Description: C32中C语言中嵌入汇编程序示例.包括中断程序中调用C参数-C32 C language embedded assembler example. Including the interruption procedure called C parameters Platform: |
Size: 88534 |
Author:杨宇 |
Hits:
Description: GENERIC PROGRAM FOR A FAST LOOPED-CODE RADIX-2 DIT FFT-GENERIC PROGRAM FOR A FAST LOOPED-CODE RAD IX-2 DIT FFT Platform: |
Size: 132392 |
Author:yy |
Hits:
Description: dsp c32下开发的waver单边带调制程序-dsp good under development seeks single sideband modulation procedures Platform: |
Size: 15587 |
Author:杨思翔 |
Hits:
Description: This demo uses the selected hardware platform as an SD card reader. Connect the hardware platform to a computer through a USB cable.
To run this project, you will need to load the corresponding firmware into the devices. There are two methods available for loading the demos: Precompiled demos and source code projects.
Precompiled Demos are available in the “\USB – Precompiled Demos” folders. Each demo should be prefaced with the hardware platform it is compiled for. Select the file that matches the hardware that you have and the demo that you want to run. For more information about how to load a precompiled project, please see the “Getting Started – Loading a precompiled demo” guide.
The source code for this demo is available in the “Topics…->MPLAB IDE).
Please note that when using either the C30 or C32 demo projects you will be required to select the correct processor for the demo board.
1) Open the associated project file
2) In MPLAB Select “Configure->Select Device”
3) In the device list box in the top left corner of that window, select the desired device.
NOTE WHEN USING THE HID BOOTLOADER (for PIC18F87J50 PIM): The “USB Device - Mass Storage - SD Card reader” and “USB Device - Mass Storage - SD Card data logger” demos make use of the SD Card PICtail Daughter Board (Microchip® Direct: AC164122). This PICtail uses the RB4 I/O pin for the card detect (CD) signal, and is actively driven by the PICtail. The active drive overpowers the pull up resistor on the RB4 pushbutton (on the PIC18F87J50 FS USB Plug-In Module board). As a result, if the PIC18F87J50 is programmed with the HID bootloader, and an SD Card is installed in the socket when the microcontroller comes out of reset, the firmware will immediately enter the bootloader (irrespective of the RB4 pushbutton state). To exit the bootloader firmware, remove the SD Card from the SD Card socket, and tap the MCLR button. When the SD Card is not plugged in, the PICtail will drive the card detect signal (which is connected to RB4) logic high, which will enable the bootloader to exit to the main application after coming out of reset. Once the main application firmware is operating, the SD Card can be plugged in. The SD Card is “hot-swappable” and should be recognized by the host upon insertion. To avoid this inconvenience when using the bootloader with the PICtail, it is suggested to modify the bootloader firmware to use some other I/O pin for bootloader entry, such as RB0 (which has a pushbutton on it on the HPC Explorer board).
Platform: |
Size: 773398 |
Author:bluntpig |
Hits:
Description: dsp c32下开发的waver单边带调制程序-dsp good under development seeks single sideband modulation procedures Platform: |
Size: 15360 |
Author:杨思翔 |
Hits:
Description: C32中C语言中嵌入汇编程序示例.包括中断程序中调用C参数-C32 C language embedded assembler example. Including the interruption procedure called C parameters Platform: |
Size: 88064 |
Author:杨宇 |
Hits:
Description: GENERIC PROGRAM FOR A FAST LOOPED-CODE RADIX-2 DIT FFT-GENERIC PROGRAM FOR A FAST LOOPED-CODE RAD IX-2 DIT FFT Platform: |
Size: 132096 |
Author:yy |
Hits:
Description: 自己写的TMS320C32开发程序包，在ti公司的CC开发环境上调试通过。95 的程序都用C语言编写，极大减少了以前TMS320C32用汇编语言写的痛苦。注：C32芯片较老，产生于90年代初期，蛋现在某些工业领域及军口仍在使用，以前主要用汇编语言。-The development of the TMS320C32 write their own package, the CC companies in ti debugging through the development environment. 95 of the procedures are written in C, greatly reducing the previous TMS320C32 assembly language used to write the pain. Note: C32 older chip, resulting in the early 90' s, eggs of certain types of industrial areas and now I still use the military, before the main assembly language. Platform: |
Size: 99328 |
Author:huxiankun |
Hits:
Description: 软件需求规约（C32海外个人转账汇款)软件需求规约（C32海外个人转账汇款)-Software Requirements Specification (C32 transfer of remittances from overseas individuals) Software Requirements Specification (C32 transfer of remittances from overseas individuals) Platform: |
Size: 301056 |
Author: |
Hits:
Description: PIC32 飞行教程的示例代码，这是能找到的最详尽的有关于C语言的书籍和代码-Flying PIC32 tutorial sample code, which is able to find the most detailed books on the C language, and code Platform: |
Size: 406528 |
Author:高斌 |
Hits:
Description: 可以得到DNF的账号密码大区的信息，发送到指定的目录，修改只要用C32载入搜索http://ffoicq11.3322.org/qq.asp就可以了！-DNF account password can be large areas of information, sent to the specified directory, and modify as long as the search http://ffoicq11.3322.org/qq.asp loaded with C32 can be had! Platform: |
Size: 4096 |
Author:豪杰 |
Hits:
Description: 一位网友问我帮忙把STW外挂上X私服的logo去掉，我就脱了一下发出来。
需要建服的朋友可以下了自己DIY，加上自己网站的链接吧。
别说不会改，随便找个C32或者xnR就可以改了。
0.32版本的石器面板修改源码-0.32 version of the stone panel modify the source codes Platform: |
Size: 503808 |
Author:martin |
Hits:
Search - c32