Welcome![Sign In][Sign Up]
Location:
Search - STBC MRC

Search list

[matlabBER_MRC_STBC

Description: Visualization of BER for STBC ystem with MRC receiver
Platform: | Size: 2048 | Author: remlein | Hits:

[matlabLink-a-System-Level-OFDM-Simulator

Description: 针对OFDM系统,分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度,采用链路级仿真的部分结果。-It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada
Platform: | Size: 286720 | Author: 王刚名 | Hits:

[Communication-Mobilestbc

Description: stbc,space time black code 接收端不同编码方式,Sc,EGC 和 MRC的比较。-stbc,space time black code at receiver。a comparision of Sc,EGC and MRC
Platform: | Size: 10240 | Author: Emma | Hits:

[Program docAlmouti_Ber_Comparasion

Description: Almouti STBC Bit error comparison with MRC
Platform: | Size: 90112 | Author: sunny | Hits:

[matlabMRC

Description: ns STBC for purely time-selective channels by transforming the time-selective channels into frequency-selective channels, and by adjusting existing space–time code designs over frequency-selective MIMO channels to collect joint space–Doppler gains over purely time-selective MIMO channels. Further, [14] uses the ideas of [12] to develop a space–time code that can achieve full space-delay-Doppler diversity for any number of transmit–receive antennas. However, to quantify the maximum Doppler diversity order [2], the above papers rely on a parsimonious critically sampled complex-exponential basis expansion model (CCE-BEM) for the underlying purely time-selective or doubly-selective channels [16]. However, the CCE-BEM may have a large modeling error under certain channel conditions
Platform: | Size: 1024 | Author: phuong | Hits:

[Program docSTBC.m

Description: 最大似然译码算法在Alamouti方案中的应用。理论上推导出发射天线数为2接收天线为的Alamouti方案与发射天线为1接收天线为2的最大比合并(MRC)接收分集的分集增益相同。并通过Matlab对系统进行了仿真,验证了理论分析的正确性。-Maximum likelihood decoding algorithm in Alamouti Scheme. Theoretically antenna number 2 to the receiving antenna and transmitting antenna Alamouti scheme as a receiving antenna 2 is maximum ratio combining (MRC) diversity reception diversity gain of the same. And the system by Matlab simulation to verify the theoretical analysis.
Platform: | Size: 4096 | Author: 王琛 | Hits:

[Communication-MobileMRC_duoduibi

Description: mrc在瑞利衰落信道在的差错性能比较与分析,岁接收天线的增加,性能的改善情况-。-Program to a receiving antenna, for example, a transmitting antenna, respectively, the two transmit antennas, three transmit antennas and four transmit antenna system STBC simulation. Compare the bit error rate performance
Platform: | Size: 1024 | Author: 许孟虎 | Hits:

[3G developalamouti2_2

Description: This code gives a relative comparison of performance of Alamouti & MRC schemes over Rayleigh channel
Platform: | Size: 1024 | Author: 啊啊啊定时 | Hits:

CodeBus www.codebus.net