Location:
Search - XINT2
Search list
Description: 配置GPIOE为XINT1，XINT2，由于不知道要上载5次，所以一次把五个程序都上载了，现在重新依次上载-GPIOE configuration for XINT1, XINT2, as a result do not know want to upload 5 times, so the first five procedures to upload, and now in order to re-upload
Platform: |
Size: 1024 |
Author: sophia |
Hits:
Description: 2812有三个独立的外部可屏蔽中断XINT1,XINT2,XINT13和一个不可屏蔽中断XNMI，外部扩展可屏蔽中断通过CPLD之后，通过按键产生一外部中断EXINT5。-2812 has three independent external maskable interrupt XINT1, XINT2, XINT13 and a non-maskable interrupt XNMI, external expansion through the CPLD can be screened after the break, produced by an external interrupt button EXINT5.
Platform: |
Size: 240640 |
Author: 蔡全 |
Hits:
Description: TIDSP280x的中断例子程序，包括TIME0、TIME1、TIME2、xint1、xint2，在TIME0中设置GPIO10输出方波-TIDSP280x interrupt example program, including TIME0, TIME1, TIME2, xint1, xint2, in TIME0 set GPIO10 output square wave
Platform: |
Size: 5120 |
Author: 袁生 |
Hits:
Description: 编写TMS320LF2407的对SCI模块、SPI模块、EV中通用定时器（T1、T2、T3、T4）及捕捉逻辑（CAP1\CAP2\CAP3)、外部中断引脚（XINT1、XINT2）和CAN模块初始化程序。-Prepared for SCI module, SPI module, EV in general-purpose timer (T1, T2, T3, T4) and capture logic (CAP1 \ CAP2 \ CAP3), TMS320LF2407 external interrupt pins (XINT1, XINT2) and CAN module initialization procedure.
Platform: |
Size: 4096 |
Author: 刘梦雅 |
Hits:
Description: 本程序用来测试DSP外部中断，把GPIO0、GPIO1分别设为外部中断1（Xint1）和外部中断2（Xint2），两个其他GPIO 分别作为中断的触发信号，完成中断触发。程序运行时，可以观察相应变量的变化。-This procedure is used to test the DSP external interrupt, the GPIO0, GPIO1 were set to external interrupt 1 (Xint1) and external interrupt 2 (Xint2), respectively, as the two other GPIO interrupt trigger signal, complete interrupt is triggered. The program is running, you can observe the changes in the corresponding variable.
Platform: |
Size: 2007040 |
Author: 张玉龙 |
Hits: