Location:
Search - atmega8 s
Search list
Description: 这是NORDIC公司NRF2401基于AVR单片机的程序源代码，很有参考价值！-NRF2401 based on the company's AVR program's source code was useful!
Platform: |
Size: 19456 |
Author: 陈慧斌 |
Hits:
Description: 双龙公司的实验板的实验源代码，已经通过验证，没有实验板的可以自己做，这是初学者的入门很好的入门程序-Ssangyong's board of Experimental Experimental source code has been validated, no experimental board can do it themselves, This is a good beginners entry to the entry procedures
Platform: |
Size: 675840 |
Author: 求知 |
Hits:
Description: AVR单片机系列之所有寄存器名称及位定义、功能等说明。-AVR Series register names and all spaces defined function note.
Platform: |
Size: 23552 |
Author: 周云龙 |
Hits:
Description: Nissan车载主机与松下8碟机的转接程序 转接cpu为avr的atmega8单片机-Nissan Car mainframe with 8 drive adapter Panasonic procedures cpu adapter for avr s atmega8 Singlechip
Platform: |
Size: 314368 |
Author: 刘光勇 |
Hits:
Description: 这个文件是ATMEGA8的实验板原理图，大家可以下载，在我们公司已经使用，至今效果还可以，大家下载。-This document is ATMEGA8 schematic diagram of the experimental board, everyone can download, in our company have been used and the result also can download the U.S..
Platform: |
Size: 78848 |
Author: xin |
Hits:
Description: u-blox的GPS模块LEA-5x,三本例子为ATMEGA1280对他的操作的程序-u-blox s GPS Module LEA-5x, three examples for the ATmega1280 his operation procedures
Platform: |
Size: 70656 |
Author: 丁远辉 |
Hits:
Description: 红外遥控器已被广泛使用在各种类型的家电产品上，它的出现给使用家器提供了很多的便利。红外遥控系统一般由红外发射装置和红外接受设备两大部分组成。红外发射装置又可由键盘电路、红外编码芯片、电源和红外发射电路组成。红外接收设备可由红外接收电路、红外解码芯片、电源和应用电路组成。通常为了使信号能更好的被传输发送端将基带二进制信号调制为脉冲串信号，通过红外发射管发射。本设计采用Atmega8作为红外发射编码和接收解码芯片。-Infrared remote control has been widely used in various types of household electrical appliances, it' s there to provide the users a lot of convenience. Infrared remote control system in general by the infrared emission devices and infrared devices to accept the composition of two major parts. Infrared emission circuit device can be by keyboard, infrared encoder chip, power and infrared emission circuit. By the infrared receiver infrared receiver circuit equipment, infrared decoder chip, power supply and application circuit. Usually better in order to signal the sending end of the transmission to binary base-band signal for pulse modulation, through the launch tube infrared emission. The design uses infrared emission Atmega8 as encoding and decoding chip receiver.
Platform: |
Size: 476160 |
Author: 金静 |
Hits:
Description: ATMEGA8-ad-number-led-学习AVR的朋友们挺多的，但对于一初学者来说不知从何入手，不妨参考下我的教学代码。这是第一次接触时用的。-ATMEGA8-ad-number-led-learning挺多friends AVR' s, but I do not know where to start for a beginner, may wish to refer to the following code to my teaching. This is the first time used in contact.
Platform: |
Size: 8192 |
Author: kenychen |
Hits:
Description: AVR单片机中的atmega8的应用PCB图-the aplication of the avr,this is the PCB board!
Platform: |
Size: 135168 |
Author: 阮开明 |
Hits:
Description: 讲述AVR的高端单片ATmega系列最简单的单片机ATmega8的实例应用，其中包含有每个部分的应用电路图和实际的全部程序代码。-About AVR' s high-end single-chip microcontroller ATmega series of the simplest examples of ATmega8 application, which contains the application of each part of the full circuit diagram and the actual program code.
Platform: |
Size: 2362368 |
Author: 杨冲 |
Hits:
Description: 今天的微控制器速度已经可以通过软件轻而易举地实现这一切。而且更妙的是电压表和电流表成了免
费的副产品。微控制器的控制环无论如何都必须知道电压和电流值。你刚好也要显示它。我们要从微控制
器得到的是：一个在所有时间都用来测量电压和电流的A/D 转换器；一个根据命令为功率三极管提供基准
电压的D/A 转换器。问题是那个D/A 转换器的速度要非常快。如果在输出端检测到了短路，那么我们必
须立即减小三极管B 极上的电压，否则这个三极管就会损坏。“快速”意味着要达到毫秒级，如同运算放
大器一样。Atmega8 的A/D 转换器已经足够快了，但显然它没有D/A 转换器。使用脉宽调制和模拟低通滤
波器是可以得到一个D/A 转换器的，但是这样速度太慢了，无法通过软件立即实现短路保护。-The speed of today s micro-controller has been easily achieved through software, all that. And even more interesting is the voltage meter and ammeter become free
Charge by-product. Micro-controller control loop in any case have to be aware of voltage and current values. You have to show that it happened. We must microcontroller
Device get is: 1 at all times be used to measure voltage and current of the A/D converter one under the command and provide the basis for the power transistor
Voltage of D/A converter. The problem is that D/A converter to be very fast speed. If the output short circuit is detected, then we must
Shall immediately reduce the voltage on the transistor B pole, otherwise the transistor will be damaged. "Fast" means to achieve milliseconds, as the operator put
Like Da-qi. Atmega8 of the A/D converter has been fast enough, but apparently it does not D/A converter. The use of pulse-width modulation and analog low-pass filter
Wave device be able to get a D/A
Platform: |
Size: 584704 |
Author: xiexie |
Hits:
Description: 在ICCAVR下编译，ATmega8与nRF24L01通过SPI进行通信，并实现无线收发数据-In ICCAVR compile, ATmega8 and nRF24L01 communicate via SPI and to send and receive data wirelessly
Platform: |
Size: 5120 |
Author: 徐飞 |
Hits:
Description: 单片机采用了当前比较流行的一款AVR 芯片ATMEGA8，
红外摇控器发出的信号被TSOP1738 解调后，传送到单片机I/O 口，单片机按一定时序进行
解码并得到按键代码，根据不同的按键代码控制继电器K1 和K2，实现连接在继电器相应
输出口的电器电源的开通与关断功能。D1 和D2 用于同步指示K1 和K2 的开关状态，Q1
和Q2 分别用于驱动继电器K1 和K2。R4 和C3 构成TSOP1738 供电引脚上的滤波电路，起
到了抗干扰作用。
电-SCM uses a current popular AVR chip ATMEGA8, infrared remote control signal emitted by TSOP1738 demodulation, the transmitted to the MCU I/O port, single chip to decode a certain timing and get key code, key code according to different control relays K1 and K2, to achieve the appropriate output port connected to the relay' s opening and the electrical power off function. D1 and D2 K1 and K2 used to synchronize the switching instructions state, Q1 and Q2 are used to drive relay K1 and K2. R4, and C3 form TSOP1738 supply pins on the filter circuit, played a role in anti-interference. Electricity
Platform: |
Size: 109568 |
Author: 小老鼠 |
Hits:
Description: 实现了atmega8与atmega16的SPI通信，atmega16作为主机，atmega8作为从机-Achieved atmega8 and atmega16 the SPI communication, atmega16 as a host, atmega8 as a slave
Platform: |
Size: 25600 |
Author: mengshiliang |
Hits:
Description: HIDKey
BootloadHID is a USB boot loader for AVR microcontrollers.-his is the README file for bootloadHID.
BootloadHID is a USB boot loader for AVR microcontrollers. It can be used on
all AVRs with at least 2 kB of boot loader section, e.g. the popular ATMega8.
The firmware is flashed into the upper 2 kB of the flash memory and takes
control immediately after reset. If a certain hardware condition is met
(this condition can be configured, e.g. a jumper), the boot loader waits for
data on the USB interface and loads it into the remaining part of the flash
memory. If the condition is not met, control is passed to the loaded firmware.
This boot loader is similar to Thomas Fischl s avrusbboot, except that it
is built on top of the HID device class. This implementation is more user
friendly on Windows, since no kernel level drivers need to be installed.
FILES IN THE DISTRIBUTION
=========================
Readme.txt ........ The file you are currently reading.
firmware .......... Source code of the controller firmware.
firmware/usbdrv
Platform: |
Size: 138240 |
Author: losite |
Hits:
Description: 基于ATmega8 的ucos-II应用-ATmega8' s ucos-II-based applications
Platform: |
Size: 174080 |
Author: fjc |
Hits:
Description: ATmega8与单片机的串口进行通信的调试程序，对于开发协议转换器时，进行调试时可能会有些帮助。-ATmega8 microcontroller' s serial port to communicate with the debugger, the time for the development of protocol converters, debugging may be helpful.
Platform: |
Size: 7080960 |
Author: 王强 |
Hits:
Description: 基于avr单片机atmega8的串口源代码，波特率9600，晶振7.3728.-this is the source of avr atmega8 s uart and the Crystal is 7.3728 MHz.
Platform: |
Size: 17408 |
Author: 赖江 |
Hits:
Description: 基于avr单片机atmega8的EEPROM的读写。-the source of atmega8 s EEPROM
Platform: |
Size: 27648 |
Author: 赖江 |
Hits:
Description: 基于avr单片机atmega8的IIC接口的读写。-the source of atmega8 s IIC
Platform: |
Size: 35840 |
Author: 赖江 |
Hits: