Location:
Search - rs232 monitor
Search list
Description: RS232 例程
可以监听，发送代码到制定的com 口-RS232 routines can monitor, send code to the development of the mouth com
Platform: |
Size: 184033 |
Author: 杨小智 |
Hits:
Description: RS232 例程
可以监听，发送代码到制定的com 口-RS232 routines can monitor, send code to the development of the mouth com
Platform: |
Size: 183296 |
Author: 杨小智 |
Hits:
Description: STK500_2下载器 M8 支持bootloader(带bootloader源码)
使用STK500_2 协议的ISP下载器，监控芯片 M8,数据通讯RS232.使用
ATMEL AVRStudio 4.xx STK500工具的进行软件升级。可通过ATMEL
AVRStudio 4.xx STK500工具升级固件程序。升级方法：通过设定电压
即按“write voltage”按钮进入bootloader程序。 -M8 browser support STK500_2 download bootloader (with bootloader source code) to use the ISP to download STK500_2 agreements, and monitor chip M8, data communication RS232. Use ATMEL AVRStudio 4.xx STK500 tool for software upgrades. By ATMEL AVRStudio 4.xx STK500 firmware upgrade tool. Upgrade methods: by setting the voltage that is, according to
Platform: |
Size: 77824 |
Author: yanbin |
Hits:
Description: 本文介绍了在Windows平台下串行通信的实现机制，讨论了根据不同的条件用Visual C++ 设计串行通信程序的三种方法，并结合实际，实现对温度数据的接收监控。 -This article describes the serial communication under Windows platform for the realization of a mechanism to discuss the different conditions used in accordance with Visual C++ The design of serial communication program in three ways, combined with the actual temperature data to realize the receiver monitor.
Platform: |
Size: 5120 |
Author: qcy |
Hits:
Description: 本设计通过Internet 来监测远程系统。远程电脑必须有固定的IP地址，通过RS232传输数据到电路板，在电路板上用固态继电器连接到电子产品，即可远程控制-This design through the Internet to monitor the remote system. Remote computer must have a fixed IP address, through the RS232 transmit data to the circuit boards, circuit boards used in solid-state relay connected to the electronic products, you can remote control
Platform: |
Size: 44032 |
Author: 石凡 |
Hits:
Description: VB与8051的联机监控使用bascom8051-VB and 8051 to monitor the use of online bascom8051
Platform: |
Size: 10240 |
Author: 張光源 |
Hits:
Description: at-command monitor rs232
Platform: |
Size: 1024 |
Author: Dima |
Hits:
Description: 智能温度感测器
（1）8051 的Port 1连接到LCD显示PORT 3的P3.3,P3.4和P3.5分别连接到LCD显示器的控制线，程序执行时可以让LCD显示器显示出时间和日期。
（2）温度感测组件AD590经由ADC0804将感测到的温度，转换成数字数据，然后经由PORT 0输入8051。
（3）8051的第10和第11只脚RXD和TXD分别连线到MAX232，然后连接到PC的COM埠。
（4）8051实验板每 小时就读入ADC0804转换的数字温度数据，然后记录在串行式EEPROM 93C66中。
（5）8051实验板可以经由RS232将记录在串行EEPROM 93C66中的数字温度数据传送PC端。*/-Intelligent Temperature Sensor (1) 8051 Port 1 to connect to the LCD display PORT 3 of the P3.3, P3.4 and P3.5 are connected to the LCD display control line, the program execution allows LCD monitor shows time and日期. (2) AD590 temperature sensing components measured by the ADC0804 to sense the temperature, converted into digital data, and then enter the 8051 via PORT 0. (3) 8051 10 and 11 feet respectively, RXD, and TXD connected to the MAX232, and then connect to the PC' s COM port. (4) 8051 Experimental plates per hour enrollment ADC0804 to convert digital temperature data, and then recorded in the serial EEPROM 93C66. (5) The 8051 experiment panels can be recorded through the RS232 serial EEPROM 93C66 in the digital temperature data transmission PC side.* /
Platform: |
Size: 52224 |
Author: tianxue |
Hits:
Description: 基于MSP430的油层界面监护系统。可以根据传感器检测到的乳化层数据，存储并显示在LCD上，并可通过串口发送到其他设备。-This monitor system is based on MSP430 chip. Store and display on LCD the data that the sensors sent.And it can send the data to other device via RS232
Platform: |
Size: 10240 |
Author: song |
Hits:
Description: 摄像机控制，通讯方式：RS232。
波特率： 1200 1位起始位， 8位数据位，1位停止位，无效验。
格式：FEH(起始码)，数字，命令，FFH（结束码）。
1．切换摄像机
格式：FEH，摄像机号，11H，FFH
例子：切换7号摄像机 FEH，07H，11H ，FFH
例子：切换15号摄像机 FEH，01H，05H，11H ，FFH
2．调系统同步切换
格式：FEH，系统同步切换号，12H，FFH
例子：调3号系统同步切换FEH，03H，12H，FFH
3. 切换监视器
格式：FEH，监视器号，13H ，FFH
例子：切换6号监视器 FEH，06H，13H，FFH-Camera control, means of communication: RS232. Baud rate: 1200 1 start bit, 8 data bits, 1 stop bit, invalid inspection. Format: FEH (start code), numbers, commands, FFH (end code). 1. Switch Camera Format: FEH, camera number, 11H, FFH example: switch 7 cameras FEH, 07H, 11H, FFH example: Switch 15 cameras FEH, 01H, 05H, 11H, FFH 2. Transfer system synchronization switching formats: FEH, synchronization switching numbers, 12H, FFH example: tune 3 synchronization switch FEH, 03H, 12H, FFH 3. Switch Monitor Format: FEH, monitor number, 13H, FFH example: Switch 6 monitors FEH, 06H, 13H, FFH
Platform: |
Size: 88064 |
Author: 汪林 |
Hits:
Description: 程序描述：网络远端温度感测器，这个范例中使用到
（1）8051 的Port 1连接到LCD显示器，PORT 3的P3.3、P3.4和P3.5分别连接到LCD显示器的控制线，程序执行时可以让LCD显示器显示出时间和日期。
（2）温度感测组件AD590经由ADC0804将感测到的温度，转换成数位数据，然后经由PORT 0输入8051。
（3）igangcai 8051的第10和第11只脚RXD和TXD分别连线到MAX232，然后连接到PC的COM埠。
(4) 当PC端经由RS232传送S时，接下来PC送出的下 个byte就用来设定PORT 3的输出。
(5) 当PC端经由RS232传送T时，接下来PC连续送出五个bytes，这五个bytes是 "年月日时分"，这是 PC 用来设定实验板的时间日期。
(6) 8051每 分钟就读入ADC0804转换的数字温度数据，然后通过RS232传送给PC端，再由PC端通过网络传送到远端的电脑。-Program description: network remote temperature sensor, this example uses the to (1) the 8051 port 1 to PORT 3 LCD monitor, the P3.3, P3.4 and P3.5 to LCD monitor control line, the program execution can make LCD monitor shows the time and date.
(2) temperature-sensing component AD590 via ADC0804 to sensing to temperature, converted to digital data, and then enter via PORT 0 8051.
(3) igangcai 8051 of clauses 10 and 11 foot TXD and RXD cabled to MAX232 respectively, and then connect to the PC s COM port.
(4) when transmitted via RS232 PC-s, the next PC out of the next byte is used to set the output PORT 3.
(5) when transmitted via RS232 PC-T, the next PC continuous sent out five bytes, the five bytes is the date-time " , this is the PC used to set the time and date the experimental Board.
(6) the 8051 per minute enrolment ADC0804 conversion of digital temperature data, and then transmitted to the PC via RS232, then by the PC-side passed over the network to the remote compute
Platform: |
Size: 45056 |
Author: bbs |
Hits:
Description: PIC - RS232 communication
Platform: |
Size: 404480 |
Author: xtrasys |
Hits:
Description: 使用VB.NET开发环境下的串口监听软件源码；可收发数据（带时间标记）-VB.NET development environment using the serial monitor software source code can send and receive data (with time stamp)
Platform: |
Size: 141312 |
Author: 陈城 |
Hits:
Description: RS232端口通信测试,可发送测试字符，监控接收到的字符-RS232 port communications test, the test character can be sent to monitor the received character
Platform: |
Size: 11264 |
Author: zouaixue |
Hits:
Description: 多功能数显表
本毕业设计的设计任务为一个多功能数显表。该数显表可以测量和显示气压、冲击频率和耗气量。并且具有RS232接口和时间显示。本毕业设计作品选用AK-4气压传感器和LWGY涡轮流量传感器，通过MCS-51单片机来控制操作，实现信号数据的采集、处理和发送。本毕业设计作品不仅可以将气压、冲击频率、耗气量及时间等数据显示在8个LED数码管上，还会通过RS232串口，将数据发送到PC上。并由PC上的配套程序，将信息数据显示在显示器上，这两部分所显示的数据是完全相同的。其中数字显示时间单位为秒，冲击频率的单位为BMP，耗气量的单位为立方米/小时。同时，系统会自动计时，开始运行3分钟之后，自动结束测量、显示，并保存信息数据。-Multi-function digital meter
The design of this graduation project is a multi-task digital form. The digital meter can measure and display pressure, impact frequency and air consumption. And has a RS232 interface and time display. The selection of graduate design works of AK-4 LWGY turbine flow sensors and pressure sensors, through the MCS-51 microcontroller to control the operation, and signal data collection, processing and transmission. This can not only graduated from design work to pressure, impact frequency, air consumption and time data is displayed in 8 LED digital tube, but also through the RS232 serial port, send data to the PC. By supporting programs on the PC, the information data displayed on the monitor, the data shown in these two parts are identical. One time, in seconds digital display, the impact frequency of the units BMP, air consumption of the units of cubic meters/hour. Meanwhile, the system will automatically time to start running after 3 minutes, automatically
Platform: |
Size: 794624 |
Author: 严二伟 |
Hits:
Description: 过滤rs232接口，可以监控串口中都有什么数据在传输，-monitor 232 interface,see what data flaws it tramslate.
Platform: |
Size: 98304 |
Author: si kui |
Hits:
Description: vb与plc串口通信程序 另加串口监视精灵
CommMonitor 侦测、拦截、逆向分析串口通信协议, 是侦测RS232/422/485串行端口
的专业工具软件，是软硬件工程师的最佳助手。CommMonitor 能侦听、拦截、记录、分析
串行通信协议，让您对应用程序操作串行端口的过程和细节，让您及时的模拟被侦听程序
或设备的数据、控制流，提高工作效率。-vb plc serial communication program plus a serial port monitor the wizard CommMonitor detect, intercept, reverse analysis of the serial communication protocol, RS232/422/485 serial port detection tool software, hardware and software engineers assistant. CommMonitor able to listen to, intercept, record, analyze serial communication protocol, allowing you to operation of the application process and details of the serial port, allowing you to timely analog listener program or device data and control flow, improve work efficiency.
Platform: |
Size: 538624 |
Author: 谢霆锋 |
Hits:
Description: 介绍几种硬件方式监控RS232通讯口方法。-A few hardware monitor RS232 communication port method.
Platform: |
Size: 7168 |
Author: 彬彬 |
Hits:
Description: RS232串口监视器，很好用的一个工具，分win98和net两个版本-Two versions of the RS232 serial port monitor, very good with a tool, sub win98 and net
Platform: |
Size: 594944 |
Author: 华军 |
Hits:
Description: data monitor for RS232 port running with following line parameters: 9600bps, 8 data bits, 1 stop bit, no parity, no flow control.
Received byte should be displayed on LED display in hexadecimal notation (choose any 2 consecutive digits on LED display, other digits should be disabled).
Platform: |
Size: 1015808 |
Author: vodo |
Hits: