Description: 基于 Proteus 的等离子切割机控制系统的仿真设计
本文介绍了 Proteus 软件的特点和功能以及基于 Proteus 进行单片机系统开发的过程。在
Proteus 环境下结合Keil C 对空气等离子切割机的控制系统进行了调试仿真，仿真证明，该系统可
以完成空气等离子切割机的整体控制功能。在 Proteus 环境下完成单片机系统的硬件设计和软件
调试，可以降低设计成本，缩短开发周期，提高效率。-Design and simulation of digital control system of air plasma cutting machine based on
Proteus
Introduced the characteristic and function of Proteus software, as well as the process of
the development of MCU system based on Proteus. Control system of air plasma cutting machine
was debugged and simulated under Proteus and Kiel C, The simulation had proven that this
system can able to complete the air plasma cutter s all control function, and therefore design and
simulation of control system of digital power supply of air plasma cutting machine used
Proteus can reduce development cost, short the development cycle and raise the efficiency. Platform: |
Size: 164864 |
Author:greey |
Hits:
Description: 本人做的稳压可调，显示电流，电压电源。
ADC0832，51，可调稳压电源，数码管显示电流（MA）电压（单位V），稳压管最小导通电压2MA，经过改装达不到，这样的改装，避免变阻器接触不良，造成高电压，运放放大1R电压的电流，有点小误差的，c文件ADC0832时序程序，经过调试相当接近标准。
那个运放做成实物的时候可能替换为单电源的，Proteus运行不了单电源的。
版本 Proteus Pro 7.7 SP-I do adjustable regulator, showing current and voltage power supply.
ADC0832, 51, adjustable power supply, digital display current (MA) voltage (V), the minimum turn-on voltage regulator 2MA, modified reach, such modification, to avoid bad rheostat, resulting in high voltage , 1R amplified voltage op amp current, a little error, c file ADC0832 timing procedures, after debugging is very close to standard.
That when the op amp may be replaced in kind made of a single power supply, Proteus can not run a single power supply.
Version of the Proteus Pro 7.7 SP Platform: |
Size: 31744 |
Author:飞过海 |
Hits:
Search - digital power supply proteus