Description: There are two optional SD card communication protocols: SD mode and SPI mode. SD model is a standard SD card reading and writing, but in the selection of SD mode, often need to select the SD card controller interface with MCU, or SD card to join the additional control unit to support the SD card reader. However, AT89C52 microcontroller is not integrated SD card controller interface to SD mode if the selected communication would in effect increase the cost of hardware products. The time to read and write data in SD card is not very demanding circumstances, the use SPI mode can say is the best solution. SPI, mode because, by four lines on all the data can be exchanged, and Du Mu Qian Ji Cheng MCU market, there are many existing SPI interface circuit using SPI mode on the SD card reader can be greatly Jianhua Cao Zuo hardware design.
- [sq905cam.tar] - USB digital camera-source
- [WinCE5.0] - USB camera driver source FOR WINCE5.0
- [1_070515130443] - 51 single-chip wireless communication mo
- [SD] - SD card serial data reading and writing
- [SD_MMC] - sd card driver for micro sd cards to con
- [prog] - grqd_xp original transplant FATFS to the
- [sd] - Based on AT89C52 Microcontroller SD card
- [SD_Source_Program] - The establishment of the SD card FAT16 s
- [SDcard_MCS51] - There are two optional SD card communica
- [SDcard] - SCM and sd card data and MP3 communicati
File list (Check if you may need any files):
SDCARD_MCS51\sd.DSN
............\sd.LST
............\sd.OBJ
............\sd.PWI
............\sdcard
............\sdcard.hex
............\sdcard.lnp
............\sdcard.M51
............\sdcard.Opt
............\sdcard.plg
............\sdcard.Uv2
............\sdcard_Opt.Bak
............\sdcard_Uv2.Bak
............\sd管脚.txt
............\STARTUP.A51
............\STARTUP.LST
............\STARTUP.OBJ
............\Last Loaded sd.DBK
............\sd.__i
............\sd.c
SDCARD_MCS51
基于AT89C52单片机的SD卡的读写设计.htm
关于SD卡SPI工作频率 - SD卡模块 - 外围模块 - ICDev论坛 - 让开发简单一点!.htm
分享F169与NOKIA5110LCD以及4G的SDHC卡程序[强悍！].htm
Download