Location:
Search - IR test
Search list
Description: gpio keypad driver for S3C2440A
&
Test Application
Platform: |
Size: 37640 |
Author: tom |
Hits:
Description: 此程序的功能是把红外遥控器的地址码(16位)和控制码及反码显示出来,每按一次遥控器都能显示这些数据(用8只数码管16进制显示).
Platform: |
Size: 2179 |
Author: qiaoxushan |
Hits:
Description: 在WINCE4。2中如果打开红外端口。使用EVC4编译。在HP3210PDA中测试通过。-In WINCE4. 2 in the infrared port if you open. The use of EVC4 compiler. In HP3210PDA in the test.
Platform: |
Size: 153600 |
Author: |
Hits:
Description: 红外遥控接收
ORG 0000H
LJMP START 转入主程序
ORG 0010H
START:
MAIN:
JNB P2.2,IR
LJMP MAIN
以下为进入P3.2脚外部中断子程序，也就是解码程序
IR:
MOV R6,#9
SB:
ACALL DELAY882 调用882微秒延时子程序
JB P2.2,EXIT 延时882微秒后判断P3.2脚是否出现高电平如果有就退出解码程序
DJNZ R6, SB 重复10次，目的是检测在8820微秒内如果出现高电-infrared remote control receiver ORG 0000H LJMP START into main program ORG 0010H START : MAIN : JNB P2.2, IR LJMP MAIN below to enter P3.2 foot external interrupt subroutine, which is decoding procedures IR : MOV R6, SB# 9 : Calling ACALL DELAY882 882 microsecond delay subroutine JB P2.2, EXIT 882 microsecond delay after the judgment whether there P3.2 feet to I quit if decoding procedures DJNZ R6, SB repeated 10 times, the purpose is to test if within 8,820 microsecond high
Platform: |
Size: 4096 |
Author: 风 |
Hits:
Description: gpio keypad driver for S3C2440A
&
Test Application
Platform: |
Size: 37888 |
Author: |
Hits:
Description: SAA3010红外解码测试，用C语言编写，转载自www.yeyudo.cn-SAA3010 IR decoder test, using C language, reproduced from www.yeyudo.cn
Platform: |
Size: 3072 |
Author: youje |
Hits:
Description: 此程序的功能是把红外遥控器的地址码(16位)和控制码及反码显示出来,每按一次遥控器都能显示这些数据(用8只数码管16进制显示).-The function of this program is to address the infrared remote control code (16) and the control code and anti-code displayed every time the remote control can display these data (8 by 16-band digital tube display).
Platform: |
Size: 2048 |
Author: |
Hits:
Description: 红外线遥控器按键检测程序.
通过检测两次下降沿之间的时间差判断接受到的数据位.
已经通过了测试,能够正确区分出32bit数据的遥控器按键键值.
具有数据重发功能,但是数据的重发有点频繁.
使用晶震频率为11.0592MHz,所有定时值都是基于这个频率计算.
占用很少量的CPU时间,使用了外部中断0接受数据,定时器0进行计数,
定时器1作为串口的波特率发生器(Band = 9600).-Infra-red remote control button detection program. By detecting falling edge twice to determine the time difference between the received data bit. Has passed the test, could correctly distinguish 32bit data button remote control key. With data re-issued, but data a bit of re-issued frequent. Zhenyuan frequency of use of crystal 11.0592MHz, all timing values are calculated based on this frequency. occupied by small quantities of CPU time, use the external interrupt 0 to accept data, timer 0 to count, timer 1 as a string port baud rate generator (Band = 9600).
Platform: |
Size: 2048 |
Author: 高峰 |
Hits:
Description: FPGA EP2C5Q288C8 IR-LED 原码,测试OK 打开即用.-FPGA EP2C5Q288C8 IR-LED original code, test that is used to open OK.
Platform: |
Size: 658432 |
Author: kenychen |
Hits:
Description: linux 基于mips 架构cpu 的红外驱动，以及用户空间测试程序-linux on mips architecture cpu infrared driver, as well as user-space test procedures
Platform: |
Size: 1640448 |
Author: yinxw |
Hits:
Description: 内容：
*红外测试程序，用单片机通过发射管发射38K的调制频率码，由一体化接收并解码由发光管显示。
*正常情况下，由于反射和高灵敏度接收，LED4（P1.3)一直闪烁，可以用黑色纸片完全遮挡接收头使
*之不能接收到发射管的信号，这是LED4熄灭。说明功能性正常
-Content:* IR test program, launched with the microcontroller through the launch tube of the modulation frequency of 38K code, by the integration to receive and decode from the LED display.* Under normal circumstances, due to reflection and high-sensitivity receiver, LED4 (P1.3) has been flickering, you can completely block the black pieces of paper to make* that they are not receiving the first emission control signal is received, it is LED4 out. Note the normal functional
Platform: |
Size: 9216 |
Author: hahammc |
Hits:
Description: 一个简单的遥控器测试程序，用于测试遥控器的键值。-A simple remote control testing procedures used to test the remote control of the key.
Platform: |
Size: 6144 |
Author: ccy |
Hits:
Description: 希望对大家有用,51单片机例程IR测试-c51-We want to be useful, 51 MCU routine IR test-c51
Platform: |
Size: 11264 |
Author: 王一 |
Hits:
Description: 任天堂手把紅外線程式,可以追蹤到四個IR點用flash 畫面顯示-WIIMOTE IR test PROGRAM. trace 4 ir points on the flash window.
Platform: |
Size: 116736 |
Author: linser |
Hits:
Description: 红外测试程序，详细的注释，很不错的程序，c51源程序-IR test procedures, detailed notes
Platform: |
Size: 15360 |
Author: 陈征南 |
Hits:
Description: STM32红外解码，STM32用的是3.5的库，遥控器用小型的20按键的那种-IR decoding STM32, STM32 use the 3.5 library for remote control buttons of the kind of small, 20
Platform: |
Size: 743424 |
Author: 韦冬成 |
Hits:
Description: 红外线收发驱动，内含测试程序，对于不同的开发板，只需要更改相关的寄存器地址就可以移植。-Infrared transceiver driver, includes test procedures for different development board, just need to change the relevant register address can be transplanted.
Platform: |
Size: 39936 |
Author: sosozp |
Hits:
Description: 单片机 红外 遥控 编码 测试程序 初学者使用-Infrared remote control MCU code using the test program for beginners
Platform: |
Size: 2048 |
Author: radish |
Hits:
Description: 根据irda1.0通信协议，写的红外接收程序，测试可用。-According to irda1.0 communication protocol, writing of infrared receiving procedures, test can be used.
Platform: |
Size: 1024 |
Author: 欧星 |
Hits:
Description: AVR mega16单片机红外遥控模块的GCC驱动程序，实际测试可用。-AVR mega16 microcontroller infrared remote control module of the GCC driver, the actual test is available.
Platform: |
Size: 45056 |
Author: 高山举目 |
Hits: