Location:
Search - two mass model
Search list
Description: 我在法国收集的两篇关于网状模型的论文，和质点弹簧模型不太一样，对研究此方面的同学应该会有所帮助-I collected in France, two papers on the mesh model, and the mass-spring model are not the same students for research in this area should be helpful to
Platform: |
Size: 413696 |
Author: 唐思渊 |
Hits:
Description: 描述了离散事件网络仿真平台十, 在该平台的基础上对某型号卫星的内部数据流和星地数据链路进行了拓
扑建模, 并完成了数据流仿真。针对三种典型的工作模式, 分析了该卫星平台有效载荷巧总线通讯情况, 并针对两种不
同的传愉链路, 对大容量数据存储器容量进行了预算。仿真结果清楚地反映了星上存储器的存储容量与下传策略、
总线的通讯状况等数据流性能指标, 为系统任务分析和设计提供了可靠的依据, 同时也为卫星数据流仿真工作提出了一个
新的途径。-Describes the discrete event network simulation platform 10, in which the platform of a particular model on the basis of internal data flow and satellite data link satellite and the ground conducted a topological model, and completed the data flow simulation. Will focus on three typical operating modes, an analysis of the satellite platform, payload Qiao bus communication situation, and for two different mass of Discovery link on the large-capacity data storage capacity for the budget. The simulation results clearly reflect the onboard memory storage capacity and downlink strategy, the bus communication status of performance indicators such as data flow, task analysis and design of the system provides a reliable basis, but also for the satellite data flow simulation work of the a new way.
Platform: |
Size: 537600 |
Author: little |
Hits:
Description: model system of two ma-model system of two mass
Platform: |
Size: 70656 |
Author: Paweł |
Hits:
Description: 永磁同步风力发电机，考虑了轴系的两质块模型和风速变化-Permanent magnet synchronous wind generators, consider the two mass shaft model and wind speed change
Platform: |
Size: 17408 |
Author: mark |
Hits:
Description: 四轮转向两自由度模型，测质心侧偏角和横摆角速度-Four-wheel steering two degree of freedom model of center of mass of side-slip Angle and yawing angular velocity measurement
Platform: |
Size: 5120 |
Author: 胡国强 |
Hits:
Description: 两自由度比例前馈simulink模型，测四轮转向的质心侧偏角和横摆角速度-Two degrees of freedom ratio feedforward simulink model, measuring four-wheel steering center of mass of side-slip Angle and yawing angular velocity
Platform: |
Size: 6144 |
Author: 胡国强 |
Hits:
Description: 构建了一个包含风速模型、功率转换模型、传动链模型等三个部分的10MW变速直驱型风力发电机组的标么值的Matlab模型.传动链模型是基于二质量块——轴数学模型所构建的动态模型.通过标么值的转换及灵活的参数调整,该模型能较准确地模拟各种变速直驱型风力发电机组.仿真分析获取了最大功率跟踪特性曲线,并得到了风力发电机组的四个工作区.结果还能表明,电负荷电磁阻力矩能动态地调整电机转子转速,从而在低速风时能实现风能最大功率的追踪.同时,风涡轮的桨距角能控制高速风的利用率,使风涡轮机工作在额定功率下,有效地防止整个风力发电系统的机械和电负荷容量的过载冲击.作为原动力模型,该模型有助于进一步研究变速直驱风力发电系统的功率特性和并网发电控制技术.-Matlab model constructed a unit value 10MW direct drive variable speed wind turbine model three-part wind power conversion model, models, etc. contained in the transmission chain drive chain model is based on two mass- Axis constructed mathematical models the dynamic model by converting the unit value and flexible parameter adjustment, the model can accurately simulate the various speed direct-drive wind turbine simulation analysis to obtain the maximum power tracking characteristic curve and get the wind turbines four workspaces results also show that the electrical load electromagnetic drag torque motor rotor speed can be adjusted dynamically, resulting in low speed wind when the wind can achieve maximum power tracking. Meanwhile, wind turbine pitch angle can be controlled using high-speed wind rate, so that the wind turbines operate at rated power, effectively preventing overloads mechanical and electrical load capacity of the entire wind power generation system and as the driving f
Platform: |
Size: 932864 |
Author: 李雷 |
Hits:
Description: 相变凝结蒸发，源项vof-udf，定义连续性方程，能量方程，动量方程中的质量源项，能量源项和动量源项(fluent1.Boiling Tutorial: Heat and Mass Transfer with the Mixture Model
2.Tutorial: Horizontal Film Boiling
3.Tutorial: Modeling Uniform Fluidization in a Two Dimensional Fluidized Bed)
Platform: |
Size: 1024 |
Author: Alex lee |
Hits:
Description: BeamElementmm 为生成二维平面梁单元的一致质量矩阵
BeamElementStiffness 为生成二位梁单元刚度矩阵
BeamElementStiffness 为组装刚度矩阵和质量矩阵的程序
本程序可以进行有限元模型修正和结构损伤识别，优点是基本解决了测量信息有限的问题。(BeamElementmm is a consistent mass matrix for generating two-dimensional planar beam elements
BeamElementStiffness is used to generate the two-beam element stiffness matrix
BeamElementStiffness is a program for assembling stiffness matrices and mass matrices
This program can perform finite element model correction and structural damage identification. The advantage is that the problem of limited measurement information is basically solved.)
Platform: |
Size: 2048 |
Author: 马尔科夫贝叶斯 |
Hits: