Welcome![Sign In][Sign Up]
Location:
Search - LEDD

Search list

[ARM-PowerPC-ColdFire-MIPSFS44B0X_USB

Description: fs44b0x_usb -- usb 测试程序 PC机部分的软件 1) LEDDEMO -- 控制 FS44B0X板上三个LED的程序 2) D12_DRIVER_FOR_WIN98 -- USB芯片WIN98的驱动程序 3) D12_DRIVER_FOR_WINXP -- USB芯片WINXP的驱动程序 FS44B0X板的USB固件程序--源代码 USB_DEMO 使用方法: 1)在SDT2.51里调入usb_demo.axf, 运行。 2)接上usb电缆,安装win98的d12驱动程序(或者winxp的d12驱动程序) 3) 运行 LEDDEMO ,用鼠标点击led1, led2, led3,可以看到FS44B0X板上三个LED亮灭。 -fs44b0x_usb-- usb test procedure part of the PC software 1) LEDDEM O-- FS44B0X control board three LED procedures 2) D12_DRIVER_FOR_W IN98-- USB chip Win98 driver 3) D12_DRIVER_FOR_WI NXP-- USB chip WINXP driver FS44B0X board USB firmware-- the source of generation code USB_DEMO Use : 1) In SDT2.51 Lane transferred usb_demo.axf running. 2) connected to the USB cable, win98 installation of the D12 driver (or the D12 winxp drivers) 3) Operation LEDD EMO with mouse clicks led1, led2, led3. FS44B0X can see three LED board-eliminate.
Platform: | Size: 219136 | Author: 张淼林 | Hits:

[SCMLEDDOT

Description: 汉字取模软件,对开发显示屏很有用处,有数字取模-Chinese modulus software, very useful for the development of display, there are number of modulus
Platform: | Size: 794624 | Author: gary | Hits:

[CSharpkeycotrldigtu

Description: led for mcu key wormcu led code for mcu ledd thids -mcu led code for mcu ledmcu led code for mcu ledmcu led code for mcu led
Platform: | Size: 15360 | Author: jery | Hits:

[Other systemsLEDD

Description: 点阵LED源码 门控等LED显示屏,-LED sourcecode for door...
Platform: | Size: 22528 | Author: vigour | Hits:

[OS programLEDD

Description: 此例为LED流水灯设计,采用verilog编程,可实现流水灯左右移,增加了分频模块,充分利用实验板LED灯资源、开关资源、按键资源。-This example is water LED lights design, using verilog programming, can be moved around water lights, increasing the frequency module, make full use of experimental board LED light resources, switch resources, key resources.
Platform: | Size: 276480 | Author: 梅兰竹菊 | Hits:

[Software Engineeringfinal

Description: our package is about a sourse code for draw logical gates in java language whith this you can learn how to whrite your own code and add your ideas to this,this can show nang or ang gates and ledd and test the ouyput
Platform: | Size: 3545088 | Author: saboori | Hits:

[assembly languageLEDd

Description: 2-2-1上电数码管显示C,按一次s3,数码管显示以偶数变化即C,A,8,4,2,变化到2之后再从C重复此变化。-The 2-2-1 electric digital tube display on C, according to an s3, digital tube display, even A change or C, A, 8,4,2, change to 2 and then repeat the change C.
Platform: | Size: 9216 | Author: 樊新超 | Hits:

[assembly languageLEDd

Description: 2-2-3 上电数码管显示1,每按一次s1,数码管显示加一,每按一次s2,数码管显示减一,最大显示为8,最小显示为1-The 2-2-3 electric digital tube display 1, each time you press the s1, digital tube display plus one, each time you press the s2, digital tube display minus one, the largest display of 8, minimum display to 1
Platform: | Size: 8192 | Author: 樊新超 | Hits:

[assembly languageLEDd

Description: 1-2-5上电d1,d2全亮一会,之后d1闪烁5次,之后d1,d2交替闪烁4次后停止。-On the 1-2-5 d1, d2 on for a while, after d1 flash 5 times, after the d1, d2 flashing in 4 times after the stop.
Platform: | Size: 8192 | Author: 樊新超 | Hits:

[assembly languageLEDd

Description: 1-1-1d1,d2交替闪烁5次,之后d1,d2同时闪烁4次,一直重复以上过程-After flashing in the 1-1-1 d1, d2 5 times, d1, d2 flashes 4 times at the same time, always repeat the process.
Platform: | Size: 8192 | Author: 樊新超 | Hits:

[assembly languageLEDd

Description: 2-2-5上电数码管显示3,每按一次s2,数码管显示加2,每按一次S1,数码管显示减2,最大显示为b,最小显示为3-On the 2-2-5 electric digital tube display 3, each time you press the s2, digital tube display plus 2, each time you press the S1, digital tube display minus 2, biggest displayed as b, minimum display for 3
Platform: | Size: 8192 | Author: 樊新超 | Hits:

CodeBus www.codebus.net