Description: 十字路口交通信号灯控制器红黄绿三灯-Intersection traffic signal controller three red, yellow, and green lights Platform: |
Size: 8192 |
Author:xulun |
Hits:
Description: 主次干道分别亮59s和11s，红灯亮5s，主干道绿灯亮59s，后黄灯5s，同时次干道为红灯亮64s，主干道红灯亮16秒，同时次干道黄灯亮5s后绿灯亮11s。-Liang 59s, respectively, primary and secondary roads and 11s, the red light 5s, green trunk 59s, after the yellow 5s, at the same time at the red light road for 64s, the trunk road red light 16 seconds, while yellow light times 5s roads green after 11s. Platform: |
Size: 328704 |
Author:纪海健 |
Hits:
Description: 一个交通信号灯的实现，通过三个开关按钮实现不同的效果-Implementation of a traffic signal, through the three switch buttons to achieve different effects Platform: |
Size: 22528 |
Author:徐俊 |
Hits:
Description: 模拟交通信号灯，实现红黄绿灯的转换，非常有兴趣-Simulation of traffic lights, red, yellow, green light to achieve the conversion, very interested Platform: |
Size: 359424 |
Author:吴燕萍 |
Hits:
Description: 一、设计要求：交通信号灯模拟控制系统设计利用单片机的定时器定时，令十字路口的红绿灯交替点亮和熄灭，并且用LED数码管显示时间。用8051做输出口，控制十二个发光二极管燃灭，模拟交通灯管理。
二、设计内容：因为本课程设计是交通灯的控制设计，所以要了解实际交通灯的变化情况和规律。假设一个十字路口为东西南北走向。初始状态0为东西红灯，南北红灯。然后转状态1东西红灯，南北绿灯通车，。过一段时间转状态2南北绿灯灭，黄灯亮5秒，东西仍然红灯。再转状态3，东西绿灯通车，南北红灯。过一段时间转状态4，东西绿灯灭，黄灯亮5秒，南北仍然红灯。最后循环至状态1。
注意：.双色LED是由一个红色LED管芯和一个绿色LED管芯封装在一起，公用负端。当红色正端加高电平，绿色正端加低电平时，红灯亮；红色正端加低电平，绿色正端加高电平时，绿灯亮；两端都加高电平时，黄灯亮。-First, the design requirements: traffic light control system using single chip analog timer timing, so that the traffic light intersection
Alternating light and off, and LED digital display with time. To do with the 8051 output, control, burning off a dozen light-emitting diodes,
Simulated traffic light management.
Second, the design of content: This course is designed for the control of traffic light design, so to understand the actual changes in traffic lights and rules
Law. Assuming a crossroads for the north-south thing. What the initial state 0 is red, north and south light. Then things turn state 1
Red, green north-south traffic. Over time, turn off State 2 South Green, yellow light for 5 seconds, things are still red. Sub-state
State 3, the opening of something green, north and south light. Switch to state 4 over time, things off the green, yellow light for 5 seconds, north and south are still red
Lights. The last cycle to the state 1.
Note:. Two-color LED is a red LED Platform: |
Size: 84992 |
Author:庆庆 |
Hits:
Description: 把东西南北方向的红绿黄灯编号，然后在软件当中把灯亮时的状态设为“1”，灯灭时的状态设为“0”。第几个灯亮，就在第几位用二进制的1表示，所以以上提的状态都以这个思路来表示。之后把每一个状态的二进制转换为十六进制。因此用十六进制来表示每一个状态。-Things red, green and yellow Number of north-south direction, and then the software which lights when the state is set to " 1" , the status is set to " 0" when the lights were. A few lights, several binary, so the above-mentioned state this idea. After each state binary to hexadecimal. Hexadecimal to represent each state. Platform: |
Size: 1024 |
Author:刘红喜 |
Hits:
Description: 用单片机模拟的交通信号灯，红灯亮十秒后黄灯散三次，之后绿灯亮-MCU simulation of traffic lights, ten seconds after the red light yellow light scattered three times, after which the green light Platform: |
Size: 48128 |
Author:代冲 |
Hits:
Search - jiaotongxinhaodeng