Description: 很好的OFDM的基于MATLAB的仿真程序包，且包含了最终结果图.-montecarlo
type montecarlo in the command window and wait for a long time..
_simulation of the complete OFDM system.
_use of a very large file in order to get probabilities.
_loop over different value of the noise.
_compute the SNR for each value of the noise.
_provide the SNR/BER plot.
if you are in a rush : simulation_system !!
go into the right folder and type simulation_system in the command window.
_then type the value of the noise power (range = [-20,10])
_the function provides the channel estimation, the bit allocation,
and a plot illustrating the errors.
_this is a fast function (less pilot, no synchronization, small file). Platform: |
Size: 96256 |
Author:田静 |
Hits:
Description: We simulate uncoded BER of BPSK modulated
data as a function of SNR
-in an AWGN channel
-in a Rayleigh fading channel
-in an AWGN channel when direct sequence spreading
is used
and compare results to the theoretical ones.
We assume coherent receiver and perfect
synchronization.- We simulate uncoded BER of BPSK modulated
data as a function of SNR
-in an AWGN channel
-in a Rayleigh fading channel
-in an AWGN channel when direct sequence spreading
is used
and compare results to the theoretical ones.
We assume coherent receiver and perfect
synchronization. Platform: |
Size: 18432 |
Author:Erfaan |
Hits:
Description: 写一个MATLAB程序，实现4个时间同步的CDMA用户的仿真，其中每个用户都使用长度为L=31的不同的Gold序列。每个用户都采用它们代表的Gold序列的二进制（+-1）调制。每个用户的接收端将这个复合的CDMA接收信号相关，而这个复合的信号都在它们各自的序列上受到AWGN的污损（基于按码片相加）。在N=10000信息比特下，仿真估值并画出作为SNR的函数的CDMA通信系统的差错概率。-Write a MATLAB program, the realization of the four time synchronization of the simulation of CDMA users, including the length of each user for use of the L = 31 different Gold sequences. They are used for each user on behalf of the Gold sequence of binary (+-1) modulation. Each user' s receiver will receive the composite CDMA signal, and this composite signal in the sequence of their respective defaced by the AWGN (additive based on the chip by). Information in the N = 10000 bits, the simulation value and draw as a function of SNR of the CDMA communication system the probability of error. Platform: |
Size: 5120 |
Author:戴路 |
Hits:
Description: MIMO OFDM 技术将成为第4 代移动通信系统的关键技术, 因MIMO OFDM 对时间和频率偏移非常敏感,
因此MIMO OFDM 同步显得尤为重要。提出了一种新的MIMO OFDM 定时同步和频偏同步技术。以GCL 序列为基础设
计了一个新的符合MIMO OFDM 同步技术的导频序列, 通过对该导频序列进行2 次相关得到频率估计, 并将所得频率
运用到定时同步中, 得到更为准确的时间估计。仿真结果表明, 在相同的信噪比情况下, 该方法可以使得系统的误码
率和帧传送误码率相对传统方法得到进一步减小。-MIMO OFDM will become a key technology of the fourth generation mobile communications system. However, MIMO OFDM is
sensitive to the CFO and timing synchronization, so the MIMO OFDM synchronization technology is very important. This paper proposes an
accurate technique for timing and frequency synchronization of multiple input multiple output ( MIMO ) orthogonal frequency division
multiplexing ( OFDM) systems. The technique derives a new preamble signal based on GCL sequences, according with the MIMJO OFDM
synchronization. The carrier frequency offset ( CFO) estimation is obtained through taking double correlation operations on the preamble signal,
and used in the timing synchronization to gain accurate time estimation. The simulation results show that at the same SNR, the proposed method
can reduce the BER and the frame transmission BER of the system compared to the conventional method. Platform: |
Size: 408576 |
Author:蜡笔 |
Hits:
Description: A 16-QAM signal X, whose power is normalized as unity, is transmitted with OFDM over the discrete-time channel model h which has been used in Homework #2 and #3. As depicted in the below figure, the transmitter (TX) is now equipped with an N-point IDFT and the receiver (RX) with an N-point DFT, along with adding cyclic prefix (CP) and removing CP removal, respectively. The complex AWGN n is set with 20 dB SNR. Suppose that N=256 and the length of CP is 64. Assuming the OFDM system works with perfect synchronization. -Generate two pseudo random (PN) sequences for X, each with a length of 256 samples which are taken {+1,-1}, and add them before the 16-QAM data with a proper CP. The OFDM frame is depicted in the following figure. PN1 and PN2 are used for channel estimation now. Suppose the PN patterns are known at RX. Use the least squares (LS) method to estimate the channel by averaging the results obtained individually PN1 and PN2. (When perfoming the DFT window for the received signal at RX, you need to notice that the channel results in a delay of 22 samples.) Platform: |
Size: 210944 |
Author:淘爱57 |
Hits:
Description: music高阶谱分析算法，随机调制信号下的模拟ppm，主同步信号PSS在时域上的相关仿真，最大似然（ML）准则和最大后验概率（MAP）准则，最大信噪比的独立分量分析算法，是小学期课程设计的题目，最小均方误差（MMSE）的算法，单径或多径瑞利衰落信道仿真。- music higher order spectral analysis algorithm, Random ppm modulated analog signal under PSS primary synchronization signal in the time domain simulation related, Maximum Likelihood (ML) criteria and maximum a posteriori (MAP) criterion, SNR largest independent component analysis algorithm, Is the topic of the elementary school stage curriculum design, Minimum mean square error (MMSE) algorithm, Single path or multipath Rayleigh fading channel simulation. Platform: |
Size: 11264 |
Author:bfdgnaysk |
Hits:
Description: 主同步信号PSS在时域上的相关仿真，最大信噪比的独立分量分析算法，DC-DC部分采用定功率单环控制，有较好的参考价值，包括脚本文件和函数文件形式，有PMUSIC 校正前和校正后的比较，music高阶谱分析算法，感应双馈发电机系统的仿真。- PSS primary synchronization signal in the time domain simulation related, SNR largest independent component analysis algorithm, DC-DC power single-part set-loop control, There are good reference value, Including script files and function files in the form, A relatively before correction and after correction PMUSIC, music higher order spectral analysis algorithm, Simulation of doubly fed induction generator system. Platform: |
Size: 6144 |
Author:feyxxi |
Hits:
Description: 欢迎大家下载学习，数据模型归一化，模态振动，可以实现模式识别领域的数据的分类及回归，ICA（主分量分析）算法和程序，主同步信号PSS在时域上的相关仿真，最大信噪比的独立分量分析算法，构成不同频率的调制信号，考虑雨衰 阴影 和多径影响。- Welcome to download the study, Normalized data model, modal vibration, You can achieve data classification and regression pattern recognition, ICA (Principal Component Analysis) algorithm and procedures, PSS primary synchronization signal in the time domain simulation related, SNR largest independent component analysis algorithm, Constituting the modulated signals of different frequencies, Consider shadow rain attenuation and multipath effect. Platform: |
Size: 6144 |
Author:jzteq |
Hits:
Description: 5. 在三条径的瑞利信道中，对于直接序列扩频：
(1) 请设计DS-CDMA一种具体的码分导引辅助的信道估计方法，接收机分别采用等均益合并、最大比合并。用Simulink进行仿真，画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。
(2) 设频率已经同步，请设计DS-CDMA一种具体的单停顿滑动相关时间同步方法，用Simulink进行仿真，画出比特信噪比与捕获概率的关系曲线。
(3) 设时间已经同步，请设计DS-CDMA一种具体的频率同步方法，用Simulink进行仿真，画出比特信噪比与频率同步误差的关系曲线。(5. In three-path Rayleigh channel, for direct sequence spread spectrum:
(1) please design a specific code division navigation aided channel estimation method for ds-cdma, and adopt equal-beneficial combination and maximum ratio combination for receivers respectively.Simulink is used to simulate and draw the relationship curve between bit SNR and channel estimation mean square error and the relationship curve between bit SNR and bit error rate.
(2) assuming that the frequency has been synchronized, please design a specific single-stop sliding correlation time synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and the acquisition probability curve.
(3) if the time has been synchronized, please design a specific frequency synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and frequency synchronization error curve.) Platform: |
Size: 3554304 |
Author:kmdcdy |
Hits:
Description: 6. 在三条径的瑞利信道中，对于OFDM：
(1) 请设计一种具体的导引辅助的信道估计方法，用Simulink进行仿真。画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。
(2) 设频率已同步，请设计OFDM一种具体的采用循环前缀进行时间同步方法，用Simulink进行仿真，画出比特信噪比与捕获概率的关系曲线。
(3) 设时间已同步，请设计OFDM一种具体的采用循环前缀进行频率同步方法，用Simulink进行仿真，画出比特信噪比与频率同步误差的关系曲线。(6. In the three-path Rayleigh channel, for OFDM:
(1) please design a specific navigation-assisted channel estimation method and use Simulink for simulation.The relation curves of bit signal-noise ratio and channel estimation mean square error and the relation curves of bit signal-noise ratio and bit error rate are drawn.
(2) if the frequency has been synchronized, please design a specific method of time synchronization using cyclic prefix in OFDM. Simulink is used for simulation to draw the relationship curve between bit-snr and acquisition probability.
(3) if time has been synchronized, please design a specific method of frequency synchronization using cyclic prefix in OFDM. Simulink is used for simulation to draw the relationship curve between bit signal-to-noise ratio and frequency synchronization error.) Platform: |
Size: 318464 |
Author:kmdcdy |
Hits:
Search - SNR-time Synchronization