Description: 利用Matlab仿真软件，完成如图1所示的一个基本的数字通信系统。信号源产生0、1等概分布的随机信号，映射到16QAM的星座图上，同时一路信号已经被分成了实部和虚部，后边的处理建立在这两路信号的基础上。实部、虚部信号分别经过平方根升余弦滤波器，再加入高斯白噪声，然后通过匹配滤波器（平方根升余弦滤波器）。最后经过采样，判决，得到0、1信号，同原信号进行比较，给出16QAM数字系统的误码。-Using Matlab simulation software, as shown in Figure 1 to complete a basic digital communications systems. Signal source such as arise over the distribution of 0,1 random signal, is mapped to 16QAM constellation diagram, at the same time all the way the signal has been divided into real and imaginary parts, behind the deal with the establishment of these two signals in the basis. Real part, imaginary part of the signal, respectively, after a square root raised cosine filter, then add white Gaussian noise, and then through the matched filter (square root raised cosine filter). Finally, after sampling, the verdict has been 0,1 signal, to compare with the original signal is given 16QAM digital system error. Platform: |
Size: 491520 |
Author:叶双 |
Hits:
Description: This the PAPR simulator for SC-FDMA by using the Raised-cosine filter or Root raised-cosine filter under different rolloffFactor. -This is the PAPR simulator for SC-FDMA by using the Raised-cosine filter or Root raised-cosine filter under different rolloffFactor. Platform: |
Size: 2048 |
Author:clement |
Hits:
Description: 在matlab环境下实现通信系统中的BPSK，QPSK，16QAM，调制。成型滤波和匹配滤波都采用根升余弦函数。-In the matlab environment to achieve communication system BPSK, QPSK, 16QAM, modulation. Shaping filter and matched filter are used root raised cosine function.
Platform: |
Size: 4096 |
Author:Fengxiaodong |
Hits:
Description: Root raised cosine filter implementation in matlab, with graphs of impulse and frequency response. Platform: |
Size: 1024 |
Author:nelson831002 |
Hits:
Description: 采用MATLAB编程，产生一个16QAM基带信号，并进行实数倍插值计算。要求符号率为1 MSymbol/s，采用均方根升余弦滤波成形，滚降系数=0.5。产生{…1，0，1，1，…}的伪随机序列，经过映射、4倍成形滤波、FIR半带滤波、实数倍内插滤波，最后输出4.315倍时域/频域响应。给出信号序列经过各级滤波的时域、频域结果-Using MATLAB programming, resulting in a 16QAM baseband signal, and the real multiples of the interpolation calculation. The requirements of symbol rate 1 MSymbol/s, the root mean square raised cosine filter shape, roll-off factor = 0.5. Generate {1,0,1,1, ...} of the pseudo-random sequence, mapping, four times the shaping filter, FIR half-band filter, in fact, several times interpolation filter, the final output of 4.315 times the time domain/frequency domain response. Given the signal sequence through all levels of filtering the time domain, frequency domain results Platform: |
Size: 239616 |
Author: |
Hits:
Description: matlab代码，根升余弦滤波器对数字基带信号进行成型滤波，匹配滤波-Matlab code, the root raised cosine filter on the digital baseband signal shaping filter, matched filter Platform: |
Size: 2048 |
Author:jiaozhoubin |
Hits:
Description: 用matlab编写了一个，信源产生经过BPSK调制以及根号升余弦滤波器后再加上载波最后将波形图输出的程序-Using matlab prepared a source after BPSK modulation, as well as the square root raised cosine filter and then with the carrier waveform graph output of the program Platform: |
Size: 1024 |
Author:谷丰 |
Hits:
Description: BPSK与QPSK调制解调系统的Matlab仿真程序；
发送滤波器与接收滤波器均为根升余弦滚降滤波器；
信道噪声为加性高斯白噪声；
绘制BPSK与QPSK调制下的误码率与信噪比曲线图，并与理论曲线进行对比。
-BPSK and QPSK modulation and demodulation systems Matlab simulation program transmit and receive filters are root raised cosine filter roll-off filter channel noise is additive white Gaussian noise draw BER BPSK and QPSK modulation with a letter under noise ratio graph and compare with the theoretical curve. Platform: |
Size: 2048 |
Author:WatcherVC |
Hits:
Description: 仿真高斯白噪声信道下QPSK的Eb/N0与误比特率之间的关系。
要求：
任选一种工具进行仿真：SPW、Matlab、Simulink。
成型滤波器采用根升余弦滚降滤波器，滚降系数为0.5，过采样因子为4
要求仿真至1e-5误比特率 。
与理论值对比，绘出对比曲线-Simulation of Gauss white noise channel QPSK between Eb/N0 and bit error rate of the relationship.
Requirement.
Optionally, a tool for simulation: SPW, Matlab, Simulink.
Shaping filter using the root raised cosine filter, roll off factor of 0.5, over sampling factor of 4
Requirements of simulation to 1e-5 bit error rate.
Compared with the theoretical value, draw the contrast curve Platform: |
Size: 1024 |
Author:李硕 |
Hits:
Description: BPSK 与QPSK 调制解调系统的Matlab 仿真程序,发送滤波器与接收滤波器均为根升余弦滚降滤波器；信道噪声为加性高斯白噪声
绘制BPSK 与QPSK 调制下的误码率与信噪比曲线图，并与理论曲线进行对比-BPSK and QPSK modulation and demodulation system Matlab simulation program, send and receive filters are root raised cosine filter roll-off filter channel noise, BER and SNR draw BPSK and QPSK modulation under additive white Gaussian noise than the graph and compare with the theoretical curve Platform: |
Size: 2048 |
Author:asha |
Hits:
Description: 分别编写BPSK与QPSK调制解调系统的Matlab仿真程序，要求：发送滤波器与接收滤波器均为根升余弦滚降滤波器；信道噪声为加性高斯白噪声
绘制BPSK与QPSK调制下的误码率与信噪比曲线图，并与理论曲线比较对比-They were written BPSK and QPSK modulation and demodulation system Matlab simulation program requirements: a transmission filter and a reception filter are root raised cosine filter channel noise to draw error BPSK and QPSK modulation under additive white Gaussian noise rate and SNR graph, and compare and contrast the theoretical curve Platform: |
Size: 1024 |
Author:管天 |
Hits:
Description: 通过代码计算根升余弦滤波器系数，并通过与matlab本身自带生成函数做了比较-By code calculates root raised cosine filter coefficients, and through matlab comes with its own generating functions were compared Platform: |
Size: 1024 |
Author:wych |
Hits:
Search - matlab root raised cosine filter