Welcome![Sign In][Sign Up]
Location:
Search - 14.7456Mhz

Search list

[SCMspi.c

Description: tested on an STK500 with an ATmega32 with a 14.7456MHz crystal. Purpose: SPI init, read & write routines without interrupt. These routines works only as an SPI Master.-tested on an STK500 with an ATmega32 with a 14.7456MHz crystal. Purpose: SPI init, read & write routines without interrupt. These routines works only as an SPI Master.
Platform: | Size: 1024 | Author: akhilesh kumar | Hits:

[SCMBlinky3Leds

Description: Program that will flash a 3 leds on pins P0.28, P0.29 and P0.30 of LPC2103 ARM running of 14.7456MHZ XTAL
Platform: | Size: 95232 | Author: ivan | Hits:

[SCMBlinkySecuencial

Description: A program that blinks an LED in sequence between the pins P0.0 to P0.31 of LPC2103 ARM running of 14.7456MHZ XTAL
Platform: | Size: 125952 | Author: ivan | Hits:

[SCMHelloUART0

Description: Program that operates the UART0 to send a message of an LPC2103 ARM running to 14.7456MHZ XTAL
Platform: | Size: 52224 | Author: ivan | Hits:

[SCMHelloUART1

Description: Program that operates the UART1 to send a message of an LPC2103 ARM running to 14.7456MHZ XTAL
Platform: | Size: 99328 | Author: ivan | Hits:

[SCMInterrupTimer0

Description: Program that does an interruption of an ARM LPC2103 TIMER0 running of 14.7456MHZ XTAL
Platform: | Size: 105472 | Author: ivan | Hits:

[SCMInterrupTimer1

Description: Program that does an interruption of an ARM LPC2103 TIMER1 running of 14.7456MHZ XTAL
Platform: | Size: 44032 | Author: ivan | Hits:

[Com PortUART

Description: ARM7 LPC2132 串口调试例程 基于Board LPC21238实验板-// UART Sample Code // NXP Semiconductors // // MCB2130 Board LPC21238: runs in internal Flash // MCB2130 Ram: runs in internal RAM /////////////////////////////////////////////////////////////////////// The UART sample code initializes UART0 (COM0) and sends out a "HELLO". Afterwards it will simply echo anything it receives. Use a serial terminal utility with the following settings: Baud: 115200 Data: 8 Parity: None Handshake: None Note: UART0 has a ISP bootloading feature which might cause the LPC2138 to stay in the bootloader after a reset (Pin 7 and Pin 4 are used as RTS and DTR). This can be avoided by either disconnectiong the ISP and RST jumpers.
Platform: | Size: 22528 | Author: 李迎春 | Hits:

CodeBus www.codebus.net