Location:
Search - DSP socket
Search list
Description: DSP序列化反序列化对象SDK开发包
DSP(Dynamic Serialize Packet)是一个动态序列化和反序列化对象的SDK开发包，使用DSP可以将对象序列化成数据流保存到文件中，或者将序列化后的数据流通过Socket传递给远端；也可以使用DSP从文件或Socket中读取数据，然后反序列化成对象。-DSP series of anti-sequence objects DSP Development Kit SDK (Dynamic Packet Serialize) is a dynamic sequence and the anti-sequence objects SDK development kits, the use of DSP target sequence can be turned into data flow to your document, or the sequence of data flow through the transfer to the distal socket; Also DSP can use Socket from the documents or to access data, and then turned into anti-sequence objects.
Platform: |
Size: 123775 |
Author: andy |
Hits:
Description: DSP序列化反序列化对象SDK开发包
DSP(Dynamic Serialize Packet)是一个动态序列化和反序列化对象的SDK开发包，使用DSP可以将对象序列化成数据流保存到文件中，或者将序列化后的数据流通过Socket传递给远端；也可以使用DSP从文件或Socket中读取数据，然后反序列化成对象。-DSP series of anti-sequence objects DSP Development Kit SDK (Dynamic Packet Serialize) is a dynamic sequence and the anti-sequence objects SDK development kits, the use of DSP target sequence can be turned into data flow to your document, or the sequence of data flow through the transfer to the distal socket; Also DSP can use Socket from the documents or to access data, and then turned into anti-sequence objects.
Platform: |
Size: 2847744 |
Author: andy |
Hits:
Description: MPEG4编解C源代码-已移植到ARM和DSP上-MPEG4 Solutions C source code-have been transplanted to the ARM and DSP
Platform: |
Size: 155648 |
Author: 邓修涛 |
Hits:
Description: J T AG 接口插座与DSP芯片的距离:为了保证JTAG信号不受干扰，需
要注意两者之间的距离不超过六英寸(15甲24厘米)，超过这个距离，就需要在中
间加缓冲芯片。本设计中使用了244作为缓冲芯片，但其原因不是由于器件之间
距离过长，而是考虑到仿真器工作在5V电压，DSP引脚为3.3V，为了电平兼容
性而进行的电压转换功能。-JT AG socket interface with DSP chips Distance: JTAG signals in order to guarantee uninterrupted, need to pay attention to the distance between the two is not more than 6 inches (15 A 24 centimeters), more than this distance, we need to increase the buffer between chips. This design was used as a buffer chip 244, but its not because the distance between devices is too long, but taking into account the work in the simulator 5V Voltage, DSP-pin to 3.3V, in order to conduct the compatibility level of the voltage conversion function.
Platform: |
Size: 297984 |
Author: feng |
Hits:
Description: 在evmdm6437上实现dsp与主机之间的通信实例，主机端采用VC2005开发平台，dsp上采用ccs3.3，ndk为1.92版本，内附有在不同频率下通信的测试数据
Platform: |
Size: 54272 |
Author: Zhang sande |
Hits:
Description: protel 下的 TI TMS320VC5509AZHH BGA封装库,加上些常用的如TSSOP28,以及TFT的接口插座封装库,自己用的希望对开发DSP 5509A的朋友有帮助.-Protel under Treasury TI TMS320VC5509AZHH BGA package, together with the more commonly used as TSSOP28, and TFT package socket interface library, with the hope of their own on the development of DSP 5509A friends help.
Platform: |
Size: 19456 |
Author: thzbigone |
Hits:
Description: dsp6713设计重要资料，可共大家编程参考-Design dsp6713 important information, a total of all programming reference
Platform: |
Size: 41984 |
Author: jinliang |
Hits:
Description: 基于套接字的简单的聊天工具,是书上源码.可以作服务端,也可以做客户端.是一个展示网络通信的好源码.-It is a Chatroom, use Socket. This file (the project file) contains information at the project level and
is used to build a single project or subproject. Other users can share the
project (.dsp) file, but they should export the makefiles locally.
Platform: |
Size: 24576 |
Author: 龚志勇 |
Hits:
Description: 源码适合入门之用 想学网络编程的同志可以看看，用vc编的，好象用的是socket，原始套接字编程 程序主要是把网络上的包拦截下来，然后简单解析包头， 整个程序还是比较简单的，不过能让你很容易理解抓包的整体过程-\BinDataDlg.cpp
\BinDataDlg.h
\PackInter.aps
\PackInter.clw
\PackInter.cpp
\PackInter.dsp
\PackInter.dsw
Platform: |
Size: 54272 |
Author: SONG |
Hits:
Description: vc6,网络编程。
Socket编程
│ ReadMe.txt
│ Resource.h
│ Socket.aps
│ Socket.clw
│ Socket.cpp
│ Socket.dsp
│ Socket.dsw
│ Socket.h
│ Socket.ncb
│ Socket.opt
│ Socket.plg
│ Socket.rc
│ Socket.sln
│ Socket.vcproj
│ SocketDlg.cpp
│ SocketDlg.h
│ StdAfx.cpp
│ StdAfx.h-│ ReadMe.txt
│ Resource.h
│ Socket.aps
│ Socket.clw
│ Socket.cpp
│ Socket.dsp
│ Socket.dsw
│ Socket.h
│ Socket.ncb
│ Socket.opt
│ Socket.plg
│ Socket.rc
│ Socket.sln
│ Socket.vcproj
│ SocketDlg.cpp
│ SocketDlg.h
│ StdAfx.cpp
│ StdAfx.h
Platform: |
Size: 9674752 |
Author: kangkang |
Hits:
Description: dsp基于ndk的tcp编程 主要是就是socket的编程 网络的配置部分-DSP based on the NDK TCP programming is mainly is the socket programming network configuration part
Platform: |
Size: 903168 |
Author: 周位强 |
Hits:
Description: 实现ARM和DSP之间的socket通信-realized the link of ARM and DSP by socket
Platform: |
Size: 754688 |
Author: zhouyujiao |
Hits:
Description: 1．EMIF 接口
TMS320F28335DSP 的扩展存储器接口(EMIF)用来与大多数外围设备进行连接，典型应
用如连接片外扩展存储器等。这一接口提供地址连线、数据连线和一组控制线。ICETEK–
F28335-A 将这些扩展线引到了板上的扩展插座上供扩展使用。
2．蜂鸣器由DSP 上EQEP1S 设置为通用I/O 管脚输出控制，可将此管脚上的频率输出转换
成声音输出。
控制的方法是使用 DSP 通用定时器设置EQEP1S 管脚以一定的频率改变高低状态，输
出方波。对于通用定时器周期寄存器的设置，计数值为所需频率计数值的二分之一。
音乐的频率(C 调)：
C D E F G A B ^C
1 2 3 4 5 6 7 ^1
C: 264, 297, 330,352, 396, 440,495, 528
4． 蜂鸣器的连接：由于选用的蜂鸣器所需电流较小，所以采用将DSP 通用I/O 引脚直接
驱动的方式。-The 1.EMIF interface
Extended TMS320F28335DSP memory interface (EMIF) is used to connect with the most peripheral equipment, typical application
Extended memory, such as connecting piece. This interface provides the address lines, data lines and a set of control line. ICETEK-
F28335-A will lead to the expansion of these extended line socket for plate on the expansion of the use of.
2 buzzer by the DSP EQEP1S set to I/O pin output control, the frequency of output this pin on the conversion
A sound output.
The control method is to use the DSP generic timer EQEP1S pin changes state level with certain frequency, transmission
A square wave. For general timer register settings, count values for the required frequency count of 1/2.
The frequency of music (C):
C D E F G A B ^C
1234567 ^1
C: 264, 297, 330352, 396, 440495, 528
Connect the 4 buzzer buzzer: as the current required is small, so the DSP I/O pin directly
Driving mode.
Platform: |
Size: 463872 |
Author: hlp |
Hits:
Description: 控制的方法是使用DSP 通用定时器设置PWM2 管脚以一定的频率改变高低状态，输出
方波。对于通用定时器周期寄存器的设置，计数值为所需频率计数值的二分之一。-TMS320F2812DSP expansion memory interface (EMIF) is used to connect peripheral devices with the most typical applications such as connecting chip extended memory. This interface provides the address of the connection, data connection and a set of control lines. ICETEK-F2812-AE these extensions will lead to the extension cord socket board altar extensions. 2. The buzzer is set by the DSP on PWM2 purpose I/O pin output control, the frequency of this output pin can be converted into sound output. The method of control is to use common DSP timer PWM2 pin to change the level of a certain frequency, the output square wave. For general-purpose timer period register is set, the count value of half the desired frequency count value.
Platform: |
Size: 67584 |
Author: 白板书呆子 |
Hits:
Description: DSP学习资料，语音复读机，①将耳机上麦克风插头插到开发板 板的J2 插座，即上图中“麦克风输入”。
另一端插到电脑的音频输出端。
②将音频信号线一端插头插到I开发板 板的J4 插座，即上图中“耳机输出”，
③调节耳机上音量旋钮到适中位置。-DSP learning data, voice, video machines, ① will plug into the headset jack J2 developed plate board, that the above figure "microphone input."
The other end into the audio output of the computer.
② the audio signal cord plug into the socket J4 I developed plate board, that the above figure, "headphone output"
③ adjust the headset volume knob to a moderate position.
Platform: |
Size: 433152 |
Author: 白板书呆子 |
Hits:
Description: holy c code of great leader
Platform: |
Size: 6144 |
Author: deyruihwuf
|
Hits:
Description: 利用omapl138平台，arm利用socket通信接收IEC61850数据包并交付给DSP进行解包和电能计算，程序设计利用多线程，可实现电能实时计算，满足4k采样速率。(Using omapl138 platform, arm uses socket communication to receive IEC61850 data packet and delivers it to DSP for unpacking and energy calculation. The program design uses multi-threading to realize real-time calculation of power and meet 4k sampling rate.)
Platform: |
Size: 2900992 |
Author: 孙kekekeke |
Hits:
Description: C6455网络传输代码,用于DSP和PC机之间的数据传输和网络通信功能(tcp udp read write data len ,tcp socket udp socket)
Platform: |
Size: 742400 |
Author: 小牛AA |
Hits: