Location:
Search - matlab KP
Search list
Description: PID温度控制,实现温度升降,通过调节其中的Kp,Ki,Kd,可以改变响应速度,可以消除振荡,通过改变传递函数可以改变响应速度-PID temperature control realizes temperature s rise and drop.We can alter the rate of response and eliminate oscillating via adjusting Kp,Ki,Kd.
We can also alter the rate of response via changing the transfer function.
Platform: |
Size: 1024 |
Author: 星麒麟 |
Hits:
Description: 这是目前最经典的matlab实现的kpca代码,代码量已经很精简,但相信还有高手能做出最简化的代码-This is the most classic of KPCA realize matlab code, the code volume is already very lean, but I think there was a master to make the most simplified code
Platform: |
Size: 1024 |
Author: 二十八画生 |
Hits:
Description: 核主成分分析KPCA算法源码[matlab]-KPCA Kernel Principal Component Analysis algorithm source [matlab]
Platform: |
Size: 4096 |
Author: huli |
Hits:
Description: PID控制算法的MATLAB仿真其中参数,Kp,Ki,Kd分别为PID控制器的比例、微分和积分参数。-PID control algorithm of the MATLAB simulation in which the parameters, Kp, Ki, Kd are the proportion of PID controller, differential and integral parameters.
Platform: |
Size: 5120 |
Author: 王程坤 |
Hits:
Description: 仿真结果表明：KP=1，随着Ti增大，系统的超调量减小，系统响应速度略微变慢。-The simulation results show that: KP = 1, as Ti increases, the system reduces the overshoot, the system response speed slowed slightly.
Platform: |
Size: 3072 |
Author: lanyu |
Hits:
Description: 运行该程序后系统的阶跃响应曲线，如图8所示：
仿真结果表明，随着Kp增大，系统的超调量加大，系统响应速度加快。但随着KP的增大，稳定性能变差。
-Run this program after the system step response curve, as shown in Figure 8: Simulation results show that with increasing Kp, the system increased the overshoot, the system response speed. However, with increasing KP, stable performance variation.
Platform: |
Size: 11264 |
Author: lanyu |
Hits:
Description: 文件包含水轮机调节装置PID调节器+随动系统的结构框图,通过搭建模型图,可以方便的调节Kp,Ki,Kd,Td,Ty五个参数,清晰看到这五个参数对调节规律的影响-File contains the turbine regulating device PID regulator+ Servo system structure diagram, through the structure model, to facilitate the regulation of Kp, Ki, Kd, Td, Ty five parameters, clearly see the five parameters on the regulation of the law impact
Platform: |
Size: 3072 |
Author: kpg |
Hits:
Description: 利用PSO粒子群搜索算法,辨识PID参数:Kp,Ki,Kd.结果表明虽然该方法辨识精度不是很高,但是也有一定可信度.-Use english PSO Particle Swarm algorithm, identification of PID parameters: Kp, Ki, Kd. The results show that although the method is not very high recognition accuracy, but it also has a certain credibility.
Platform: |
Size: 3072 |
Author: kpg |
Hits:
Description: 核主成分分析法,用matlab实现,极为精彩.不可错过-Kernel Principal Component Analysis method, using matlab realize, is extremely exciting. Not to be missed
Platform: |
Size: 1024 |
Author: yyb_whu |
Hits:
Description: 为解决PCA不适合多指标综合分析中非线性主成分分析的问题 ,采用核主成分分析 (kpca)方法 ,对我国不同地区 16种腐乳的品质进行了综合评价。
-PCA is not suitable to address the many indicators of a comprehensive analysis of non-linear principal component analysis of the problem, using Kernel Principal Component Analysis (kpca) method, 16 kinds of different regions of our country the quality of fermented bean curd had a comprehensive evaluation.
Platform: |
Size: 1024 |
Author: fengyu |
Hits:
Description: pid 控制pwm输出例子,可通过调整kp ki kd调整-pid control pwm output example
Platform: |
Size: 226304 |
Author: 叶明 |
Hits:
Description: ：介绍了一种利用DSP控制的大容量蓄电池自动充电装置的设计。采用高频开关电源技术，给出了基于数
字信号处理器TMS320LF2407的充电装置控制系统的软、硬件设计。借助Matlab中的Simulink仿真工具，采用
在线模糊自整定技术对充电装置控制系统进行仿真，并将仿真结果应用于DSP控制器中，实现对Fuzzy-PID控
制的Kp、Ki、Kd参数的在线自整定，使充电方式能较好的模拟最佳充电曲线，达到理想效果。理论分析和试验都
表明，该充电装置能够有效地提高蓄电池的充电效率，加快充电速度。
-：An automatic charging equipment with high-capacity storage battery was designed through being controlled by
DSP.Using the HF SPS(High-Frequency Switching Power Supply)，the software/hardware implementation of a
TMS320LF2407 based controller system was introduced.With the tool-box of Simulink in Matlab，it adopts Fuzzy-PID
methods to simulate the controlling system of charging system.Then the result of simulation will be used in DSP controller
to realize self-control of the the parameters of Kp、Ki、Kd in PID controller so as to make the way of battery charging could
simulate the excellent curve and reach ideal results.
Platform: |
Size: 314368 |
Author: mabeibei |
Hits:
Description: 这是关于Ziegler-Nichols PID控制算法中 P/I/D参数的设计方法，很有参考价值。-This paper is about the method of getting the KP/KI/KD in the PID control system.
Platform: |
Size: 109568 |
Author: 黄河 |
Hits:
Description: 里面有三个二维模糊调节器分别实现PID控制器的参数Kp，ki，Kd，的调节。其控制原理：根据前面的偏差e和偏差变化ec将三个模糊控制器FC1,FC2,FC3分别进行模糊化，模糊逻辑推理，解模糊化。最后得到pid控制器参数调节量。-There are three two-dimensional fuzzy controller to achieve PID controller parameters were Kp, ki, Kd, of the regulation. The control principle: According to the previous error e and error change ec the three fuzzy controller FC1, FC2, FC3 were fuzzy, fuzzy logic, defuzzification. Finally, adjust the controller parameters by pid.
Platform: |
Size: 30720 |
Author: 杜增明 |
Hits:
Description: A Karplus-Strong music synthesis algorithm, you can set the frequencies of notes, the overlap, amplitude and sustain in the kp.m file.-A Karplus-Strong music synthesis algorithm, you can set the frequencies of notes, the overlap, amplitude and sustain in the kp.m file.
Platform: |
Size: 413696 |
Author: Vali |
Hits:
Description: 本文件对PID参数kp,ki,kd进行寻优，以ITAE作为指标函数。
PSO 文件中有详细的参数设置和寻优过程
GA寻优与PSO寻优作为对比出现
figure1展示了随着迭代次数的变化，适应度函数的收敛情况
figure2展示了kp,ki,kd的迭代情况
ht 文件是用来画图的
问题解决思路.pdf 简要介绍了粒子群算法寻优的过程(In this document, the PID parameters KP, Ki, KD are optimized, and ITAE is used as the index function.
PSO file has detailed parameter settings and optimization process
GA optimization and PSO optimization as a contrast appear
Figure1 shows the convergence of fitness function as the number of iterations changes
Figure2 shows the iterations of KP, Ki, and KD
The HT file is used for drawing
The problem solving idea.Pdf briefly introduces the process of particle swarm optimization)
Platform: |
Size: 254976 |
Author: 大燕
|
Hits:
Description: 模糊自整定PID控制器设计，基于MATLAB仿真实例，附上代码。(Fuzzy pid control example, based on MATLAB,it changs its Kp,Ki,Kd automatically.)
Platform: |
Size: 1158144 |
Author: limbo-
|
Hits:
Description: Given the following parameters,
Tp = 22 sec, Kp= 100, R = 2.5, Ts = 100 msec, T TG = 0.5 sec and Ks = KTG=1.
Construct the SIMULINK block diagram and obtain the frequency deviation response.
Platform: |
Size: 6144 |
Author: asgedom
|
Hits:
Description: Given the following parameters,
Tp = 22 sec, Kp= 100, R = 2.5, Ts = 100 msec, T TG = 0.5 sec and Ks = KTG=1.
Construct the SIMULINK block diagram and obtain the frequency deviation response.
Platform: |
Size: 6144 |
Author: asgedom
|
Hits:
Description: 本代码是个人编写的计算GaN量子阱内导带，价带（6*6哈密顿量）的光学特性，包含光吸收，光增益，量子效率，波函数，计算包含导带-价带，导带-导带，价带-价带内部的跃迁的所有计算，使计算量子体系的光吸收的理想代码。。。该Matlab代码的算法可以与nextnano软件包相媲美。。。。(kp method, optical absorption coefficient , optical gain, quantumn efficiency, transition rate, momentum matrix element wavefunction, 6*6 band hole Hamiltonian, electronic band ........)
Platform: |
Size: 8192 |
Author: 稻草人2号 |
Hits: