Description: 一个温控系统的源代码，输入初始温度和目标温度,实现对温度的控制,最终温度稳定在目标温度上.-a temperature control system source code, the importation of the initial temperature and the temperature, the temperature control, the ultimate temperature stability on the target temperature. Platform: |
Size: 124928 |
Author: |
Hits:
Description: ① 设计并开发能检测温度信号，并能产生报警信号的系统；
② 能判断所检测的温度值是否越界；
③ 若温度值越界则进行声（蜂鸣器）、光（发光二极管）报警；
-① designed and developed the ability to detect the temperature signal, and can generate alarm signal systems ② be able to judge whether the detected temperature value of cross-border ③ If the temperature value is then carried out cross-border sound (buzzer), light (light-emitting diode) alarm Platform: |
Size: 530432 |
Author:mike |
Hits:
Description: 功能：完成温控制系统的设计
1） 在设置模式下，用户可以通过按键设置允许最高温度TH 、允许最低温度TL 及转换精度。
2） 在测温模式下,实时测出当前温度并显示。（可采用LED显示或LCD显示，显示结果精度不得低于0.1°C）。
3）在测温模式下，实时比较当前温度与报警温度，当高于高温报警TH 时，系统红灯亮，声音警报响，同时启动冷却电路开始制冷(冷却电路的启动用继电器控制)；当在高温报警TH与低温报警TL 之间时，系统绿灯亮。
-Function: the completion of the design of a in the setting mode, the user can set the buttons to allow the maximum temperature TH, allowing a minimum temperature of TL and conversion accuracy. 2) In the temperature mode, real-time measure the current temperature and displayed. (LED display or LCD display can be used to show the results of accuracy of not less than 0.1 ° C). 3) In the temperature mode, real-time compare the current temperature and alarm temperature, when the TH is higher than high-temperature alarm, the system red light, sound alarm sound at the same time began to start the cooling circuit cooling (cooling circuit to start with the relay control) when the high-temperature alarm TL between TH and low-temperature alarm, the system green light. Platform: |
Size: 7168 |
Author:liqiaoge |
Hits:
Description: at89c51基于单片机的温度控制系统的设计，论文-at89c51 temperature control system based on single chip design, paper Platform: |
Size: 232448 |
Author:qwerty |
Hits:
Description: 本系统严格按照题中所定参数及要求，构建了一个以MSP430单片机为控制核心的温度自动控制系统。该系统用PSB型负温热敏电阻作为温度传感器，以一种类R-F的方法测量木盒内实时温度，单片机用实时温度与预设温度值一起代入PID算式得出一个温度增量，再用此温度增量线性的控制PWM波的占空比，开关电源的输出电压也会随之变化，即制冷晶片的输入功率发生变化，因此制冷晶片制冷（加热）的功率随PWM波占空比变化，达到自动控温的目的。本系统制冷（加热）效果明显，效率高，界面友好，制作精致，能够胜任题中所定各项要求。-Question in strict accordance with the system parameters and requirements set out to construct a MSP430 microcontroller to control the core temperature control system. The system with the PSB-type negative thermal sensitive resistors as temperature sensors, the method in a class of RF real-time measurement of temperature inside the wooden box, single chip with real-time temperature and the preset temperature value into the PID formula come together on behalf of a temperature increase, then this temperature increment linear wave PWM duty cycle control, switching power supply output voltage will change, that is cooling the chip input power changes, so cooling the chip cooling (heating) power with the PWM duty cycle changes in wave to achieve the purpose of automatic temperature control. The system cooling (heating) effect is obvious, efficient, friendly interface, making sophisticated, capable of the requirements set out in the title. Platform: |
Size: 316416 |
Author:康倩 |
Hits:
Description: 本资料纤细的阐述了一个温度测控系统的软硬件开发过程和程序-This information describes a delicate temperature control system hardware and software development processes and procedures Platform: |
Size: 41984 |
Author:王伟 |
Hits:
Search - Temperaturecontrolsystem