Description: Procedures where the directory: ex7_CAN
CAN bus communication because of debugging required external CAN device. So in the absence of external CAN device case, the sample procedures used in the self-test mode of CAN communication, namely the use of CANBOX4 Send CANBOX0 receiver. At the timer interrupt service routine in the implementation of sending interrupted CAN receive information.
Open the CC2000, the following steps:
1. Project-> Open, open the project file directory.
2. Project-> Rebuild ALL, the compiler links
3. File-> Load Program
4. Cursor to INT1 interrupt service routine CANIFR = 0xFFFF which the line.
5. Debug-> Toggle breakpoint (shortcut F9)
6. Debug-> Animate (shortcut F12)
GEL Files on left foot Right on point, Load GEL, select LF2407.gel, then the menu bar Gel-> LF2407-> CAN regs, you can see the CAN register variables are displayed in the Watch Window Island. CANBOX0 can be seen inside receive data 0x2211, 0x4433 and other d
- [LF2407] - ti2407 test board programming examples
- [self(12-1)] - ECAN self-test procedure, CAN module in
File list (Check if you may need any files):
ex7_CAN
.......\CC_BUILD.LOG
.......\cc_build_Custom.log
.......\Custom.lkf
.......\Custom.lkv
.......\Define.asm
.......\Define.obj
.......\DSP.CMD
.......\EX.MAK
.......\EX.MAP
.......\EX.OBJ
.......\EX.OUT
.......\EX.paf
.......\EX.pjt
.......\F2407REGS.H
.......\GLOBAL.C
.......\GLOBAL.OBJ
.......\LF2407.GEL
.......\LF2407A.H
.......\Main.c
.......\Main.obj