Description: This program controls a oven controller. The controller is Yokogawa UT100 series (UT150 or UT152 or UT 155).
It can control the set point, temperature raise rate, temperature decrease rate and more. The communication protocol is RS232.
It also plots the temperature set point and measured as a function of time.
The main file is Master_Oven_Diagnostic.vi . This file controls all the the other functions. I
To Search:
File list (Check if you may need any files):
Oven Program\Initialize_Oven.vi
............\Master_Oven_Diagnostic.vi
............\Master_Oven_Diagnostic_V2.vi
............\Master_Run_Oven.vi
............\Master_Run_Oven_woSetTemp.vi
............\OvenREADfunctions_only.vi
............\OvenWriteFunctions_only.vi
............\Oven_Close.vi
............\Oven_Global.vi
............\Oven_read_write.vi
............\Oven_read_write_report_oven_DNR.vi
............\Oven_read_write_report_oven_SP.vi
............\Oven_read_write_report_oven_temp.vi
............\Oven_read_write_report_oven_TMU.vi
............\Oven_read_write_report_oven_UPR.vi
............\Oven_read_write_set_oven_DNR.vi
............\Oven_read_write_set_oven_Temp.vi
............\Oven_read_write_set_oven_UPR.vi
............\Report_Oven_dnr.vi
............\Report_Oven_SP.vi
............\Report_Oven_Temp.vi
............\Report_Oven_TMU.vi
............\Report_Oven_UPR.vi
............\Set_Oven_dnr.vi
............\Set_Oven_Temp.vi
............\Set_Oven_UPR.vi
............\Test_Oven_Range.vi
Oven Program
Download