Location:
Search - binary signal
Search list
Description: VxWorks下二值信号量应用程序源代码-VxWorks binary signal volume application source code
Platform: |
Size: 1834 |
Author: 周舟 |
Hits:
Description: VxWorks下二值信号量应用程序源代码-VxWorks binary signal volume application source code
Platform: |
Size: 2048 |
Author: 周舟 |
Hits:
Description: RS码是Reed-Solomon 码（理德－所罗门码）的简称，它是一类非二进制BCH码，在RS码中，输入信号分成k·m比特一组，每组包括k个符号，每个符号由m个比特组成-RS Reed-Solomon codes (Li-teh-Solomon code) in the short, it is a non-binary BCH, the RS code, the input signal into a bit k m groups, each including k symbols, each symbol by the m-bit components
Platform: |
Size: 93184 |
Author: 姚中华 |
Hits:
Description: 关于自适应滤波的一系列程序，包括二进制信道均衡，噪声对消，信号增强等，斑竹，该加精了吧？-adaptive filter on a series of procedures, including binary channel equalization and noise cancellation and signal enhancement, fed, the rate is honed?
Platform: |
Size: 36864 |
Author: gjd |
Hits:
Description: QPSK发送机，信号源为随机二进制序列，经串并变换后，转换成双极性信号发送-QPSK transmitter, the signal source for random binary sequence, series and transform, change the polarity signal sent in pairs
Platform: |
Size: 10240 |
Author: lk |
Hits:
Description: 采用Intel8255端口数据线与上图除IN0~IN7之外的引线连接。
程序步骤：
(1)根据模拟信号输入连线方式(跳线JP10与电位器１相连，若JP10上跳线摘掉，可将电位器２作模拟信号输入)，选择模拟通路，即选定addC,addB,accA组成三位二进制数据；
(2)同时使START和ALE有效，使ADC0809选择相应模拟信号并转换；
(3)等待EOC出现高电平；
(4)使OE为高电平，即允许从ADC0809读出数据
-Intel8255 port using data cable with the exception of the map outside the IN0 ~ IN7 pin connection. Procedural steps: (1) According to the analog signal input connection means (JP10 jumper connected with the potentiometer 1, if the jumper JP10 removed can be Potentiometers for analog signal input 2), select the analog channel, namely, the election set addC, addB, accA composed of three binary data (2) At the same time so that START and ALE effective, so select the appropriate ADC0809 analog signal and conversion (3) wait for EOC appears high (4) to enable the OE for the high electrical ping, which allows读出数据from ADC0809
Platform: |
Size: 1024 |
Author: 萧寒 |
Hits:
Description: 二进制通信系统的进行蒙特卡罗仿真程序，以正交信号为基础。当均值分别等于０，０.１，１.０，２．０时完成１００００个比特的仿真并求出误差概率。绘出理论误码率和蒙特拉罗仿真的差错率并进行比较这俩个结果，并绘出每个均值情况下判决器的１０００个接受信噪比抽样-Binary communication systems to carry out Monte-Carlo simulation procedures to orthogonal signal basis. When the mean, respectively, equivalent to 10,000 completed 0,0.1,1.0,2.0 bit error probability simulation and obtained. Mapping theory and蒙特拉罗BER simulation这俩error rate and compare results, and the mean circumstances of each mapped
Platform: |
Size: 2048 |
Author: 金玲 |
Hits:
Description: OFDM信号及其频谱的matlab仿真源代码，输入信号为随机产生的二进制序列并插入了保护间隔-OFDM signal and its spectrum simulation matlab source code, the input signal for randomly generated binary sequence and insert a guard interval
Platform: |
Size: 4096 |
Author: 优优 |
Hits:
Description: 系统设置一个两位BCD码倒计时计数器（计数脉冲1HZ），用于记录各状态持续时间；
因为各状态持续时间不一致，所以上述计数器应置入不同的预置数；
倒计时计数值输出至二个数码管显示；
程序共设置4个进程：
① 进程P1、P2和P3构成两个带有预置数功能的十进制计数器，其中P1和P3分别为个位和十位计数器，P2产生个位向十位的进位信号；
② P4是状态寄存器，控制状态的转换，并输出6盏交通灯的控制信号。-System to set up a two BCD code countdown counter (count pulse 1HZ), used to record the duration of each state because the duration of each state are inconsistent, so these counters should be placed in several different presets countdown of numerical output to two digital display procedures were set up four processes: ① process P1, P2 and P3 form two functions with a preset number of decimal counters, of which P1 and P3, respectively, for months, and 10-bit counters, P2 to generate a 10-bit The binary signal ② P4 is the status register, control the state of the conversion, and six output control signals of traffic lights.
Platform: |
Size: 1024 |
Author: kid |
Hits:
Description: 适用MATLAB仿真实现对模拟信号的采样量化编码程序（模拟信号采样经均匀量化后自然二进制编码），通信系统仿真必备-The application of MATLAB simulation of analog signal sampling quantization coding procedures (analog signal sampling by the uniform quantization after the natural binary code), communication system simulation must
Platform: |
Size: 1024 |
Author: 侯婷 |
Hits:
Description: 二进制数字调制信号ook,2psk,2fsk信号及其频谱-Binary digital modulation signal ook, 2psk, 2fsk signal and its spectrum
Platform: |
Size: 1024 |
Author: lijing |
Hits:
Description: 带有原二进制信号与BPSK调制后的信号图对比的BPSK仿真程序-With the original binary signal and BPSK modulation signal comparison of BPSK simulation program
Platform: |
Size: 1024 |
Author: hws |
Hits:
Description: 用数值方法实现该fsk信号的相关型解调器，完成一个二进制fsk通信系统的仿真-Numerical methods used in the implementation of the relevant type fsk signal demodulator, to complete a binary fsk communication system simulation
Platform: |
Size: 1024 |
Author: 欧米秋 |
Hits:
Description: amplitude pseudo random binary signal
Platform: |
Size: 1024 |
Author: dhanang |
Hits:
Description: 基于DES加密算法的二进制加密解密程序，内含主程序与加密函数、解密函数，有详细注释，并画出了二进制信号波形。-DES encryption algorithm based on binary encryption and decryption process, containing the main program and the encryption function, decryption function, detailed notes, and draw a binary signal waveforms.
Platform: |
Size: 9216 |
Author: 魁 |
Hits:
Description: 数字调制器的墓本构建模块是函数random-binary，它产生电平值为+1或一1的二进制波形，产生的比特数以及每比
特的采样数是该函数的参数。函数random-binary可以仿真多个数字调制器，例如，可用如下MATLAB语句仿真一个QPSK调制器:
下列MATLAB程序产生一个长10比特的QPSK信号,采样频率为每比特8个采样点:
-Digital modulator building blocks of the tomb is a function of the random-binary, it produces a value of+1 level or a 1 binary waveform, resulting in the number of bits and a sampling of each number of bits is the function parameters. Function of random-binary can simulate the multiple digital modulator, for example, can be used as MATLAB simulation of a QPSK modulator statement: The following MATLAB program to generate a long 10-bit QPSK signal, the sampling frequency for each 8-bit sampling points:
Platform: |
Size: 243712 |
Author: defang |
Hits:
Description: 借助于二叉树实现信号扩大器的放置，使得扩大器的数量最少-With binary signal amplifiers to achieve the placement, allowing a minimum number of amplifiers
Platform: |
Size: 577536 |
Author: 小宝 |
Hits:
Description: In this simulink model , baseband binary detection is simulated .A rectangular pulse shaped signal is given as input to the detector.The received signal is matched filtered and down-sampled .The effects of symbol timing offset can be seen by varying the phase of down-sampling operation.The binary signal transmitted is recovered
at the detector output.-In this simulink model , baseband binary detection is simulated .A rectangular pulse shaped signal is given as input to the detector.The received signal is matched filtered and down-sampled .The effects of symbol timing offset can be seen by varying the phase of down-sampling operation.The binary signal transmitted is recovered
at the detector output.
Platform: |
Size: 7168 |
Author: quail |
Hits:
Description: 用来将二进制的信号转化成BCD码形式的信号，用来在数码管上显示相应的数字。-To the binary signal into BCD code in the form of signals, used in the digital display the corresponding number.
Platform: |
Size: 252928 |
Author: da |
Hits:
Description: mt4 indicator for forex or binary
Platform: |
Size: 134144 |
Author: kradev |
Hits:
« 12
3
4
5
6
7
8
9
10
...
17
»