Welcome![Sign In][Sign Up]
Location:
Search - jiaotongdeng

Search list

[Otherjiaotongdeng.code

Description: 模拟交通控制系统礼包 实现交通控制 自动化 很有使用价值  系统很稳定-simulated traffic control system to achieve gifts traffic control automation system is very stable value
Platform: | Size: 1323008 | Author: 革根 | Hits:

[VHDL-FPGA-Verilogjiaotongdeng

Description: 一个用VHDL编写的在CPLD上实现模拟交通灯的程序源代码-a VHDL prepared by the CPLD on the analog signal source code
Platform: | Size: 394240 | Author: 田冰 | Hits:

[File Formatjiaotongdeng[1]

Description:
Platform: | Size: 83968 | Author: 蚊子 | Hits:

[assembly languagejiaotongdeng

Description: 一.设计要求 1.道路有A.B两路,一般情况A.B均有车时,两路各放行10S. 2.红绿灯转换必须经过4秒黄灯闪烁. 3.若两路均无车则保持原状. 4.若一路通行无阻10秒后,另一路无车,则继续放行此路,直到另一路有车. 5.若有紧急车辆通过两路均无红灯4秒,阻止一般车辆通过,让紧急车辆通过6.在数码管显示各路通行的标志和剩余时间. -1. Design requirements 1. Road has two-way AB, AB generally have cars, two of the released 10S. 2. Traffic light conversion must be 4 seconds blinking yellow light. 3. If the two had no car to maintain the status quo. 4. if unimpeded access all the way 10 seconds later, another car-free road, then continue to release this road until the road has another car. 5. if emergency vehicles through two red lights were not four seconds to stop the vehicles passed, so that emergency vehicles through 6. in the digital display various signs and the remainder of the passage of time.
Platform: | Size: 6144 | Author: 刘智峰 | Hits:

[Documentsjiaotongdeng

Description: 要求: 1、 设计一个十字路口的交通灯控制电路,要求甲车道和乙车道两条交叉道路上的车辆交替运行,每次通行时间都设为45秒。 2、 在绿灯转为红灯时,要求黄灯先亮5秒钟,才能变换运行车道; 3、 黄灯亮时,要求每秒闪亮一次。 甲、乙车道除了有红、黄、绿灯指示外,每一种灯亮的时间都用显示器进行显示(采用倒计时的方法 -Requirements: one, design a crossroads of traffic lights control circuit requires a two-lane carriageway and B cross-road vehicles to run alternately, each time access is set to 45 seconds. 2, in the green light to red light, require bright yellow first 5 seconds, in order to transform run-lane 3, when the yellow light, flashing a request per second. A, B lane except red, yellow, green direction, each time lights are used to show the display (using the countdown method
Platform: | Size: 80896 | Author: hongbingjun | Hits:

[assembly languagejiaotongdeng

Description: 交通灯8255交通灯汇编源程序 微机接口课程设计:8255控制交通灯-8255 traffic lights traffic lights source compilation courses Computer Interface Design: 8255 to control traffic lights
Platform: | Size: 1024 | Author: | Hits:

[transportation applicationsjiaotongdeng

Description: 微机原理课程设计报告及源代码 大家下了以后帮忙顶一下啊-Principles of curriculum design computer reports and source code after all under the roof to help you ah
Platform: | Size: 109568 | Author: 高德亮 | Hits:

[VHDL-FPGA-Verilogjiaotongdeng

Description: 这是用VHDL语言编译的交通灯程序,十分好用-This is compiled using VHDL language traffic lights procedure is very easy to use
Platform: | Size: 1024 | Author: 史乐 | Hits:

[DSP programjiaotongdeng

Description: TIDSP2407交通灯程序,希望对大家有用-Traffic lights TIDSP2407 procedures useful for everyone
Platform: | Size: 1024 | Author: wllaoda | Hits:

[Embeded-SCM Developjiaotongdeng

Description: 利用plc制作交通灯的毕业设计论文参考资料-Plc traffic lights making use of the graduate design thesis reference
Platform: | Size: 32768 | Author: wuxue | Hits:

[VHDL-FPGA-Verilogjiaotongdeng

Description: 交通灯VHDL设计,所有程序和顶层逻辑图都有,编译已通过,管脚分配可按实际分配-VHDL design of traffic lights, all the procedures and have a top-level logic diagram, the compiler has passed, according to the actual distribution of pin allocation
Platform: | Size: 234496 | Author: zhang | Hits:

[Software Engineeringjiaotongdeng

Description: 十字路口交通灯控制器设计报告,写得非常好,很有参考价值-Crossroads traffic lights controller design report, written very good, useful reference
Platform: | Size: 145408 | Author: 郭海东 | Hits:

[JSP/Javajiaotongdeng

Description: 一个模拟交通灯的JAVA源代码,可通过按钮控制灯的转换-A simulated traffic lights JAVA source code, can be controlled through the buttons light conversion
Platform: | Size: 2048 | Author: 林枫 | Hits:

[Compress-Decompress algrithmsjiaotongdeng

Description: 课程设计《交通灯控制的设计》,不知道会不会太简单了。-Curriculum design
Platform: | Size: 657408 | Author: 张云隆 | Hits:

[assembly languagejiaotongdeng

Description: 基于8255A交通灯模拟程序,附带一开关灯程序.-8255A-based simulation program traffic lights, with a light switch procedures.
Platform: | Size: 865280 | Author: fuzhichao | Hits:

[Software Engineeringjiaotongdeng

Description: 全面系统的介绍智能交通灯的设计,及在各条件下的运用。-Comprehensive and systematic introduction of intelligent traffic signal design, and in all conditions of use.
Platform: | Size: 1132544 | Author: 369 | Hits:

[assembly languagejiaotongdeng

Description: 设计一个简单的十字路口交通灯。交通灯分东西和南北两个方向,均通过数码管和指示灯指示当前的状态。设两个方向的流量相当,红灯时间45s,绿灯时间40s,黄灯时间5s。-Design a simple traffic lights at a crossroads. Traffic lights at East-West and North-South in both directions, both through the digital control and the current status indicator instructions. Established a considerable traffic in both directions, the alarm time 45s, green time of 40s, yellow time 5s.
Platform: | Size: 1024 | Author: linyao | Hits:

[VHDL-FPGA-Verilogjiaotongdeng

Description: 1). 用红、绿、黄三色发光二极管作信号灯。主干道为东西向,有红、绿、黄三个灯;支干道为南北向,也有红、绿、黄三个灯。红灯亮禁止通行;绿灯亮允许通行;黄灯亮则给行驶中的车辆有时间停靠到禁行线之外。 2).由于主干道车辆较多而支干道车辆较少,所以主干道绿灯时间较长。当主干道允许通行亮绿灯时,支干道亮红灯。而支干道允许通行亮绿灯时,主干道亮红灯,两者交替重复。主干道每次放行50秒,支干道每次放行30秒。 在每次由亮绿灯变成亮红灯的转换过程中间,需要亮5秒的黄灯作为过渡,以使行驶中的车辆有时间停靠到禁行线以外。 3). 能实现正常的、即时显示功能。用DE2上的四个七段数码管作为倒计时显示器。分别显示东西、南北方向的红灯、绿灯、黄灯时间。 4).能实现特殊状态的功能显示。设S为特殊状态的传感器信号,当S=1时,进入特殊状态。当S=0时,退出特殊状态。按S后,能实现特殊状态功能: (1)显示器闪烁; (2)计数器停止计数并保持在原来的数据; (3)东西、南北路口均显示红灯状态; (4)特殊状态结束后,能继续对时间进行计数。 5).能实现总体清零功能。按下R后,系统实现总清零,计数器由初始状态开始计数,对应状态的指示灯亮。 -1). With red, green, yellow three-color light-emitting diodes for lights. For the east-west trunk road, has red, green, yellow three lights support for the north-south trunk road, there are red, green, yellow three lights. Red light curfew green permit passage yellow light is to the moving vehicles have the time of call to cut outside the lane. 2). Because of the trunk road vehicles more vehicles and less trunk extension, so a longer green time of a main road. When the main road access permit a green light when the trunk road red sticks. Permit access roads and support a green light when the trunk road red, the two alternating repetition. Allowed 50 seconds for each trunk, branch trunk release each 30 seconds. At each green light into red by the conversion process between the need for five seconds of yellow light as a transitional measure to enable the moving vehicles have the time of call to ban outside lane. 3). To achieve a normal, real-time display. Using DE2 four seventh
Platform: | Size: 2048 | Author: 靓仔 | Hits:

[VHDL-FPGA-Verilogjiaotongdeng

Description: 交通灯控制系统VHDL源码,用VHDL语言、MAXPLUS2环境设计实现-VHDL core
Platform: | Size: 401408 | Author: DAVID | Hits:

[VHDL-FPGA-Verilogjiaotongdeng

Description: 交通灯1.设计一个十字路口的交通灯控制电路,要求 甲车道和乙车道两条交叉道路上的车辆交替 运行, 每次通行时间都设为25秒; 2.要求黄灯先亮5秒,才能变换运行车道; 3.黄灯亮时,要求每秒钟闪亮一次 。-jiaotongdeng
Platform: | Size: 442368 | Author: syh | Hits:
« 12 3 4 5 6 7 8 9 10 ... 29 »

CodeBus www.codebus.net