Description: 报警产生器,有详细的C语言代码，还有详细的电图，可通过PROTEUS仿真。-Alarm Generator, has a detailed C language code, there is a detailed electrical diagram, through the PROTEUS simulation. Platform: |
Size: 113664 |
Author:申晓波 |
Hits:
Description: proteus仿真
ad590 与 8951 制作的温度报警器，当温度高于65度，报警。可手动取消。-Proteus simulation AD590 and 8951 produced by the temperature alarm, when the temperature is higher than 65 degrees, alarm. Can be manually canceled. Platform: |
Size: 224256 |
Author:jiangyang |
Hits:
Description: 基于PIC16F877A的DS18B20一线总线多路测温系统（采用Proteus模拟）。
Proteus模拟电路图＋PIC C语言源程序（MPLAB V8.00）
这可不是用多I/O模拟的多路测温哦！看系统功能：
1）、由一线数据线寄生供电，采用MOSFET强上拉给DQ供电；
2）、上电自动搜索可用的传感器并做CRC校验（实现了Search ROM命令）；
3）、 报警下限可选择；
4）、轮询显示温度，通过LCD1602输出；
5）、 传感器中途拔出或温度越界均报警；
6）、 采用声光报警方式，可做为温度控制信号标志。
-PIC16F877A-based multi-channel bus of DS18B20 line temperature measurement system (using the Proteus simulation). Proteus analog circuit+ PIC C language source code (MPLAB V8.00) This is not using multiple I/O simulation of multi-channel temperature measurement Oh! See system functions: 1) by the parasitic power line data line, using MOSFET strong pull-up power supply to the DQ 2), power-on automatically search for available sensors and do CRC check (to achieve a Search ROM command) 3) alarm limit choice 4), polling shows the temperature, through the LCD1602 output 5), half-way pulled out or the temperature sensors are all cross-border police 6), using sound and light alarm mode can be used as the temperature control signal flags. Platform: |
Size: 180224 |
Author:王萧风 |
Hits:
Description: 本项目设计采用了6位数码管显示电路，在设计6位LED显示时，为了简化电路，降低成本，采用动态显示的方式，6个LED显示器共用一个8位的I/O，6位LED数码管的位选线分别由相应的P2.0--P2.5控制，而将其相应的段选线并联在一起，由一个8位的I/O口控制，即P0。译码显示电路将“时”，“分”，“秒”计数器的输出状态经显示译码器译码，通过6位LED七段显示器显示出来。达到定时电路时根据计时系统的输出状态产生的一个脉冲信号，然后去触发蜂鸣器发生器来实现闹铃。校时电路是用来对“时”，“分”，“秒”显示数字进行校对调整的。压缩文件中的仿真文件可以用Proteus查看。-The project was designed with six digital tube display circuit, in the design of six LED display, in order to simplify the circuit, reduce costs, dynamic display mode, 6 LED displays share one 8-bit I/O, 6 Wei LED Digital Choice of line pipe by the corresponding P2.0- P2.5 control, whereas the corresponding segment of its alignment parallel together by an 8-bit I/O port control, that is, P0. Decode display circuit will be "time", "sub", "seconds" counter output state by the display decoder decoding, through the six LED seven-segment display is displayed. To achieve timing circuit timing system according to the output of the state generated by a pulse signal, and then to trigger generator to achieve the alarm buzzer. The school when the circuit is used to "time", "sub", "seconds" display figures proofreading adjusted. Compressed file in the simulation files can be used Proteus view Platform: |
Size: 21504 |
Author:David |
Hits:
Description: pic单片机控制蜂鸣器发出警报声，用c语言写的，proteus仿真通过-pic microprocessor controlled alarm buzzer sound, written with the c language, proteus simulation by Platform: |
Size: 53248 |
Author:likeli |
Hits:
Description: （一）要求：用PROTEUS画出原理图和PCB图，并完成下列任务：
⑴ 用4只LED数码管输出显示时和分。
⑵ 可通过按键设置闹钟功能，且停闹无须手工操作。
⑶ 可通过按键设置分校时。
(4) 写出详细的设计报告。
(5) 给出电路的原理图、PCB图和源程序。
（二）优秀要求：根据PCB图制作PCB板，并焊接元件调试
-(A) requires: The PROTEUS draw schematic and PCB plans and complete the following tasks: ⑴ with four LED digital tube display and sub output. ⑵ can set the alarm button, and stop trouble without manually. ⑶ by pressing a button when setting campus. (4) write a detailed design report. (5) gives the circuit schematic, PCB diagrams and source code. (B) of the outstanding requirements: According to the PCB Mapping PCB, and soldering device debugging Platform: |
Size: 247808 |
Author:张龙 |
Hits:
Description: 这是一个DS18B20温度计+LCD1602液晶+键盘调温的proteus仿真实例，实例中键盘的7键是加1，8键是减1，4键进入上限报警温度TH设置，5键是进入下限报警温度TL设置，6键进入用户设定温度设置，4/5/6三个键是互锁的，就是说4键有效时，5和6就不起作用。-This is a DS18B20 thermometer+ LCD1602 LCD+ keyboard thermostat proteus simulation example, the instance of the keyboard 7 key is added 1,4 1,8 key is the key to enter the upper alarm by temperature TH set, 5 key is to enter lower limit alarm temperature TL setting, 6 to enter the user set temperature settings, 4/5/6 three keys are interlocked, that is 4 keys to effective, 5 and 6 will not work. Platform: |
Size: 66560 |
Author:si |
Hits:
Description: 以51单片机为核心 DS1302做时钟芯片制作的闹钟 具有设置时间和闹钟功能 利用T9输入法输入备忘可实现定时提醒 Proteus下仿真通过-DS1302 with 51 microcontroller core clock chip production to do with setting the alarm time and alarm functions using T9 input method allows time to remind the memo under the simulation by Proteus Platform: |
Size: 312320 |
Author:rabbit |
Hits:
Description: 51单片机为核心实现时钟功能 用四个按键即可控制 具有设置时间和闹钟功能 Proteus下仿真通过-51 the clock functions as the core chip with four buttons to control a set time and alarm functions under the simulation by Proteus Platform: |
Size: 67584 |
Author:rabbit |
Hits:
Description: 用51单片机为核心 将DS1302测得的温度值输入单片机 用1602显示出来 可以设置报警温度 超过报警温度时蜂鸣器响 Proteus下仿真通过-Microcontroller core with 51 measured the temperature of the DS1302 chip with a 1602 value of the input display can be set to alarm when the temperature exceeds the temperature alarm buzzer under the simulation by Proteus Platform: |
Size: 60416 |
Author:rabbit |
Hits:
Description: 本设计中，电子密码锁使用STC89C52单片机控制，采用 C语言编写，通过Proteus软件仿真并进行了实物焊接。电子密码锁通过矩阵键盘进行密码输入，1602A液晶显示模块进行显示。其可实现的功能有：（1）通过切换，对输入的4位密码进行显示或隐藏；（2）通过发光二极管和蜂鸣器，对解密正确或者错误进行声光报警；（3）4位密码修改；（4）在密码遗失情况下，通过初始密码进行密码再设置；（5）采用AT24C02外部存储器，完成断电密码保护功能；（6）具有1-9次的解锁次数任意设定功能；（7）模拟密码箱随机产生密码，并进行解码。本设计特色为采用1602A液晶显示模块，这使得显示更加直观、使用更加方便。密码可实现显示和隐藏切换，通过隐藏密码实现密码保护。-In this design, the electronic code lock use STC89C52 SCM using C language by Proteus software simulation and physical welding. Electronic lock matrix keyboard for password input, 1602A LCD module for display. Its function can be realized: (1) by switching the input four passwords to display or hide (2), right or wrong of the decryption by light-emitting diode and buzzer sound and light alarm (3) 4 (4) In the case of password is lost, the initial password for password re-set password is modified (5) the AT24C02 external memory to complete the power-off password protection (6) have 1-9 times the number of unlock any set given function (7) analog password box randomly generated password, and decoding. The design features of the LCD module using the 1602A, which makes the display more intuitive, easier to use. The password can show and hide the switch, by hiding the password to a password-protected. Platform: |
Size: 71680 |
Author:liuguangfeng |
Hits:
Description: 使用AT89C51,DS18B20的温度报警系统，已通过PROTEUS仿真验证-Alarm system of temperature,containing AT89C51 and the DS18B20 chip, has been verified by PROTEUS simulation Platform: |
Size: 62464 |
Author:wudigegege |
Hits:
Description: 基于51单片机，通过中断实现液晶电子钟功能，有四个功能键，有闹钟功能。带有配套Proteus仿真文件。适合作为入门参考用。-Achieved by interrupting LCD electronic clock function, there are four function keys, with alarm function. Proteus simulation with supporting documents. Platform: |
Size: 49152 |
Author:李佳明 |
Hits:
Description: 本设计介绍了电子密码锁的应用背景，基本功能和实现方法。在硬件方面，以51单片机为主控芯片，带有一个4*4的矩阵键盘作为密码输入的方式，通过1602液晶显示器提示程序运行状态和使用步骤，并采用了24C02芯片实现对密码的存储功能。利用蜂鸣器、发光二极管、继电器模拟报警和锁的开关。在软件方面，实现了密码的输入、清除、更改，删除等功能。在设计过程中引入了信息反馈的思想，使密码锁功能更灵活、更切合实际。有的按键可实现一键多用的功能，节约资源。本设计已通过Proteus软件成功仿真的电子密码锁的实现过程，并完成实物。-This paper introduces the electronic combination lock application background, basic function and implementation method. In terms of hardware, this design uses 51 single-chip microcomputer as main control chip, with a 4* 4 matrix keyboard as a means of password entry. It adopts 24C02 chip to complete the code s memory function, using LCD 1602 to prompt the program s running state and working procedures, adopting buzzer,LED and relay to imitate the alarm and the lock switch. In the aspect of software, it realizes the password input, remove, change, delete, etc. That it introduces the ideas of information feedback makes the combination lock function more flexible, more practical. A key to achieve some keys can use function, saving the resource. The electronic code lock was successfully simulated by Proteus, at the same time , the entity also was completed. Platform: |
Size: 88064 |
Author:feichen |
Hits:
Description: 使用keil平台与汇编编写的51单片机程序，可以执行电子时钟功能，可修改时间与设置闹钟，内含proteus仿真，验证通过。(The 51 microcontroller program written by keil platform and assembler can execute the function of electronic clock. It can modify the time and set the alarm clock, and contains proteus simulation.) Platform: |
Size: 577536 |
Author:米粒爱玩
|
Hits:
Search - alarm by proteus