Description: 文章介绍了如何应用AVR单片机ATmega16做为核心，加上前端信号调理电路程控增益放大器，及波形显示LCD（GDM12864A），实现一个简易示波器的硬件和软件设计。-This paper describes how to use AVR Singlechip ATmega16 as the core, together with the front-end signal conditioning circuit programmable gain amplifier, and the waveform display LCD (GDM12864A), realize a simple oscilloscope hardware and software design. Platform: |
Size: 5120 |
Author: |
Hits:
Description: 文章介绍了如何应用AVR单片机ATmega16做为核心，加上前端信号调理电路程控增益放大器，及波形显示LCD（GDM12864A），实现一个简易示波器的硬件和软件设计。-This paper describes how to use AVR Singlechip ATmega16 as the core, together with the front-end signal conditioning circuit programmable gain amplifier, and the waveform display LCD (GDM12864A), realize a simple oscilloscope hardware and software design. Platform: |
Size: 5120 |
Author:余海斌 |
Hits:
Description: 自己写的用AVR 单片机产生正弦波.用示波器观察波形很好！-Write your own single-chip generated sine wave with AVR. Oscilloscope to observe waveforms with very good! Platform: |
Size: 11264 |
Author:wxb |
Hits:
Description: AVR单片机示波器，可以测量1HZ-27KHZ范围内的波形，但是输入摆幅不要超过±2.5V。内带编译代码等源文件，以及电路图-Single-chip AVR oscilloscope, can be measured 1HZ-27KHZ waveform within the scope of, but the input swing should not exceed ± 2.5V. With compiled code, such as within the source file, as well as the circuit diagram Platform: |
Size: 311296 |
Author:凉哥 |
Hits:
Description: AVR ATmega48 SPI最簡單測試碼！
透過spi_data[x]陣列寫入想要傳送的資料，
而x則是控制傳送第x筆數，而接腳輸出則在PortB的預設接腳內，只要修改spi_data就可以透過示波器看到SPI的信號了！-AVR ATmega48 SPI test the most simple code! Through spi_data [x] array you want to send the information to write, and x is the control of transmission of the first x amounts, while the output pin in the PORTB pin within the default, as long as the modified spi_data can see through the oscilloscope SPI the signal! Platform: |
Size: 11264 |
Author:Rick |
Hits:
Description: 采用AVR单片机制作的低成本LCD示波器资料和源码-AVR produced using low-cost single-chip LCD Oscilloscope information and source Platform: |
Size: 942080 |
Author:曹晶 |
Hits:
Description: my source code is developing program for access graphic lcd 128*64 pixel based ks0107 and ks0108 driver for oscilloscope application using Code Vision C AVR Platform: |
Size: 1024 |
Author:deddy |
Hits:
Description: avr m16简单虚拟示波器，简单实用
性能
1:AD速度最高100K/s.最低为4ms间隔采样，一次采400点。
2：触发方式：单次，自动触发。触发电平设置。
3：扫描时间，增益控制（下位机这个功能还没有做出来）。
4：上移下移，时间的缩放。
5：采集点数可变，由宏来实现。
6：计算峰峰值（没做出来），
7：自动设置（没做出来）。
8：运行/停止。
-virtual oscilloscope avr m16 simple, simple and practical performance of 1: AD The maximum speed of 100K/s. a minimum of 4ms sampling interval, a 400-point taken. 2: Trigger Mode: Single, automatic trigger. Trigger level setting. 3: scan time, gain control (under the bit machine this function has not yet done). 4: Move down, the time scaling. 5: Acquisition variable points, from macro to achieve. 6: Calculation of peak-to-peak (not done), 7: automatic settings (not done). 8: Run/Stop. Platform: |
Size: 631808 |
Author:chen |
Hits:
Description: TFT屏做的示波器完整源程序,AVR单片机.-TFT screen of the oscilloscope to do a full source code, AVR microcontroller. Platform: |
Size: 137216 |
Author:许广艳 |
Hits:
Description: 老外制作的数字示波器，包括原理图、PCB图、AVR程序,CPLD程序。希望对大家学习有所帮助.-Foreigners made digital oscilloscope, including schematics, AVR procedures, CPLD program. Want to help you learn Platform: |
Size: 2698240 |
Author:asdf |
Hits:
Description: 通过这个示波器的制作，你将会了解很多东西，比如如何运用运算放大器组合放大电路，高速AD转换器的应用、FIFO存储器的应用、AVR单片机SPI总线接口协议以及点阵液晶驱动。-Produced by the oscilloscope, you will understand many things, such as how to use the combination of amplifier op-amp, high-speed AD converter application, FIFO memory applications, AVR MCU SPI bus interface protocol and the dot matrix LCD driver. Platform: |
Size: 3500032 |
Author:z1234 |
Hits:
Description: 用avr做的数字示波器，四个按键可调控频率和幅值。-Avr to do with the digital oscilloscope, the four buttons can control the frequency and amplitude. Platform: |
Size: 496640 |
Author:hang |
Hits:
Description: avr示波器 基于AVR的示波器，开发环境ICCAVR-avr oscilloscope based on the AVR oscilloscope, development environment ICCAVR Platform: |
Size: 924672 |
Author:许航 |
Hits:
Search - AVR oscilloscope