Location:
Search - rp-pppoe-3
Search list
Description:
Platform: |
Size: 228687 |
Author: |
Hits:
Description: PPPoE在Linux上的源代码-PPPoE on Linux source code
Platform: |
Size: 229000 |
Author: 李广 |
Hits:
Description: 在linux上实现拨号上网的功能，可以在平台arm上运行，移植性比较好。-on dial-up capabilities in the platform arm run transplanted better.
Platform: |
Size: 211879 |
Author: 王凯 |
Hits:
Description: linux下的拨号程序rp-pppoe.3.7-the dial-up procedure rp - pppoe.3.7
Platform: |
Size: 212326 |
Author: 暮色 |
Hits:
Description: 一个拨号程序还不错，但有些地方还需要改进-a dial-up procedure was pretty good, but some areas need improvement
Platform: |
Size: 212931 |
Author: 高训 |
Hits:
Description: rp-pppoe-3.8是在RED HAT系列Linux中所使用的拨号上网程序，采用PPPOE协议，实现了其协议栈。-rp - PPPOE - 3.8 in RED HAT series of Linux used by the dial-up Internet access procedures used PPPOE agreement, achieved its protocol stack.
Platform: |
Size: 235647 |
Author: 王峰 |
Hits:
Description: 0. Install the rp-pppoe-software
--------------------------------
You should have already done this by the time you re reading this. If not,
go back and read README.
1. Set up your Ethernet hardware
--------------------------------
First, make sure the Ethernet card you intend to use with the modem is
visible to the Linux kernel. Just how to do this is beyond the scope
of this document. However, if the card is the only Ethernet card in
the system, executing:
ifconfig eth0
should display something like this:
eth0 Link encap:Ethernet HWaddr 00:60:67:62:31:D4
plust some more lines. Your HWaddr will be different. As long as you see
the HWaddr line, your card should be working.
DO NOT assign an IP address to the Ethernet card. DO NOT configure the
card to come up at boot time.-0. Install the rp - PPPOE-software ------- ------------------------- You should have al ready done this by the time you re reading this. I f not, go back and read README. 1. Set up your Ethernet h ardware -------------------------------- F irst, make sure the Ethernet card you intend to use wit h the modem is visible to the Linux kernel. Just h ow to do this is beyond the scope of this document . However, if the card is the only Ethernet card in the Syste m, executing : ifconfig eth0 should display something like th is : eth0 Link encap : Ethernet HWaddr 00:60:67:62 : 31 : D4 plust some more lines. Your HWaddr will be dif peptide. As long as you see the HWaddr line, your card should be working. DO NOT assign an IP a http://www.hotmail.com/ to the Ethernet card. DO NOT configure th e card t
Platform: |
Size: 187791 |
Author: chensi |
Hits:
Description: pppoe拨号上网软件,实现linux,或嵌入式linux系统拨号上网.
Platform: |
Size: 536733 |
Author: liugang |
Hits:
Description: PPPoE在Linux上的源代码-PPPoE on Linux source code
Platform: |
Size: 228352 |
Author: 李广 |
Hits:
Description: 在linux上实现拨号上网的功能，可以在平台arm上运行，移植性比较好。-on dial-up capabilities in the platform arm run transplanted better.
Platform: |
Size: 211968 |
Author: 王凯 |
Hits:
Description: linux下的拨号程序rp-pppoe.3.7-the dial-up procedure rp- pppoe.3.7
Platform: |
Size: 211968 |
Author: 暮色 |
Hits:
Description: 一个拨号程序还不错，但有些地方还需要改进-a dial-up procedure was pretty good, but some areas need improvement
Platform: |
Size: 212992 |
Author: 高训 |
Hits:
Description: rp-pppoe-3.8是在RED HAT系列Linux中所使用的拨号上网程序，采用PPPOE协议，实现了其协议栈。-rp- PPPOE- 3.8 in RED HAT series of Linux used by the dial-up Internet access procedures used PPPOE agreement, achieved its protocol stack.
Platform: |
Size: 235520 |
Author: 王峰 |
Hits:
Description: 0. Install the rp-pppoe-software
--------------------------------
You should have already done this by the time you re reading this. If not,
go back and read README.
1. Set up your Ethernet hardware
--------------------------------
First, make sure the Ethernet card you intend to use with the modem is
visible to the Linux kernel. Just how to do this is beyond the scope
of this document. However, if the card is the only Ethernet card in
the system, executing:
ifconfig eth0
should display something like this:
eth0 Link encap:Ethernet HWaddr 00:60:67:62:31:D4
plust some more lines. Your HWaddr will be different. As long as you see
the HWaddr line, your card should be working.
DO NOT assign an IP address to the Ethernet card. DO NOT configure the
card to come up at boot time.-0. Install the rp- PPPOE-software-------------------------------- You should have al ready done this by the time you re reading this. I f not, go back and read README. 1. Set up your Ethernet h ardware-------------------------------- F irst, make sure the Ethernet card you intend to use wit h the modem is visible to the Linux kernel. Just h ow to do this is beyond the scope of this document . However, if the card is the only Ethernet card in the Syste m, executing : ifconfig eth0 should display something like th is : eth0 Link encap : Ethernet HWaddr 00:60:67:62 : 31 : D4 plust some more lines. Your HWaddr will be dif peptide. As long as you see the HWaddr line, your card should be working. DO NOT assign an IP a http://www.hotmail.com/ to the Ethernet card. DO NOT configure th e card t
Platform: |
Size: 187392 |
Author: chensi |
Hits:
Description: linux下的pppoe拨号程序源代码；
不错的开源代码-linux pppoe under the dial-up program source code. Good revenue code
Platform: |
Size: 189440 |
Author: 全不知 |
Hits:
Description: pppoe拨号上网软件,实现linux,或嵌入式linux系统拨号上网.-pppoe dial-up software, realize linux, embedded linux system or dial-up.
Platform: |
Size: 536576 |
Author: liugang |
Hits:
Description: 在linux上实现拨号上网的功能,可以在平台arm上运行,移植性比较好。最新的代码3.10版本-In linux to achieve dial-up function, you can run on arm platform, portability is better. The latest 3.10 version of the code
Platform: |
Size: 215040 |
Author: lee |
Hits:
Description: rp-pppoe for linux rp-pppoe for linux
Platform: |
Size: 238592 |
Author: weiny |
Hits:
Description: rp-pppoe_3.8-3.diff.gz ubuntu拨号程序源码debian包-rp-pppoe_3.8-3.diff.gz ubuntu dialer source debian package
Platform: |
Size: 10240 |
Author: roby |
Hits:
Description: 编译好的linux pppoe 拨号程序，保证能用，不会用另说。-compiled linux pppoe dailer program，promise can be used.
Platform: |
Size: 589824 |
Author: Kevin Ren |
Hits: