Search - lpc2132 flash

Search - lpc2132 flash - List

[Other resource] PWM_VOICE DL : 0: 用LPC213X系列的PWM来产生语音。语音数据来源于PC机转换后得到的。最大可以是16位的。由于是PWM所以输出端口需要低通滤波才能够得到比较干净的声音。可以经过修改使用LPC2132以上的ARM的D/A来产生。 This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM. -LPC213X series used to generate the PWM voice. Voice data from the PC after the conversion. It is the largest of 16. Because there is PWM output ports need low-pass filter can be relatively clean voice. It has been modified over the use LPC2132 ARM D / A to produce. This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM.
Update : 2008-10-13 Size : 62.23kb Publisher : 徐勇
[Other resource] lpc2132-flash DL : 0: ARM7 LPC2132 FLASH驱动，C源代码。
Update : 2008-10-13 Size : 15.24kb Publisher : microstar2000
[Other resource] at45db021b DL : 0: 用LPC2132驱动SPI接口FLASH的c驱动程序，调试完全通过
Update : 2008-10-13 Size : 2.82kb Publisher : zhousisi
[ARM-PowerPC-ColdFire-MIPS] PWM_VOICE DL : 0: 用LPC213X系列的PWM来产生语音。语音数据来源于PC机转换后得到的。最大可以是16位的。由于是PWM所以输出端口需要低通滤波才能够得到比较干净的声音。可以经过修改使用LPC2132以上的ARM的D/A来产生。 This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM. -LPC213X series used to generate the PWM voice. Voice data from the PC after the conversion. It is the largest of 16. Because there is PWM output ports need low-pass filter can be relatively clean voice. It has been modified over the use LPC2132 ARM D/A to produce. This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM.
Update : 2025-02-17 Size : 62kb Publisher : 徐勇
[ARM-PowerPC-ColdFire-MIPS] lpc2132-flash DL : 0: ARM7 LPC2132 FLASH驱动，C源代码。-ARM7 LPC2132 FLASH drives, C source code.
Update : 2025-02-17 Size : 15kb Publisher : microstar2000
[SCM] at45db021b DL : 0: 用LPC2132驱动SPI接口FLASH的c驱动程序，调试完全通过-SPI interface with LPC2132 Driver FLASH
Update : 2025-02-17 Size : 3kb Publisher : zhousisi
[ARM-PowerPC-ColdFire-MIPS] LPC2132-USBMem DL : 0: LPC2132、2148下测试可用的USB+FLASH控制方案源代码。-LPC2132, 2148 to test the available USB+ FLASH control program source code.
Update : 2025-02-17 Size : 137kb Publisher : 蔡明
[ARM-PowerPC-ColdFire-MIPS] Example DL : 0: lpc2132读写SST39VF400的程序，通过串口发给单片机，由单片机写入FLASH，可以擦除和写入。ADS1.2编译-This is a program for lpc2132 to write SST39VF400.use ads1.2
Update : 2025-02-17 Size : 318kb Publisher : hexiaobin
[Com Port] UART DL : 0: ARM7 LPC2132 串口调试例程基于Board LPC21238实验板-// UART Sample Code // NXP Semiconductors // // MCB2130 Board LPC21238: runs in internal Flash // MCB2130 Ram: runs in internal RAM /////////////////////////////////////////////////////////////////////// The UART sample code initializes UART0 (COM0) and sends out a "HELLO". Afterwards it will simply echo anything it receives. Use a serial terminal utility with the following settings: Baud: 115200 Data: 8 Parity: None Handshake: None Note: UART0 has a ISP bootloading feature which might cause the LPC2138 to stay in the bootloader after a reset (Pin 7 and Pin 4 are used as RTS and DTR). This can be avoided by either disconnectiong the ISP and RST jumpers.
Update : 2025-02-17 Size : 22kb Publisher : 李迎春
[Other Embeded program] FLASH DL : 0: ARM7系列中的LPC2132对FLASH得设置以及一些小示例程序，都是开发板自带程序。-The LPC2132 ARM7 family of FLASH may set up as well as some small sample programs are to develop board comes procedures.
Update : 2025-02-17 Size : 74kb Publisher : 何鹏兵