Location:
Search - PE1
Search list
Description: linux主流芯片使用手册，夏普TFT_LCD手册LQ035Q7DH01.pdf，lts350q1-pe1.pdf，um_s3c2410x_rev11_012003.pdf等
Platform: |
Size: 10041659 |
Author: chenxinrui |
Hits:
Description: linux主流芯片使用手册，夏普TFT_LCD手册LQ035Q7DH01.pdf，lts350q1-pe1.pdf，um_s3c2410x_rev11_012003.pdf等
-mainstream chip linux user manual, Sharp TFT_LCD manual LQ035Q7DH01.pdf, lts350q1-pe1.pdf, um_s3c2410x_rev11_012003.pdf, etc.
Platform: |
Size: 10041344 |
Author: chenxinrui |
Hits:
Description: 一款压缩壳PE123的DELPHI源码
学习写壳的很好的参考-A compression shell PE123 source of DELPHI learning to write shell good reference
Platform: |
Size: 857088 |
Author: selang11 |
Hits:
Description: HY57V561620 datasheet，夏普LQ035Q7DH0 TFT_LCD手册，三星lts350q1-pe1 TFT_LCD手册-HY57V561620 datasheet, manual LQ035Q7DH0 TFT_LCD Sharp, Samsung manual lts350q1-pe1 TFT_LCD
Platform: |
Size: 1504256 |
Author: 群哥 |
Hits:
Description: pe格式以及例子源码.采用c进行编写.
包括import ,export ,map.-pecoff and source code written by c .include import export map.
Platform: |
Size: 128000 |
Author: luyis |
Hits:
Description: 随着电子技术的迅猛发展，具有耗电少、亮度高、体积小等特点的液晶显示器被广泛应用于嵌入式系统中。S3C2410是三星公司开发的一款以ARM920T为核心的16/32位嵌入式处理器。它主要面向手持设备以及高性价比、低功耗的应用。LTS350Q1-PE1是三星电子公司生产的一款非晶硅有源矩阵TFT-LCD，它具有功耗低、亮度高和体积小等特点，目前在嵌入式设备中应用非常广泛。 -With the rapid development of electronic technology, with low power consumption, high brightness, small size and other characteristics of the liquid crystal displays are widely used in embedded systems. Samsung S3C2410 is developed with ARM920T core, a 16/32-bit embedded processor. It is mainly for handheld devices, as well as high cost, low-power applications. LTS350Q1-PE1 is produced by Samsung Electronics a-Si active-matrix TFT-LCD, it has low power consumption, high brightness and small size characteristics, present a wide range of embedded device applications.
Platform: |
Size: 322560 |
Author: wzk |
Hits:
Description: WWDG+LCD1602秒表实验；* WWDG + LCD1602 秒表实验
*两个按键中断方式控制，计时精确到10ms
*key1--Start/Stop---PA8(板子上User键) key2---Clear---PC13(板子上Tamper键)
*LCD1602接线：D0~D7--->PD[0..7] RS->PE0 RW->PE1 E->PE2(外部接上拉电阻到5V)
*by 追梦 2011-4-8
*change by:追梦 2011-4-9 LCD1602有效引脚全部接到PD口
**连接：LCD1602-----> STM32
** D0~D7 ------ PD[0..7]
** RS ------ PD13
** RW ------ PD14
** E ------ PD15-WWDG+ LCD1602 stopwatch test * WWDG+ LCD1602 stopwatch interrupt test* Two buttons control, timing accurate to 10ms* key1--Start/Stop---PA8 (User button on the board) key2--- Clear--- PC13 (Tamper key board)* LCD1602 Connection: D0 ~ D7---> PD [0 .. 7] RS-> PE0 RW-> PE1 E-> PE2 (external pull-up resistor to 5V)* by Dream 2011-4-8* change by: Dream 2011-4-9 LCD1602 effective all the received PD pin port** connecting: LCD1602-----> STM32** D0 ~ D7------ PD [0 .. 7]** RS------ PD13** RW------ PD14** E------ PD15
Platform: |
Size: 1015808 |
Author: 杜运福 |
Hits:
Description: STM8S105S4 矩阵键盘 用STVD开发环境 汇编编程
自己编写的, PE1 PE2记得要外加上拉电阻-STM8S105S4 matrix keyboard with STVD of assembly programming development environment written, PE1 PE2 plus remember to pull-up resistor!!!
Platform: |
Size: 108544 |
Author: 王强 |
Hits:
Description: atmega64的485串口程序，pe4为485芯片控制端口，pe0、pe1为输入输出(Atmega64 485 serial procedures)
Platform: |
Size: 46080 |
Author: 程序猪
|
Hits:
Description: 基于ARM Cortex-M4F(TM4C123)单片机 【功能】微控制器的A/D采集光照强度传感器和电位器的电压，在液晶屏上显示（格式如下，每秒更新一次）
第1行： AD=AIN3(PE0) 【固定不变】
第2行： Light=x.xxx V 【x.xxx 为电压值】
第3行： AD=AIN2(PE1) 【固定不变】
第4行： POT=y.yyy V 【y.yyy 为电压值】(The voltage of the A/D sensor and potentiometer based on the ARM Cortex-M4F (TM4C123) microcontroller [functional] micro controller is displayed on the LCD screen (format as follows, once per second).
The first line: AD=AIN3 (PE0) [fixed]
The second line: Light=x.xxx V [x.xxx as voltage value]
The third line: AD=AIN2 (PE1) [fixed]
The fourth line: POT=y.yyy V [y.yyy as voltage value])
Platform: |
Size: 2195456 |
Author: Der_steppenwolf |
Hits: