Description: 乒乓球游戏机实验报告实验人： 大火虎设计课题： 用VHDL设计一个乒乓球游戏机,用开关来摸拟球手及裁判,用LED来模拟乒乓球,采用每局十一球赛制,比分由七段显示器显示. 设计思路： 采用按功能分块,将整个电路分成若干子程序,利用不同的子程序来实现记分，显示，键盘控制。设计过程： 1) 对4MHZ信号进行分频,得到所需的1HZ,及七段显示器所需的频率.存为CLOCKMAKE.VHD(注:仿真时所加的信号频率比这要高。)。 2) 设计一个子程序来描述裁判,左击球手,右击球手的动作对LED显示的影响,及失球后给出失球信号.这个程序是通过状态机来完成。存为ＰLAYANGLED.VHD 3) 利用上一子程序给出的矢球信号，来实现记分。-table tennis game Experimental Experimental Report : fire tiger design issues : VHDL design a table tennis game, and switch to simulation player and referee, used to simulate LED table tennis, Council adopted 11 per match system, the score by paragraph 107 of monitor displays. Design : Using functional block, the whole circuit is divided into several subroutines, the use of different subroutine to achieve points, display, keyboard control. Design process : a) right 4MHZ signal frequency, with the necessary 1HZ. Monitors and paragraph 107 of the required frequency. retention of CLOCKMAKE.VHD (Note : Simulation at the signal frequency increases would be higher than this.) . 2) design a subroutine to describe the referee, hitting the left hand, right-click the player moves right LED display, Platform: |
Size: 1120 |
Author:slw |
Hits:
Description: 本文为采用VHDL编写的程序及报告。步骤如下：1设计三位二进制计数器程序
二:设计一驱动循环显示7位数字
2编写LED控制程序如下：
3设计采用原理图方式如下:
-VHDL paper prepared for the introduction of procedures and reports. Steps are as follows : Design of a binary counter three two procedures : Design of a drive cycle show seven figures prepared two LED control procedures are as follows : three designs diagram as follows : Platform: |
Size: 296936 |
Author:梁兵 |
Hits:
Description: 本文为采用VHDL编写的程序及报告。步骤如下：1设计三位二进制计数器程序
二:设计一驱动循环显示7位数字
2编写LED控制程序如下：
3设计采用原理图方式如下:
-VHDL paper prepared for the introduction of procedures and reports. Steps are as follows : Design of a binary counter three two procedures : Design of a drive cycle show seven figures prepared two LED control procedures are as follows : three designs diagram as follows : Platform: |
Size: 296960 |
Author:梁兵 |
Hits:
Description: 一个模拟LED显示的控件，可以很方便地设计出漂亮的LED显示效果。-A simulated LED display control, it is easy to design a beautiful LED display. Platform: |
Size: 25600 |
Author:陈毅锋 |
Hits:
Description: 由于普通LED点阵显示屏动态显示通常采用硬件扫描驱动，这在一些需要特殊显示的场合显得不够灵活。文中提出了一种利用PC机和单片机的通讯来实现显示屏灵活的动态显示和远程监控的设计方法，同时该方法还可以将显示内容在PC机上进行预览。-Because of the general dynamic display LED dot matrix display scan driver commonly used hardware, which in some occasions require special display appears not flexible enough. This paper presents a PC-use and single-chip communication to achieve a flexible dynamic screen display and remote monitoring and control design methods, while the method can also display the contents in the PC-on preview. Platform: |
Size: 137216 |
Author:WHSAH |
Hits:
Description: 三色点阵控制，595串行输入显示，参加06年山东电子设计程序，供参考。-Tri-color dot-matrix control, serial input 595 indicates that participation in Shandong in 2006 electronic design procedures, for reference. Platform: |
Size: 62464 |
Author:肖继达 |
Hits:
Description: 光电池LED自动照明控制系统的设计与实现，这是一套毕业设计，里面包括电路原理图和程序原码包，还有相关的芯片资料，这是一套很大的系统
-Battery LED light automatic lighting control system design and implementation, which is a graduation project, which include the circuit schematic diagram and procedures for the original code package, and chip-related information, this is a great system Platform: |
Size: 714752 |
Author:aulyp |
Hits:
Description: 有74HC595和三极管联合控制的8*8点LED显示屏的现实驱动电路设计图-74HC595 and the transistor have joint control of the 8* 8 LED display drive circuit design reality Platform: |
Size: 555008 |
Author:小柴 |
Hits:
Description: 基于FPGA芯片控制全彩LED大屏幕图像显示系统系统设计随着数字技术的飞速发展，各种数字显示屏也随即涌现出来有LED、LCD、DLP等，各种数字大屏幕的控制系统多种多样，有用ARM+FPGA脱机控制系统，也有用PC+DVI接口解码芯片+FPGA芯片联机控制系统，在这里我们讲述一种不仅可以用于控制全彩LED大屏幕的显示，而且还可以作为发送端输出高清图像数据。采用的联机控制系统对全彩LED大屏幕进行控制。即PC+DVI接口解码芯片+FPGA芯片+输出接口模式的联机控制系统-FPGA-based full-color LED chips to control large-screen image display system, system design with the rapid development of digital technology, digital displays have also emerged immediately LED, LCD, DLP, etc., all kinds of large-screen digital control system diverse and useful ARM+ FPGA offline control system, it also uses PC+ DVI interface decoder chip+ FPGA chip-line control system, we have described here can not only be used to control a full-color large screen LED display, but also can serve as a send ended output high-definition image data. Online control system used on large-screen full-color LED control. PC+ DVI interface that decoder chip+ FPGA chip+ output interface of the online control system model Platform: |
Size: 833536 |
Author:打狗队 |
Hits:
Description: 简易LED 点阵汉字显示控制模块设计，包括LED汉字显示原理、电路原理图和程序设计，简单明了。-Simple LED dot-matrix character display control module design, including LED display Chinese characters principle, circuit schematic diagram and program design, simple and straightforward. Platform: |
Size: 318464 |
Author:郑一 |
Hits:
Description: CC1110和CC2510的LED灯远程控制程序，本设计建立在CC1110和TPS40211基础之上。-AN080-- LED Lighting with Remote Control using CC2510 and CC1110
This note describes a LED lighting design based on CC2510 and TPS40211. CC2510 is 2.4GHz System-on-Chip Low Power RF Transceiver while TPS40211 is a wide input range current mode boost controller, which provides voltage regulation and support 8 LED in series. CC2510 provides the wireless control function including 16 steps dimmer and various flashing modes. The CC1110 is the sub 1GHz version of the CC2510. Platform: |
Size: 1885184 |
Author:王亮 |
Hits:
Description: 数码管设计软件！可以自动生成数码管的编码！支持MCS-51，PIC，AVR，能生成共阳的或共阴的编码，可以是汇编格式和C语言格式！-Digital control design software! The digital control can automatically generate the code! Support for MCS-51, PIC, AVR, can generate a total of yin-yang, or a total coding, which can be compiled format and C language format! Platform: |
Size: 322560 |
Author:陈永 |
Hits:
Description: LED显示屏控制系统的分析与设计用于图文显示的LED显示屏，如果只显示一些图形、文字，而对图像、动画以及信息的实时显示要求不高，而且信息的内容和屏与屏切换相对比较稳定，不需要固定计算机实时服务，只需要在控制显示屏的单片机中加入-LED Display Control System Analysis and Design for graphic display of the LED screen, if only to show some graphics, text and image, animation and real-time information display ask for much, and the information content and the screen and the screen switch relatively stable, real-time service does not require a fixed computer, only the microcontroller in the control display by adding Platform: |
Size: 361472 |
Author:王刚 |
Hits:
Description: led 设计pcb 和控制源程序代码，里面有详细的设计资料。-led pcb design and control of source code, there are detailed design information. Platform: |
Size: 5489664 |
Author:海涛 |
Hits:
Description: 本系统采用AT89S51单片机来控制步进电机，不仅可以实现电机的正反转，还可以实现预置步数转动显示，以及LED正反转状态显示功能，电路设计可靠且易于实现，程序设计简单易懂。本系统主要由按键电路、单片机最小系统、AT89S51单片机、步进电机正反转状态显示电路、驱动电路以及步进电机等几部分组成。输出驱动电路采用一个六非门芯片74LS04和ULN2003A，来驱动步进电机的四相绕组。短路保护采用一个0.4A的保险管，防止因绕组短路而烧毁烧毁电机绕组线圈。-The system uses AT89S51 microcontroller to control the stepper motor, the motor can be achieved not only rotating, you can also turn the display to achieve the preset step, and the LED reversing the status display, circuit design, reliable and easy to implement, easy to program design to understand. The system consists of key circuit, the smallest single-chip system, AT89S51 microcontroller, stepper motor reversing the status display circuit, drive circuit and the stepper motor composed of several parts. Output driver circuit using a six-chip 74LS04 NAND gate and ULN2003A, to drive the four-phase stepper motor windings. Short circuit protection using a 0.4A fuse to prevent short circuit due to winding of the motor windings burned burned. Platform: |
Size: 92160 |
Author:丽丽 |
Hits:
Search - LED control design