Location:
Search - CMA equalizer
Search list
Description: 自适应均衡器（CMA）的Matlab仿真源程序及仿真结果图-adaptive equalizer (CMA) and Matlab simulation source Simulation results
Platform: |
Size: 2649087 |
Author: 宋家勇 |
Hits:
Description: Blind Equalizer 的演算法主要是利用CMA及 LMS 的配合，当CMA将EYE打开，使讯号趋近于正确值，就切换到LMS，利用Slicer的输出当作training sequence来调整Equalizer的系数，而Carrier Recovery 的部份，则是将phase error track出来-Blind Equalizer algorithm is the use of the CMA and LMS tie, When the CMA will EYE open, signaling close to the correct value, it switched to the LMS. SLICER use of the output as training sequence to adjust Equalize The coefficient r, and some of Carrier Recovery, the type of track out phase error
Platform: |
Size: 5612 |
Author: samyu107 |
Hits:
Description: 这是李晓华博士关于MIMO盲均衡的系统matlab源码，其中设计二阶统计，CMA均衡器，以及子空间方法。-This is Dr. Li Xiaohua on MIMO blind equalization system Matlab source, Design order statistics which, CMA equalizer, and subspace methods.
Platform: |
Size: 102833 |
Author: 到达 |
Hits:
Description: 自适应均衡器（CMA）的Matlab仿真源程序及仿真结果图-adaptive equalizer (CMA) and Matlab simulation source Simulation results
Platform: |
Size: 2649088 |
Author: 宋家勇 |
Hits:
Description: Blind Equalizer 的演算法主要是利用CMA及 LMS 的配合，当CMA将EYE打开，使讯号趋近于正确值，就切换到LMS，利用Slicer的输出当作training sequence来调整Equalizer的系数，而Carrier Recovery 的部份，则是将phase error track出来-Blind Equalizer algorithm is the use of the CMA and LMS tie, When the CMA will EYE open, signaling close to the correct value, it switched to the LMS. SLICER use of the output as training sequence to adjust Equalize The coefficient r, and some of Carrier Recovery, the type of track out phase error
Platform: |
Size: 5120 |
Author: samyu107 |
Hits:
Description: 这是李晓华博士关于MIMO盲均衡的系统matlab源码，其中设计二阶统计，CMA均衡器，以及子空间方法。-This is Dr. Li Xiaohua on MIMO blind equalization system Matlab source, Design order statistics which, CMA equalizer, and subspace methods.
Platform: |
Size: 102400 |
Author: 到达 |
Hits:
Description: cma盲均衡算法，适用于MPSK,低阶MQAM信号。
Platform: |
Size: 2048 |
Author: 敏 |
Hits:
Description: 描述了一个用于微波传输设备的16QAM接收机解调芯片的FPGA实现,芯片集成了定时恢复、载波恢复和自适应盲判决反馈均衡器(DFE),采用恒模算法(CMA)作为均衡算法。芯片支持高达25M波特的符号速率,在一片EP1C12Q240C8(ALTERA)上实现,即将用于量产的微波传输设备中。
-Describes a microwave transmission equipment for 16QAM receiver demodulator chip FPGA realization of an integrated chip timing recovery, carrier recovery and blind adaptive decision feedback equalizer (DFE), using constant modulus algorithm (CMA) as the equalization algorithm. Chip supports up to 25M baud symbol rate, in the midst of EP1C12Q240C8 (ALTERA) achieved for the upcoming production of microwave transmission equipment.
Platform: |
Size: 281600 |
Author: 萝卜 |
Hits:
Description: These M-files generate received T/-spaced, noisy signals from empirically-measured T/2-spaced AppSigTec channels and simulates a blind adaptive equalizer updated with Constant Modulus Algorithm.
Platform: |
Size: 2048 |
Author: Morteza Babaee |
Hits:
Description: T/2 -spaced FSE MMSE equalizer sim
chnnel: carrier offset-T/2-spaced FSE MMSE equalizer sim
chnnel: carrier offset
Platform: |
Size: 1024 |
Author: Kai |
Hits:
Description: LS自适应均衡仿真程序，利用矩阵运算实现，程序简洁，有助于学习和理解自适应算法理论-LS adaptive equalization simulation program, using matrix operations to achieve the program simple, to the learning and understanding adaptive algorithm theory
Platform: |
Size: 1024 |
Author: 鲁信 |
Hits:
Description: 基于matlab和C，包括LMS,CMA,MCMA自适应均衡器的程序和论文，论文说明很详细，可以提供相关参考-Including the LMS, CMA, MCMA adaptive equalizer procedures and papers, research papers explain in great detail and can provide relevant information
Platform: |
Size: 412672 |
Author: 刘军 |
Hits:
Description: 1.原始信号A，通过信道受噪声污染后的信号q，然后分别经过均衡器ZF（MMSE）得到信号U，可以画出U的分布图 2.分别应用LMS,SATO,CMA算法得到U。（其中包括最佳延迟、均方误差的计算）所有结果均以图像形式显示。-1. The original signal A, subject to noise pollution through the channel after the signal q, and then through the equalizer, respectively ZF (MMSE) receive the signal U, the distribution of U can draw Figure 2. Were applied LMS, SATO, CMA algorithm to be U. (Including the best delay, mean square error terms) all the results are displayed in graphic form.
Platform: |
Size: 819200 |
Author: concha |
Hits:
Description: CMA算法均衡器的MATLAB源代码。CMA算法是是Bussgang类盲均衡算法中最常用的一种。-CMA algorithm equalizer MATLAB source code. CMA algorithm Yes Yes Bussgang type blind equalization algorithm most commonly used.
Platform: |
Size: 3072 |
Author: 罗 |
Hits:
Description: CMA算法实现自适应均衡器，对学习MATLAB软件，通信专业的人有用。-CMA adaptive equalizer algorithm, to learn MATLAB software, communications professionals who useful.
Platform: |
Size: 1024 |
Author: juechenxia |
Hits:
Description: CMA 盲均衡算法代码 采用QAM调制信号-CMA，blind equalizer with QAM
Platform: |
Size: 1024 |
Author: leechao |
Hits:
Description: 此程序为QAM算法的应用程序，运用FSE—CMA均衡后的效果程序-This procedure for the application of the QAM algorithm, the use of the CMA equalizer after the FSE-effect program
Platform: |
Size: 1024 |
Author: sjtu |
Hits:
Description: 这个M文件产生了一个以T为周期，来自于经验估计信道的噪声信号，并且仿真了最新的自适应盲均衡恒模算法。-These M-files generate received noisy signals from empirically-measured channels and simulates a blind adaptive equalizer updated with Constant Modulus Algorithm
Platform: |
Size: 2048 |
Author: zhaojian |
Hits:
Description: 主要是盲均衡的自适应算法，CMA算法，并且运用于均衡器之中。-Blind equalization of the adaptive algorithm, the CMA algorithm, and used in the equalizer.
Platform: |
Size: 5120 |
Author: 吴琳珠 |
Hits:
Description: 本篇论文在对无线通信信道进行研究的基础上，阐述了信道产生码间干扰的原因以及无码间干扰的条件，介绍了奈奎斯特第一准则和时域均衡的原理。深入研究了均衡器的结构和自适应算法，在均衡器的结构中主要介绍了4种自适应均衡器结构即线性横向均衡器、线性格型均衡器、判决反馈均衡器和分数间隔均衡器，并对这几种结构进行了比较。对于系数调整算法主要介绍了常用的几种算法，包括LMS算法、RLS算法以及盲均衡常用的恒模算法(CMA)，并讨论了它们各自的优缺点。最后选用线性横向均衡器结构与上述3种系数调整算法，利用MATLAB进行仿真，并对结果进行分析与比较。-adaptive equalizer,
Platform: |
Size: 536576 |
Author: 发生地 |
Hits: