Welcome！[Sign In] ！[Sign Up]！
Front-page it | Collect it | [中国-简体中文]
FAQ Fav
Location:
Search - digit signal

Search list

[Other resource] C For Digit Signal Processing

Description: 基于c的数字信号编程-based digital signal Programming
Platform: | Size: 98333 | Author: 张秦豫 | Hits:

[Windows Develop] C-For-Digit-Signal-Processing

Description: c for digital signal processing
Platform: | Size: 92701 | Author: chenxuzhen | Hits:

[Other resource] VHDLANDSIGNALa

Description: it is a very good book for programble VHDL and digit signal book
Platform: | Size: 1101104 | Author: sugarxyc | Hits:

[Other resource] Generation of a Sine Wave Using a TMS320C54x Digit

Description: Generation of a Sine Wave Using a TMS320C54x Digital Signal Processor
Platform: | Size: 12550 | Author: 黄应东 | Hits:

[Other resource] Digit Signal Processing with C

Description: \"DIGITAL SIGNAL PROCESSING WITH C AND THE TMS32 0C30\"一书的附带程序，几乎包括所有数字信号处理的基本算法，很不错的源程序，可以加深对数字信号处理的理解-"DIGITAL SIGNAL PROCESSING WITH C AND THE TMS32 0C30," a book of incidental proceedings, including almost all of the digital signal processing algorithm, a very good source, it can deepen the digital signal processing to understand
Platform: | Size: 187379 | Author: 汪林 | Hits:

[VHDL-FPGA-Verilog] pinlvji 频率计VHDL编程

Description: 频率计VHDL编程。设计一个4位数字显示的十进制频率计，其测量范围为1MHz，测量值通过4个数码管显示以8421BCD码形式输出，可通过开关实现量程控制，量程分10kHz、100kHz、1MHz三档(最大读数分别为9.999kHz、99.99kHz、999.9kHz)； 当输入信号的频率大于相应量程时，有溢出显示。 -Cymometer VHDL programming. Design of a 4-digit decimal display frequency, the measurement range of 1MHz, the measured value through the four LED 8421BCD code shows the form of output can be controlled through the switch range, range at 10kHz, 100kHz, 1MHz Three (maximum reading were 9.999kHz, 99.99kHz, 999.9kHz) when the input signal is greater than the corresponding frequency range, it shows overflow.
Platform: | Size: 90168 | Author: testsb | Hits:

[source in ebook] C For Digit Signal Processing

Description: 基于c的数字信号编程-based digital signal Programming
Platform: | Size: 98304 | Author: 张秦豫 | Hits:

[DSP program] Generation of a Sine Wave Using a TMS320C54x Digit

Description: Generation of a Sine Wave Using a TMS320C54x Digital Signal Processor
Platform: | Size: 12288 | Author: 黄应东 | Hits:

[Algorithm] Digit Signal Processing with C

Description: "DIGITAL SIGNAL PROCESSING WITH C AND THE TMS32 0C30"一书的附带程序，几乎包括所有数字信号处理的基本算法，很不错的源程序，可以加深对数字信号处理的理解-"DIGITAL SIGNAL PROCESSING WITH C AND THE TMS32 0C30," a book of incidental proceedings, including almost all of the digital signal processing algorithm, a very good source, it can deepen the digital signal processing to understand
Platform: | Size: 187392 | Author: 汪林 | Hits:

[Windows Develop] C-For-Digit-Signal-Processing

Description: c for digital signal processing
Platform: | Size: 92160 | Author: chenxuzhen | Hits:

[VHDL-FPGA-Verilog] VHDLANDSIGNALa

Description: it is a very good book for programble VHDL and digit signal book
Platform: | Size: 1100800 | Author: sugarxyc | Hits:

[VHDL-FPGA-Verilog] tushuguan

Description: --功能描述 --1 刷卡后产生与本人身份唯一对应的串行二进制码元序列，作为模拟系统的输入信号（此处不妨设为8位学生学号）。 --2 经过串并转换，序列变成一个8位二进制数。 --3 遍历预先存储在rom中的学号信息，逐一和这个8位数相比较，如果有相匹配的信息，显示欢迎字样（此处用一个高电平表示），同时打开栅栏门（也用一个高电平表示）。 -- Functional Description- 1 credit card and identity generated only the corresponding element of the serial binary code sequence, as a simulation system of the input signal (in this case may be set to No. 8 students).- 2 after a string and conversion into a sequence of 8-bit binary number.- 3 pre-stored in the rom traversal of the Student ID information, one by one and compared to the 8-digit, if there is match the message that welcomes the word (here, said with a high), at the same time open the gate ( also expressed a high level).
Platform: | Size: 1024 | Author: leizi | Hits:

[Other Embeded program] PCmachine

Description: 单片机串行通信发射机采用串行工作方式，发射并显示两位数字信息，既显示00-99，使数据能够在不同地方传递。硬件部分主要分两大块，由AT89C51和多个按键组成的控制模块，包括时钟电路、控制信号电路，时钟采用6MHZ晶振和30pF的电容来组成内部时钟方式，控制信号用手动开关来控制，P1口来控制，P2、P3口产生信号并通过共阳极数码管来显示，软件采用汇编语言来编写，发射程序在通信协议一致的情况下完成数据的发射，同时显示程序对发射的数据加以显示。-Single-chip serial communication transmitters using a serial work, the launch and display the two-digit information, both show the 00-99, so that data can pass in different places. Hardware part of two main blocks, by the AT89C51 and composed of a number of key control module, including the clock circuit, control signal circuit, the clock used 6MHz crystal and 30pF capacitors to form the internal clock mode, the control signals used to manually switch to control, P1 mouth to control, P2, P3 I have a signal and, through a total of anode digital tube display, the software using assembly language to write, launch procedures consistent communication protocol in the case of complete data on the launch, at the same time show the process of launching the data to be displayed.
Platform: | Size: 270336 | Author: 王磊 | Hits:

[Other] ZLG7290

Description: zlg7290基于IIC接口键盘及LED驱动器 1 I C 串行接口 提供键盘中断信号 方便与处理器接口 2 可控扫描位数 可控任一数码管闪烁-zlg7290 based on the IIC Interface Keyboard and LED drive 1 IC serial interface to provide the keyboard interrupt signal processor interface to facilitate comparison with the 2-digit controllable controllable scan any digital tube flashing
Platform: | Size: 260096 | Author: yjj | Hits:

[VHDL-FPGA-Verilog] FPGArealiztionofdigitalsignalprocessing

Description: 数字信号处理FPGA实现 实用程序和文件,有sine.exe ---输入宽度。输出对应的正弦波表 mif文件 csd.exe --- 寻找整数和分数的标准有符号数字量（canonical signed digit ，CSD）表达式程序 fpinv.exe --- 倒数计算浮点数表的程序 dagen.exe ---分布式算法文件生成HDL" onclick="tagshow(event)" class="t_tag">VHDL代码的程序 cic.exe ---CIC滤波器计算参数的程序 -Digital Signal Processing FPGA realization of practical procedures and documents, there are sine.exe--- input width. Sine wave output of the corresponding csd.exe--- Table mif file to find the integer and fractional number of the volume of standard symbols (canonical signed digit, CSD) Expression Programming fpinv.exe--- countdown procedures for calculation of floating-point form dagen.exe--- documents distributed algorithm to generate HDL " onclick =" tagshow (event) " class =" t_tag " > VHDL program code cic.exe--- CIC filter process parameters
Platform: | Size: 260096 | Author: kevin | Hits:

[VHDL-FPGA-Verilog] part2

Description: Implement a 3-digit BCD counter. Display the contents of the counter on the 7-segment displays, HEX2− 0. Derive a control signal, from the 50-MHz clock signal provided on the DE2 board, to increment the contents of the counter at one-second intervals. Use the pushbutton switch KEY0 to reset the counter to 0.
Platform: | Size: 552960 | Author: echo | Hits:

[Other] Cory-L.-Clark---2005---Professional-LabVIEW-Digit

Description: Labview Digital signal Processing
Platform: | Size: 6062080 | Author: babaco | Hits:

[Industry research] DSP(II)

Description: 中科大数字信号处理（II）的课程教案，深入浅出地讲解了数字信号处理-DSP，digit signal process
Platform: | Size: 20880384 | Author: xws | Hits:

[matlab] digit-signal

Description: 基于matlab的两个例题，采样频率、幅频特性、相频特性、阻带衰减、滤波等等 -Matlab-based two examples, the sampling frequency, amplitude-frequency characteristics, phase-frequency characteristics, stop-band attenuation, filtering, etc.
Platform: | Size: 301056 | Author: 鲁可丹 | Hits:

[SCM] 显示屏

Description: 利用stm32f103zet6进行da转化，把模拟信号转化成数字信号，将数字信号在智能屏中显示出来(be in progress; be underway; carry on; carry out; carry through conversion; transform; translate; change; inversion analog signal; analog signals digit signal; digital signal; numerical signal; DS; digital signals number; figure; digit; amount signal; semaphore; gunintelligent; intelligence; brain power; noopsychedisplay; show; reveal; indication come out; emerge)
Platform: | Size: 4738048 | Author: 逍遥吃吃吃 | Hits:
« 12 3 »

CodeBus www.codebus.net