Description: 一个4*8天线数的mimo仿真程序,采用16QAM调制解调,在平坦衰落环境下的误码率情况-a 4* 8 the number of MIMO antenna simulation program using 16QAM modulation and demodulation, the decline in flat environment of the BER Platform: |
Size: 2048 |
Author:张勤 |
Hits:
Description: 一个4*4mimo通信系统的仿真,qpsk调制,用mmse自适应解调,画出了ber曲线-A 4* 4mimo communication system simulation, qpsk modulation and demodulation with adaptive mmse, draw a curve ber Platform: |
Size: 1024 |
Author:yangxidan |
Hits:
Description: Script for computing the BER for BPSK modulation in a
Rayleigh fading channel with 2 Tx, 2Rx MIMO channel
Zero Forcing Equalization with Successive Interference
Cancellation (ZF-SIC)-Script for computing the BER for BPSK modulation in a
Rayleigh fading channel with 2 Tx, 2Rx MIMO channel
Zero Forcing Equalization with Successive Interference
Cancellation (ZF-SIC) Platform: |
Size: 2048 |
Author:mohanad1 |
Hits:
Description: A multiple-input multiple-output (MIMO) communication system combined with the orthogonal frequency division multiplexing (OFDM) modulation technique can achieve reliable
high data rate transmission over broadband wireless channels. Channel state information for both single-input single-output (SISO) and MIMO systems based on pilot aided arrangement is
investigated in this paper. The estimation of channel at pilot frequencies with conventional Least Square (LS) and Minimum Mean Square (MMSE) estimation algorithms is carried out
through Matlab simulation. The performance of MIMO OFDM and SISO OFDM are evaluated on the basis of Bit Error Rate (BER) and Mean Square Error (MSE) level.-A multiple-input multiple-output (MIMO) communication system combined with the orthogonal frequency division multiplexing (OFDM) modulation technique can achieve reliable
high data rate transmission over broadband wireless channels. Channel state information for both single-input single-output (SISO) and MIMO systems based on pilot aided arrangement is
investigated in this paper. The estimation of channel at pilot frequencies with conventional Least Square (LS) and Minimum Mean Square (MMSE) estimation algorithms is carried out
through Matlab simulation. The performance of MIMO OFDM and SISO OFDM are evaluated on the basis of Bit Error Rate (BER) and Mean Square Error (MSE) level. Platform: |
Size: 729088 |
Author:loihuynh |
Hits:
Description: 为了提高MIMO-OFDM系统的数据传输率和频谱利用率,提出一种新的自适应算法。该算法在保证信道质量所需误码率和总发射功率的前提下,按照各个子载波衰落程度动态地分配比特和功率,使系统的总数据传输速率最大。理论分析得出,该算法降低了系统运算复杂度,能很大地改善系统的整体性能。-In order to improve data transmission rates and spectrum efficiency of MIMO-OFDM systems,this paper proposes a new adaptive algorithm. While the channel transmission quality to meet the requirements of a certain target BER(bit error rate) and total emissive power,according to each sub-carrier decline degree to adjust each sub-carrier modulation method freely,try to minimize the total data rate of system. Theory analysis shows the algorithm can reduce system complexity and improve overall performance of the ... Platform: |
Size: 205824 |
Author:王睿 |
Hits:
Description: 运用matlab搭建了MIMO—OFDM系统,并仿真了该系统在awgn信道,平坦衰落和多径信道下的误码率。-Using matlab built a MIMO-OFDM systems, and simulation of the system in awgn channel, flat fading and multipath channel BER. Platform: |
Size: 19456 |
Author:hahaha |
Hits:
Description: MIMO OFDM 技术将成为第4 代移动通信系统的关键技术, 因MIMO OFDM 对时间和频率偏移非常敏感,
因此MIMO OFDM 同步显得尤为重要。提出了一种新的MIMO OFDM 定时同步和频偏同步技术。以GCL 序列为基础设
计了一个新的符合MIMO OFDM 同步技术的导频序列, 通过对该导频序列进行2 次相关得到频率估计, 并将所得频率
运用到定时同步中, 得到更为准确的时间估计。仿真结果表明, 在相同的信噪比情况下, 该方法可以使得系统的误码
率和帧传送误码率相对传统方法得到进一步减小。-MIMO OFDM will become a key technology of the fourth generation mobile communications system. However, MIMO OFDM is
sensitive to the CFO and timing synchronization, so the MIMO OFDM synchronization technology is very important. This paper proposes an
accurate technique for timing and frequency synchronization of multiple input multiple output ( MIMO ) orthogonal frequency division
multiplexing ( OFDM) systems. The technique derives a new preamble signal based on GCL sequences, according with the MIMJO OFDM
synchronization. The carrier frequency offset ( CFO) estimation is obtained through taking double correlation operations on the preamble signal,
and used in the timing synchronization to gain accurate time estimation. The simulation results show that at the same SNR, the proposed method
can reduce the BER and the frame transmission BER of the system compared to the conventional method. Platform: |
Size: 408576 |
Author:蜡笔 |
Hits:
Description: With the increasing demand of higher data rate for telecommunication, the IEEE802.11n standard was constituted in 2009. The most important character of the standard is MIMO-OFDM, which not only improves the throughput but also the spectrum efficiency and channel capacity. And in wireless communication, the role of MIMO detectors plays an important part to remove inter-symbol interference (ISI) caused by multipath fading channel. In this paper the BER performance of IEEE 802.11n for 3x2, 4x2 and 4x3 antennas are compared using MMSE and ZF detectors in Matlab Simulink. Platform: |
Size: 465920 |
Author:wawi |
Hits:
Description: Matlab code which implements MB-OFDM transmission block as per ECMA 368 standard.
OFDM over frequency selective wireless channels
simulation code for Peak-to-Average Power Ratio (PAPR) reduction in MIMO OFDM/A system using CMA
This is an OFDM simulation that gives you the PAPR, BER, and the PSD before and after the SSPA.
the program distribute an amount power among ofdm subchannel to make the capacity of a channel as ma
Representation of OFDM signal with PAPR reduction using Clipping and SLM Techniques.
The complete project of OFDMA system. It tries to maximize the network capacity.
Link and system level simulator for OFDM based wireless broadband systems
Ultrawideband (UWB) multiband OFDM physical layer with fixed-point transmitter/receiver modeling.
Platform: |
Size: 858112 |
Author:Sina |
Hits:
Description: 这个例子展示了如何用波束形成来模拟点对点MIMO-OFDM系统。多输入多输出(MIMO)组合和正交频分复用(OFDM)技术已在最近的无线标准的采用,如802.11X,提供更高的数据传输速率。由于MIMO采用天线阵,波束形成可以提高接收信噪比,进而降低误码率。(This examples shows how to model a point-to-point MIMO-OFDM system with beamforming. The combination of multiple-input-multiple-output (MIMO) and orthogonal frequency division multiplexing (OFDM) techniques have been adopted in recent wireless standards, such as 802.11x families, to provide higher data rate. Because MIMO uses antenna arrays, beamforming can be adopted to improve the received signal to noise ratio (SNR) which in turn reduces the bit error rate (BER).) Platform: |
Size: 60416 |
Author:逗
|
Hits: