Description: 开关电源中pwm用matlab中的simulink表示的仿真模型，做的是闭环实验，还没有引进pid的仿真。有兴趣的看一下-pwm Switching Power Supply with Matlab Simulink said of the simulation model so is the closed-loop experiments, but also the introduction of pid simulation. Interested to see Platform: |
Size: 10240 |
Author:xiaohuang |
Hits:
Description: 一1000 MW水电站（机组M1）通过一条500 kV, 700 km的输电线路与负载中心连接。负载中心模型是5000 MW的阻抗负载，由遥远的1000 MW电站和当地的5000 MW (机组 M2)电站供电。系统已经初始化，因此线路传送950 MW，接近它的潮流阻抗负载（SIL = 977 MW）。这两台机相当于一台水轮机和管理(HTG)，励磁系统和电力系统稳定器(PSS)。这三个模块位于“涡轮和调速”子系统中。通过此例，在500 kV系统中制造故障，观察PSS对系统稳定性的影响。-a 1,000 MW hydropower station (crew M1) through a 500 kV, 700 km of transmission line and load center. Load center model is 5,000 MW of load impedance. from the distant 1000 MW power station and the local 5,000 MW (Unit M2) power supply. Is initialized, it transmits 950 MW. closer to its trend of load impedance (SIL = 977 MW). This machine is equivalent to a two hydraulic turbines and Management (HTG), excitation system and the power system stabilizer (PSS). This module is located at 3 "and turbine speed" subsystem. Through this cases, the 500 kV system manufacturing fault, PSS observation of the system stability. Platform: |
Size: 13312 |
Author:卢丹 |
Hits:
Description: ST7529液晶驱动 The ST7529 is a driver & controller LSI for 32 gray scale graphic dot-matrix liquid crystal display systems. It generates 255
Segment and 160 Common driver circuits. This chip is connected directly to a microprocessor, accepts Serial Peripheral
Interface (SPI), 8-bit/16-bit parallel or IIC display data and stores in an on-chip display data RAM. It performs display data
RAM read/write operation with no external operating clock to minimize power consumption. In addition, because it contains
power supply circuits necessary to drive liquid crystal, it is possible to make a display system with the fewest components.-ST7529 LCD driver The ST7529 is a driver Platform: |
Size: 2320384 |
Author:chengchen |
Hits:
Description: full wave rectifierDuring the period from 伪 to 蟺, the input voltage vs input current is are positive and the power flows from supply to the load. The converter is said to be operated at rectification mode .During the period from 蟺 to 蟺+伪 , the input voltage vs is negative and the input current is is positive and reverse power flows from load to the supply. The converter is said to be operated in inversion mode. Depending on the value of 伪, average output voltage can be either positive or negative and hence provides 2 quadrant operation.
-full wave rectifierDuring the period from 伪 to 蟺, the input voltage vs input current is are positive and the power flows from supply to the load. The converter is said to be operated at rectification mode .During the period from 蟺 to 蟺+伪 , the input voltage vs is negative and the input current is is positive and reverse power flows from load to the supply. The converter is said to be operated in inversion mode. Depending on the value of 伪, average output voltage can be either positive or negative and hence provides 2 quadrant operation.
Platform: |
Size: 7168 |
Author:anush |
Hits:
Description: 基于平均法的boost型DC/DC建模步骤，包括电压模和峰值电流模。增加了误差放大器放大倍数的确定，电源调整率，负载调整率和三种变换器的一阶等效模型-Based on the average of the boost-type DC/DC modeling steps, including the voltage mode and peak current mode. An increase of the error amplifier to determine the magnification, adjust the rate of power supply, load-adjusted factor and three first-order equivalent converter model Platform: |
Size: 1024 |
Author:蔡友 |
Hits:
Description: 基于平均法的buck_boost型DC/DC建模步骤，包括电压模和峰值电流模。增加了误差放大器放大倍数的确定，电源调整率，负载调整率和三种变换器的一阶等效模型-Based on the average law buck_boost type DC/DC modeling steps, including the voltage mode and peak current mode. An increase of the error amplifier to determine the magnification, adjust the rate of power supply, load-adjusted factor and three first-order equivalent converter model Platform: |
Size: 16384 |
Author:蔡友 |
Hits:
Description: 基于平均法的buck型DC/DC建模步骤，包括电压模和峰值电流模。增加了误差放大器放大倍数的确定，电源调整率，负载调整率和三种变换器的一阶等效模型-Based on the average of the buck-type DC/DC modeling steps, including the voltage mode and peak current mode. An increase of the error amplifier to determine the magnification, adjust the rate of power supply, load-adjusted factor and three first-order equivalent converter model Platform: |
Size: 16384 |
Author:蔡友 |
Hits:
Description: 本文件是一个SPWM逆变器的仿真源文件，可以在MATLAB7.1中直接运行。设计中PWM Generator采用外部调制信号，并在调制信号中注入了三次谐波，很好的抑制了输出谐波，同时提高了直流电源的利用率。-This document is a SPWM inverter simulation source file, you can directly run MATLAB7.1. Design of PWM Generator external modulation signal, and in the modulation signal into the third harmonic, the output of good harmonic suppression, while improving the utilization of the DC power supply. Platform: |
Size: 67584 |
Author:李勇 |
Hits:
Description: ：介绍了一种利用DSP控制的大容量蓄电池自动充电装置的设计。采用高频开关电源技术，给出了基于数
字信号处理器TMS320LF2407的充电装置控制系统的软、硬件设计。借助Matlab中的Simulink仿真工具，采用
在线模糊自整定技术对充电装置控制系统进行仿真，并将仿真结果应用于DSP控制器中，实现对Fuzzy-PID控
制的Kp、Ki、Kd参数的在线自整定，使充电方式能较好的模拟最佳充电曲线，达到理想效果。理论分析和试验都
表明，该充电装置能够有效地提高蓄电池的充电效率，加快充电速度。
-：An automatic charging equipment with high-capacity storage battery was designed through being controlled by
DSP.Using the HF SPS(High-Frequency Switching Power Supply)，the software/hardware implementation of a
TMS320LF2407 based controller system was introduced.With the tool-box of Simulink in Matlab，it adopts Fuzzy-PID
methods to simulate the controlling system of charging system.Then the result of simulation will be used in DSP controller
to realize self-control of the the parameters of Kp、Ki、Kd in PID controller so as to make the way of battery charging could
simulate the excellent curve and reach ideal results. Platform: |
Size: 314368 |
Author:mabeibei |
Hits:
Description: 这是具有功率因数校正的开关电源的MATLAB/SIMULINK仿真模型，希望对有用的人，有所帮助！-this is a simulink model of power supply with PFC, which is useful for those who study on this! Platform: |
Size: 7168 |
Author:邓长吉 |
Hits:
Description: 小波神经网络电力预测，是现在供电预测的一个很好的matlab程序，容易实现，操作简单，易学。-Wavelet neural network forecast electricity, is now forecasting a good power supply matlab program, easy to implement, simple operation, easy to learn. Platform: |
Size: 6144 |
Author:贾冠宇 |
Hits:
Description: 不间断电源（UPS）的开发资料。基本上属于程序仿真。-Uninterruptible power supply (UPS) the development of the information. Essentially a process simulation. Platform: |
Size: 320512 |
Author:李强 |
Hits:
Description: Matlab基本电路运算，只需要输入电路的基本信息如节点数，电源的电压。电流等即可得出电路所有的电量-Matlab basic circuit operation, and only need basic information such as the number of nodes of the input circuit, the power supply voltage. Current, etc. can draw all the power of the circuit Platform: |
Size: 13312 |
Author:王毅 |
Hits:
Description: Matlab与数据库链接有三种方法，本文只讲述其中以ODBC的方式进行链接。
本文件包含四部分，其中第三部分为我自己写的一些数据库函数操作的函数，第四部分为网上的一些资料。
-More than one power supply at the same time, the rectifier and inverter and bypass system are redundant configuration resistance
Load capacity with decentralized bypass system, there is no single point of failure, is the real full redundancy Yu Jiegou, reliability
The maximum expansion and online.
Its disadvantage is high cost.
Platform: |
Size: 168960 |
Author:陈刚 |
Hits:
Search - power supply matlab