Description: 802.11n draft4.0,内部资料,大家尽量不要外传,可以供研究与实现WIFI的朋友共享.-802.11n draft4.0, internal information, we try to avoid rumors that could be for research and implementation of WIFI friends sharing. Platform: |
Size: 2384896 |
Author:马洪亮 |
Hits:
Description: The network driver in this package provides a means for developers to create 802.11 packets in user space and send them on the 802.11 layer. Platform: |
Size: 119808 |
Author:Truong minh |
Hits:
Description: uart wifi 串口wifi 程序 单片机可以用的串口wifi模块-microcontroller serial uart wifi wifi program wifi module can be used in serial
Support for UART data serial, four baud rate options: 19200/38400/57600/115200bps.
Wireless data rates support the 802.11b Standard, the maximum rate is 11Mbps.
Integrate the functions of 802.11 MAC protocol Software.
Support for the STA appliances in the Infrastructure Network.
Support for the OPEN/WEP mode authentication.
Support for the wep64/wep128/ccmp/wpi data encryption transmission in the
shared key mode
Support for the automatic networking mode and manual networking mode.
In the automatic networking mode，the module can automatically scan the
target network, and automatically connect when disconnection.
In the manual networking mode，operation of connect and disconnect is touched off by
order，this supports a flexible control space.
Support the Platform: |
Size: 566272 |
Author:Jacky |
Hits:
Description: For legacy compatibility, Direct Sequence Spread Spectrum (DSSS), Complementary Code Keying (CCK) and OFDM baseband processing are included to support all IEEE 802.-RTL8191SU RTL8191SU RTL8191SU Platform: |
Size: 4096 |
Author:hugo |
Hits:
Description: 802.11n physical layer simulink model-802.11n WLAN PHY
Simulation models of 802.11n (modified from 11a PHY model):
wlan/IEEE80211n.mdl
For all simulation models:
--------------------------
Most simulation setting can be configured with the Simulation Settings module
in the lower-left portion of the SIMULINK block diagram. The SNR values to test are
located in the module directly below, PER Test Settings . Currently, the simulation
models are configured for testing a 2x2 antenna configuration, with TGn Channel model D.
For testing with an AWGN channel, the file ch_model.m needs to be modified. For
testing other channel configurations, the file ch_model_tgn.m should be modified (replace
the .mat file tgn_chD_nlos(noflour)_2x2 for load command with other file). Note this file
was generated using the "WLAN MIMO Channel Matlab program" by Laurent Schumacher (see
references [3], [4] below).
Note that most of the other parameters may either be found in the IEEE80211n_settings.m
file, Platform: |
Size: 4047872 |
Author:scootpeng |
Hits:
Search - 802.11-tgn-channel-models