Welcome![Sign In][Sign Up]
Location:
Search - flat fading modulation

Search list

[Other resourceostbc

Description: This program simulates the bit-error-rate (BER) performance of OSTBC with L=4 antennas over the frequency flat Rayleigh block fading channel The code is developed for real orthogonal design, code rate 1/2 modulation- 16 QAM with gray coding resulting in 2 bits/sec/Hz.
Platform: | Size: 1421 | Author: george | Hits:

[Post-TeleCom sofeware systemsostbc

Description: This program simulates the bit-error-rate (BER) performance of OSTBC with L=4 antennas over the frequency flat Rayleigh block fading channel The code is developed for real orthogonal design, code rate 1/2 modulation- 16 QAM with gray coding resulting in 2 bits/sec/Hz.-This program simulates the bit-error-rate (BER) performance of OSTBC with L = 4 antennas over the frequency flat Rayleigh block fading channel The code is developed for real orthogonal design, code rate 1/2 modulation-16 QAM with gray coding resulting in 2 bits/sec/Hz.
Platform: | Size: 1024 | Author: george | Hits:

[Communication-Mobilebpsk_fading

Description: 本源程序提供在平坦衰落信道下的BPSK调制解调的性能分析,并与理论曲线进行比较,得到了理想的效果-This source provides a flat fading channel the performance of the BPSK modulation and demodulation analysis and comparison with the theoretical curve obtained the desired results
Platform: | Size: 24576 | Author: paradise | Hits:

[matlabflatber

Description: BER performance in flat fading channels using bpsk modulation
Platform: | Size: 1024 | Author: raphel | Hits:

[SCMQPSK-Demodulation

Description: I simulated the SPACE TIME BLOCK CODED system based on Alamouti scheme, where the modulation is BPSK. Now I am trying to extend that to QPSK and higher modulations. Since for SISO channels, BER curve for BPSK and QPSK is equal in AWGN and flat fading channels.
Platform: | Size: 1024 | Author: den | Hits:

[Otherprecoding

Description: 程序对2发2收系统进行SVD算法的仿真。发送信号采用QPSK调制,信道为准静态瑞利平坦衰落信道,引入的噪声为均值为0的高斯白噪声,接收端采用最大似然检测算法,仿真其误比特率特性。-The SVD algorithm simulation program 2 admission system. Send signals using QPSK modulation, channel prevail static Rayleigh flat fading channels, the introduction of noise with mean 0 Gaussian white noise, the receiving end using the maximum likelihood detection algorithm, simulation of the bit error rate characteristics.
Platform: | Size: 1024 | Author: Polaris | Hits:

[OtherV-BLAST

Description: 程序对4发4收系统进行V-BLAST检测算法的仿真。发送信号采用QPSK调制,信道为准静态瑞利平坦衰落信道,引入的噪声为均值为0的高斯白噪声,接收端分别采用ZF、MMSE、ZF-OSIC、MMSE-OSIC四种检测算法,根据其误比特率比较性能。-V-BLAST detection algorithm simulation program 4 of 4 admission system. Send signals using QPSK modulation, channel quasi-static Rayleigh flat fading channel, the introduction of noise with mean zero Gaussian white noise receiving end, respectively, ZF, MMSE, ZF-OSIC, MMSE-OSIC four detection algorithm based on its The bit error rate of the comparative performance.
Platform: | Size: 3072 | Author: Polaris | Hits:

[Otherzfpro

Description: 程序对2发2收系统进行ZF算法的仿真。发送信号采用QPSK调制,信道为准静态瑞利平坦衰落信道,引入的噪声为均值为0的高斯白噪声,接收端采用最大似然检测算法,仿真其误比特率特性。-The ZF algorithm simulation program 2 admission system. Send signals using QPSK modulation, channel prevail static Rayleigh flat fading channels, the introduction of noise with mean 0 Gaussian white noise, the receiving end using the maximum likelihood detection algorithm, simulation of the bit error rate characteristics.
Platform: | Size: 1024 | Author: Polaris | Hits:

[matlabzf_4qam_22

Description: Performace analysis of Zero Forcing detection in (2,2) MIMO system using 4 QAM modulation in Rayleigh Flat Fading Channel
Platform: | Size: 1024 | Author: prabhat | Hits:

[matlabMUMIMO_ZF

Description: MIMO with ZF SIC and optimal ordering with assuming that the channel is a flat fading Rayleigh multipath channel and the modulation is BPSK.
Platform: | Size: 2048 | Author: ashim khadka | Hits:

[Otherofdm-rar

Description: OFDM(Orthogonal Frequency Division Multiplexing)即正交频分复用技术,实际上OFDM是MCM Multi-CarrierModulation,多载波调制的一种。其主要思想是:将信道分成若干正交子信道,将高速数据信号转换成并行的低速子数据流,调制到在每个子信道上进行传输。正交信号可以通过在接收端采用相关技术来分开,这样可以减少子信道之间的相互干扰 ICI 。每个子信道上的信号带宽小于信道的相关带宽,因此每个子信道上的可以看成平坦性衰落,从而可以消除码间串扰。而且由于每个子信道的带宽仅仅是原信道带宽的一小部分,信道均衡变得相对容易。-OFDM (Orthogonal Frequency Division Multiplexing) that is orthogonal frequency division multiplexing, OFDM is actually MCM Multi-CarrierModulation, a multi-carrier modulation. The main idea is: The channel is divided into a number of orthogonal sub-channel, high-speed data signal into parallel low-speed data streams, modulated to be transmitted on each subchannel. Quadrature signal at the receiving end can be separated using technologies, which can reduce the mutual interference between ICI subchannels. Signal is less than the bandwidth of each sub-channel coherence bandwidth of the channel, each subchannel can be regarded as flat fading, which can eliminate inter-symbol interference. And because the bandwidth of each subchannel is only a small part of the original channel bandwidth, channel equalization becomes relatively easy.
Platform: | Size: 321536 | Author: mixa | Hits:

[Data structsOFDM

Description: OFDM(Orthogonal Frequency Division Multiplexing)即正交频分复用技术,实际上OFDM是多载波调制的一种。其主要思想是:将信道分成若干正交子信道,将高速数据信号转换成并行的低速子数据流,调制到在每个子信道上进行传输。正交信号可以通过在接收端采用相关技术来分开,这样可以减少子信道之间的相互干扰 ICI 。每个子信道上的信号带宽小于信道的相关带宽,因此每个子信道上的可以看成平坦性衰落,从而可以消除符号间干扰。而且由于每个子信道的带宽仅仅是原信道带宽的一小部分,信道均衡变得相对容易。-OFDM (Orthogonal Frequency Division Multiplexing) that is orthogonal frequency division multiplexing, in fact, is a multi-carrier OFDM modulation. The main idea is: The channel is divided into a number of orthogonal sub-channel, high-speed data signal into parallel low-speed data streams, modulated to be transmitted on each subchannel. Quadrature signal at the receiving end can be separated using technologies, which can reduce the mutual interference between ICI subchannels. The signal bandwidth of each subchannel is less than the channel coherence bandwidth, and therefore can be regarded as flat fading on each sub-channel, thereby eliminating inter-symbol interference. And because the bandwidth of each subchannel is only a small part of the original channel bandwidth, channel equalization becomes relatively easy.
Platform: | Size: 2048 | Author: 刘金星 | Hits:

[3G developVBLAST

Description: In this simulation, a 2 x 2 MIMO system with BPSK modulation is used. Then, the algorithm of V-BLAST is implemented. After that, weight vector is produced using ZF, MMSE and ML detectors. Finally, the BER performance is plotted. A flat fading Rayleigh channel is assumed in this simulation.
Platform: | Size: 1024 | Author: hamed | Hits:

[matlabML-equalization-in-MIMO

Description: 在平稳瑞利多径信道下,用BPSK调制,用matlab 仿真由最大似然译码的性能。-It discuss a receiver structure called Maximum Likelihood (ML) decoding which gives us a better performance. We will assume that the channel is a flat fading Rayleigh multipath channel and the modulation is BPSK.
Platform: | Size: 2048 | Author: mingzhan | Hits:

[Game ProgramVBLAST

Description: In this simulation, a 2 x 2 MIMO system with BPSK modulation is used. Then, the algorithm of V-BLAST is implemented. After that, weight vector is produced using ZF, MMSE and ML detectors. Finally, the BER performance is plotted. A flat fading Rayleigh channel is assumed in this simulation.
Platform: | Size: 1024 | Author: hirknhe | Hits:

[3G developMPSK

Description: 实现Rayleigh平衰落信道下MPSK调制方式的误码率与误比特率对信噪比的仿真,M取2^m,其中m=1,2,...,6。仿真结果说明-Realize the Rayleigh flat fading channel bit error rate and bit error rate of MPSK modulation way under the simulation of signal to noise ratio, M ^ 2 M, with M = 1, 2,...6.The simulation results show that
Platform: | Size: 135168 | Author: 明月 | Hits:

[3G developMPAM

Description: 实现Rayleigh平衰落信道下MPAM调制方式的误码率与误比特率对信噪比的仿真,M取2^m,其中m=1,2,...,6。-Realize the Rayleigh flat fading channel bit error rate and bit error rate of MPAM modulation way under the simulation of signal to noise ratio, M ^ 2 M, with M = 1, 2,...6.
Platform: | Size: 138240 | Author: 明月 | Hits:

[3G developMFSK

Description: 实现Rayleigh平衰落信道下MFSK调制方式的误码率与误比特率对信噪比的仿真,M取2^m,其中m=1,2,...,6。-Realize the Rayleigh flat fading channel bit error rate and bit error rate of MFSK modulation way under the simulation of signal to noise ratio, M ^ 2 M, with M = 1, 2,...6.
Platform: | Size: 111616 | Author: 明月 | Hits:

[Special EffectsVBLAST

Description: In this simulation, a 2 x 2 MIMO system with BPSK modulation is used. Then, the algorithm of V-BLAST is implemented. After that, weight vector is produced using ZF, MMSE and ML detectors. Finally, the BER performance is plotted. A flat fading Rayleigh channel is assumed in this simulation.
Platform: | Size: 2048 | Author: m05435430huaic | Hits:

CodeBus www.codebus.net