Description: 完成了用低成本ARM处理器stm32,搭配12864液晶做出的示波器源码-Complete with low-cost ARM processors stm32, with 12864 to make liquid crystal oscilloscope source Platform: |
Size: 303104 |
Author:janal |
Hits:
Description: 基于STM32的虚拟示波器源码,其中包含STM32内部USB的驱动程序-STM32-based virtual oscilloscope source, which includes the internal USB driver STM32 Platform: |
Size: 4457472 |
Author:张磊 |
Hits:
Description: STM32-3.2寸TFT-ADS830-IDT7205示波器源程序.RAR
FAT32文件系统的存储机制及其在单片机上的实现-STM32-3.2-inch TFT-ADS830-IDT7205 oscilloscope source. RAR FAT32 file system on the storage mechanism and its implementation in SCM Platform: |
Size: 533504 |
Author:唐成卫 |
Hits:
Description: 用STM32开发的示波器,基于安抚来开发板-Oscilloscope with the STM32 development, to development board based on comfort Platform: |
Size: 3374080 |
Author:田凯 |
Hits:
Description: STM32实现在模拟示波器上显示频谱特性,间隔1M的频标,在单片机内部输出同步锯齿波-STM32 realize in analogue oscilloscope display on the spectrum characteristics, at 1 M s frequency standard, the microcontroller internal output synchronous sawtooth wave
Platform: |
Size: 2338816 |
Author:阚炜107 |
Hits:
Description: 通过对 TIM1 定时器进行控制,使之各通道输出插入死区的互补PWM 输出,
各通道输出频率均为17.57KHz。
其中,通道1 输出的占空比为50 ,通道2 输出的占空比为25 ,通道3 输
出的占空比为12.5 。各通道互补输出为反相输出。
TIM1 定时器的通道1 到3 的输出分别对应PA.08、PA.09、PA.10 引脚,而通
道1 到3 的互补输出分别对应PB.13、PB.14 和PB.15 引脚,将这些引脚分别接
入示波器正接线,GND 引脚接示波器负接线,在示波器上看到了相应通道占空比
的PWM 输出。-By TIM1 timer control, so that the output of each channel into the dead zone of complementary PWM output, the output frequency of each channel are 17.57KHz. Among them, the channel 1 output 50 duty cycle, channel 2 output 25 duty cycle, channel 3 output duty cycle of 12.5 . The channel output is inverted complementary output. TIM1 timer channel 1 to 3 of the output corresponding to PA.08, PA.09, PA.10 pin, while channels 1 to 3 correspond to the complementary output PB.13, PB.14 and PB.15 pin, These pins are an oscilloscope is wiring, GND pin is connected to the negative terminal oscilloscope, the oscilloscope channel to see the corresponding PWM output duty cycle. Platform: |
Size: 434176 |
Author:jo |
Hits:
Description: 基于stm32 的示波器程序 实现信号峰峰值有效值和频率的测量-Stm32 based oscilloscope program to achieve peak RMS signal and frequency measurement Platform: |
Size: 1372160 |
Author:liyu |
Hits:
Description: 基于stm32的示波器程序的源文件,很全的功能单元的模块驱动。很好的资料。-Stm32 based oscilloscope program source file, is the whole functional unit module driver. Very good information. Platform: |
Size: 2195456 |
Author:yianliu |
Hits:
Description: 本代码是基于STM32的示波器的代码,能够实现在LCD上显示和触摸操作。-This code is the code based on the STM32 oscilloscope, can be achieved on the LCD display and touch operations. Platform: |
Size: 512000 |
Author:Chen Enhao |
Hits:
Description: 基于STM32示波器代码 说的比较好可以下载一下-Code based on STM32 oscilloscope is better to say what can be downloaded Platform: |
Size: 510976 |
Author:陈永亮 |
Hits:
Description: 基于STM32制作的示波器,用屏幕可以显示方波,正弦波等波形(Based on the STM32 produced by the oscilloscope, the screen can display square wave, sine wave and other waveforms) Platform: |
Size: 6216704 |
Author:DSP菜鸟
|
Hits:
Description: STM32实现的示波器,功能强大,实测可正常使用。(STM32 implementation of the oscilloscope, powerful, measured can be used normally.) Platform: |
Size: 29251584 |
Author:CC168
|
Hits:
Description: 外部采样,利用蓝牙把示波器采样后的信号传给手机,通过手机app显示波形(External sampling, the use of Bluetooth sampling oscilloscope signals to the mobile phone, through the mobile phone app display waveform) Platform: |
Size: 4880384 |
Author:孜然酱233
|
Hits:
Description: 手持示波器实现正弦波、方波、三角波的频率、脉宽、电压幅值的测量,通过蓝牙模块实现Android手机远程测量和数据存储。(The hand-held oscilloscope is used to measure the frequency, pulse width and voltage amplitude of the sine wave, square wave and triangle wave, and realize the remote measurement and data storage of Android phone through the bluetooth module.) Platform: |
Size: 4990976 |
Author:Hygge
|
Hits:
Description: 基于STM32的示波器的完整程序与硬件,可以显示波的各种参数,和真实示波器一样。(The complete program and hardware of Oscilloscope Based on STM32 can display various parameters of wave, just like real oscilloscope.) Platform: |
Size: 20366336 |
Author:小小熊1 |
Hits: