Location:
Search - uart serial 51
Search list
Description: 很有参考价值的51单片机串口程序，正在搞串口的看一看-great reference value of 51 MCU procedures, is now pursuing a look at the serial port
Platform: |
Size: 7168 |
Author: 张子实 |
Hits:
Description: 5 ledblink -- 跑马灯程序
该项目在SDT2.51下编译调试。最简单的demo程序，运行后3个发光二极管轮流点亮。
6 timerint -- 定时器中断demo程序
该项目在SDT2.51下编译调试。将子目录timerint拷贝到c:\ 下。
该demo程序的主程序是while空循环，定时器中断服务程序每500ms将3个LED反相。
在57600超级终端里也可以看到中断发生时的信息。
7 uart -- 串口测试程序
该项目在SDT2.51下编译调试。运行后在57600的超级终端里等待PC键盘的输入，当按下 a 或 b 或 c 按键时，超级终端里将显示 You Pressed a ,You Pressed b ,You Pressed c .
-5 ledblink-- 5,250 procedures for the project under the Build SDT2.51 debugging. The most simple demo, the running after three LED lights rotation. 6 timerint-- timer interruption demo procedures of the project under the Build SDT2.51 debugging. Will subdirectory timerint copy of the c : \ under. The demo procedures while the main program is empty circle, the timer interruption of services in each of 500ms to RP-3 LED. The Super Terminal Lane 57600 can be seen at the time of the interruption information. 7 UART-- Serial testing procedures of the project under the Build SDT2.51 debugging. After running in the Super Terminal 57,600 awaiting the PC keyboard input, or when pressing a button b or c, Super Terminal Lane will be a show Pressed You, You Pressed b, You Pressed c.
Platform: |
Size: 249856 |
Author: 张淼林 |
Hits:
Description: Features
• Compatible with MCS-51® Products
• 8K Bytes of In-System Programmable (ISP) Flash Memory
– Endurance: 1000 Write/Erase Cycles
• 4.0V to 5.5V Operating Range
• Fully Static Operation: 0 Hz to 33 MHz
• Three-level Program Memory Lock
• 256 x 8-bit Internal RAM
• 32 Programmable I/O Lines
• Three 16-bit Timer/Counters
• Eight Interrupt Sources
• Full Duplex UART Serial Channel
• Low-power Idle and Power-down Modes
• Interrupt Recovery from Power-down Mode
• Watchdog Timer
• Dual Data Pointer
• Power-off Flag-Features
Platform: |
Size: 212992 |
Author: haojun |
Hits:
Description: 摘 要： 本文件是C8051单片机串口0、1测试程序，使用外部22.1184MHz晶振。
功能：Uart驱动程序，包括初始化、波特率设置，单字节发送接收、字符串发送接受等。
程序运行时向PC机发送字符串；接收到PC机的数据后，再将该数据发送回PC机。
按开发板上键盘，将该键值发送到PC机；本开发板提供的串口调试助手不支持中文显示。-Abstract : This document is C8051 MCU serial 0,1 testing procedures use of external 22.1184 MHz oscillator. Function : Uart driven procedures, including initialization, set baud rate, single-byte receive this, the string this acceptability. Procedures to the PC this string; PC to receive the data and then send that data back to PC. Development board on the keyboard, this pair sent to the PC; The development board for the serial debugging assistants do not support the Chinese show.
Platform: |
Size: 61440 |
Author: |
Hits:
Description: 实现51单片机的串口通信。可通过超级终端调试。-51 Singlechip realize serial communication. Debugging through HyperTerminal.
Platform: |
Size: 1024 |
Author: 林宏 |
Hits:
Description: 这是一个通用的51单片机和计算机串口通信的程序，经验证，是正确的。-This is a generic single-chip microcomputer 51 and computer serial communication procedures, experience certificates, is correct.
Platform: |
Size: 23552 |
Author: 谢勇 |
Hits:
Description: 典型的基于单片机51的UART串口通信程序-A typical 51-based single-chip UART serial communication program
Platform: |
Size: 23552 |
Author: xiaozi |
Hits:
Description: 使用C51编程，在KEIL的编译环境写实现的串口通讯的原代码-The use of C51 programming environment in the KEIL compiler realize the serial communication to write the original code
Platform: |
Size: 23552 |
Author: 甘 |
Hits:
Description: C51的IO模拟UART,非常好用,对于缺少串口的51单片机很好!-C51 s IO simulated UART, very easy to use, for lack of good single-chip serial 51!
Platform: |
Size: 2048 |
Author: xillinx |
Hits:
Description: 普通I/O口模拟串口的
51汇编原程序代码！-General I/O port simulation serial compilation of 51 original code!
Platform: |
Size: 1024 |
Author: 胡小辉 |
Hits:
Description: 51单片机中断方式串口收发数据，文件短小精湛-51 Single-chip serial port interrupt to send and receive data, documents superb short
Platform: |
Size: 1024 |
Author: michael |
Hits:
Description: 51单片机通过串口接收发送数组的c语言代码-51 Single-chip receiver to send an array through the serial port of the c language code
Platform: |
Size: 1024 |
Author: 胡牙鲆 |
Hits:
Description: 51_PC串口通信例子 proteus上实现
-Proteus 51_PC example of serial communication to achieve
Platform: |
Size: 38912 |
Author: 保密 |
Hits:
Description: 功能非常完善的51串口程序包，带数据包发送、接收校验。特别带有串口设置自动计算功能，使用方便。带详细使用说明。-Very well-51 serial package, with data packets to send, receive validation. Especially with a serial port settings automatically calculate the functional and easy to use. With detailed instructions.
Platform: |
Size: 3072 |
Author: 中银飞絮 |
Hits:
Description: 通用 51单片机 UART 0 初始化程序，适用于不同波特率，不同晶振-Generic 51 Single-chip UART 0 initialization procedure, applied to different baud rate, different crystal
Platform: |
Size: 1024 |
Author: 肖勋 |
Hits:
Description: 串口源码,收发数据,字符串 串口源码,收发数据,字符串-Serial source
Platform: |
Size: 9216 |
Author: 顾满洲 |
Hits:
Description: Proteus下UART串口程序，可利用Virtual Serial Ports Driver和串口调试工具进行测试.包含仿真电路和C程序。-Serial Port program which can be used in Proteus environment. The packet includes simulation circuit and C code.
Platform: |
Size: 46080 |
Author: Jinhai |
Hits:
Description: code for 51单片机 用于控制串口wifi模块的代码。很有用。
串口wifi，uartwifi模块-code for 51 MCU is used to control serial port wifi module code. Very useful.
Platform: |
Size: 11264 |
Author: Jacky |
Hits:
Description: UART（串口）用的51芯片是AT89S52，所以这些代码没问题可以在AT89S51、AT89S52、AT89C51、AT89C52下通用，不需要任何修改。-UART (serial port) with the 51 chip AT89S52, so the code is no problem in the AT89S51, AT89S52, AT89C51, AT89C52 under the general, without any changes.
Platform: |
Size: 1024 |
Author: lvyan |
Hits:
Description: 基于C语言开发的串口通信底层程序，对于初学者可以较好的理解串口通信开发
-C language development based on the underlying process of serial communications
Platform: |
Size: 81920 |
Author: yanbin |
Hits: