Description: This example shows how to write/read data to/from Backup data registers and
demonstrates the Tamper detection feature.
The associated software performs the following:
Configures the Tamper pin to be active on low level and enable Tamper interrupt.
Then all Backup data registers are programmed after that we check if the written data
are correct. If yes a led connected to PC.06 is turned on, otherwise a led connected
to PC.07 is turned on.
Once a low level is applied on PC.13 pin (ANTI_TAMP) the Backup data registers are
reset and the Tamper interrupt is generated. In the corresponding ISR we check if
the Backup data registers are cleared, if yes a led connected to PC.08 is turned
on otherwise a led connected to PC.09 is turned on.
In this example the system is clocked by the HSE(8MHz).
- [ProE] - Pro/E is to use a very wide range of thr
- [DMA] - This example provides a description of h
File list (Check if you may need any files):
Download