Welcome![Sign In][Sign Up]
Location:
Search - T2*测量

Search list

[Other resourcedanpianji-zhongli

Description: 用光电耦合器测量出重物下降过程中经过任何等距离且在同一垂直线上的三点时间间隔t1,t2,及距离h,然后利用公式g=2h(t1-t2)/t1t2(t1+t2)使用浮点数运算方法计算出g的值。最后由单片机p3口送串行显示。
Platform: | Size: 4853 | Author: 张品 | Hits:

[SCM振动仪

Description: 某公司生产手机中的振动电机,当该公司为全球最大的某手机生产公司提供样品的时候,客户提 出一种电机检测方式:客户生产的手机都是采用间歇通电方式来振动的,即振动电机通电一个时间T1, 停止一个时间T2,T1/T2 在20ms/10ms 左右。客户要求样品在出货时提供这种通电方式下的振动量数 据。电机的振动量采用专用设备测量,而电机驱动电路需设计专用的控制电路。为了研究不同占空比 下的特性数据,公司要求制作一台控制器,T1 与T2 分别可调,调节范围在1~99ms 之间。
Platform: | Size: 1223 | Author: yearstone@gmail.com | Hits:

[SCMdanpianji-zhongli

Description: 用光电耦合器测量出重物下降过程中经过任何等距离且在同一垂直线上的三点时间间隔t1,t2,及距离h,然后利用公式g=2h(t1-t2)/t1t2(t1+t2)使用浮点数运算方法计算出g的值。最后由单片机p3口送串行显示。-Optocoupler used to measure the process of heavy decline any equidistant and at the same vertical line of three time intervals t1, t2, and the distance h, and then use the formula g = 2h (t1-t2)/t1t2 (t12B ! t2) the use of floating-point method to calculate the value of g. Finally, I sent Singlechip p3 serial display.
Platform: | Size: 5120 | Author: 张品 | Hits:

[SCMCeilEnvironmentMCUcode

Description: 89s52单片机设计的具有小信号频率检测(小幅度模拟信号频率测量)功能和自动换挡测量功能的最低测量频率1Hz最高测量频率达到10MHz的频率计的ceil环境汇编语言编写的单片机程序(附频率计的protel设计原理图)-89s52 microcontroller designed with the small-signal frequency detection (small amplitude analog signal frequency measurement) functions and automatic shift measurements of the lowest frequency of 1Hz measurement of the maximum measurement frequency of 10MHz frequency meter ceil environment MCU program written in assembly language (with frequency meter The protel schematic design)
Platform: | Size: 59392 | Author: 李光银 | Hits:

[Other Embeded programtemperature

Description: 用2片DB18B20测量温度,0.5秒刷新一次显示在PC机上,格式为“T1=温度1,T2=温度2,A=平均值”。单片机与PC机用MAX232连接。-Temperature measurement using two DB18B20, 0.5 second refresh time displayed on the PC, the format of " T1 = Temperature 1, T2 = temperature 2, A = average." With a MAX232 chip and PC connection.
Platform: | Size: 2048 | Author: 子非鱼 | Hits:

[SCMSTC89S52-T2-capture

Description: 说明:定时器2捕获功能的使用。由于只有三个三个数码管,帮只显示捕获的低八位,经验证,当P1.1(T2EX) 用定时器0控制发出一个下降沿,用T2的P1^1;引脚进行捕获,从而得到高电平时间用以测量波形的宽度 跳变时,数据被捕获-STC89S52 microcontroller timer T2 capture
Platform: | Size: 4096 | Author: chenyong | Hits:

[Otherfun_T2_biNCEXP_fixsigma.rar

Description: 用于磁共振参数T2*测量的一件双边模型函数,所用语言是matlab.
Platform: | Size: 350 | Author: fengmy88@126.com | Hits:

CodeBus www.codebus.net