reset pulse bps_setup: baud rate selection clk5_714: the 5.714MHz clock char_in: DPRAM read out on behalf of the sending data ReadPtr_w: the DPRAM Reading the pointer charout: serial data output bps_clk: SendFlag bit clock (test): Send logo (send data to 1)

RS2322.v

• We are an exchange download platform that only provides communication channels. The downloaded content comes from the internet. Except for download issues, please Google on your own.
• The downloaded content is provided for members to upload. If it unintentionally infringes on your copyright, please contact us.
• Please use Winrar for decompression tools
• If download fail, Try it againg or Feedback to us.
• If downloaded content did not match the introduction, Feedback to us，Confirm and will be refund.
• Before downloading, you can inquire through the uploaded person information

Nothing．