Welcome![Sign In][Sign Up]
Location:
Search - pc through infrared

Search list

[Other resource无线键盘

Description: C51单片机通过红外通信实现PC键盘的无线通信 读取与显示具体细节请参考源程序将时钟线接入外部中断数据线接入普通I/O输入输出口-C51 microcontroller through infrared communications PC wireless keyboard and display read details please refer to the source clock line access external interrupt data lines access I / O input and output mouth
Platform: | Size: 205236 | Author: 无语 | Hits:

[Other resourceLPCforIR

Description: 基于标准MCS-51 单片机的红外接收软件.RC-5码.可通过RS232将接收到的码发送给PC机,实现红外遥控功能.短小精悍,采用中断编写.-standards-based MCS-51 infrared receiver software. RC-5 yards. Through RS232 will receive a code sent to the PC to achieve functional infrared remote control. Small and used interrupted preparation.
Platform: | Size: 3243 | Author: | Hits:

[SMSpc_send_sms

Description: 电脑串行口连接手机发送短信息的软件.手机通过数据线,红外接口和电脑相连接后,就可以通过这个程序操作手机.程序中的sms类也可以直接在其他工程里使用.-computer serial port connectivity phones send text messages software. Phone through data lines, infrared Interface and PC link, can this procedure through the phone. the procedures can also type handsets directly on the other used in the project.
Platform: | Size: 121181 | Author: fantasy | Hits:

[Other resourcePocketOBEX_demo

Description: 用MFC实现的在pocket PC之间通过红外技术通信的程序-used in pocket PC through infrared technology communications procedures
Platform: | Size: 36307 | Author: 邢云生 | Hits:

[Other resourceIR_Rx_Tx

Description: 本程序运行于C8051F330,功能为接收遥控器发出的红外信号,然后等待上位机通过I2C总线来读取。IR数据接收完毕后,不再采集新的IR数据,一直等待上位机将数据取走后才开始准备接收新的IR数据-this program running on the C8051F330, functional remote control device to receive the infrared signal, Then wait for the PC through the I2C bus to read. IR data receiving end, not the acquisition of new IR data have been waiting for the PC will be removed after data began preparing to receive the new IR data
Platform: | Size: 55453 | Author: 龙子 | Hits:

[SCM无线键盘

Description: C51单片机通过红外通信实现PC键盘的无线通信 读取与显示具体细节请参考源程序将时钟线接入外部中断数据线接入普通I/O输入输出口-C51 microcontroller through infrared communications PC wireless keyboard and display read details please refer to the source clock line access external interrupt data lines access I/O input and output mouth
Platform: | Size: 204800 | Author: 无语 | Hits:

[SCMLPCforIR

Description: 基于标准MCS-51 单片机的红外接收软件.RC-5码.可通过RS232将接收到的码发送给PC机,实现红外遥控功能.短小精悍,采用中断编写.-standards-based MCS-51 infrared receiver software. RC-5 yards. Through RS232 will receive a code sent to the PC to achieve functional infrared remote control. Small and used interrupted preparation.
Platform: | Size: 3072 | Author: | Hits:

[SMSpc_send_sms

Description: 电脑串行口连接手机发送短信息的软件.手机通过数据线,红外接口和电脑相连接后,就可以通过这个程序操作手机.程序中的sms类也可以直接在其他工程里使用.-computer serial port connectivity phones send text messages software. Phone through data lines, infrared Interface and PC link, can this procedure through the phone. the procedures can also type handsets directly on the other used in the project.
Platform: | Size: 120832 | Author: fantasy | Hits:

[Windows CEPocketOBEX_demo

Description: 用MFC实现的在pocket PC之间通过红外技术通信的程序-used in pocket PC through infrared technology communications procedures
Platform: | Size: 35840 | Author: 邢云生 | Hits:

[SCMIR_Rx_Tx

Description: 本程序运行于C8051F330,功能为接收遥控器发出的红外信号,然后等待上位机通过I2C总线来读取。IR数据接收完毕后,不再采集新的IR数据,一直等待上位机将数据取走后才开始准备接收新的IR数据-this program running on the C8051F330, functional remote control device to receive the infrared signal, Then wait for the PC through the I2C bus to read. IR data receiving end, not the acquisition of new IR data have been waiting for the PC will be removed after data began preparing to receive the new IR data
Platform: | Size: 55296 | Author: 龙子 | Hits:

[SCMir_keil

Description: 红外逻辑分析仪源程序,用2051通过串口与上位机通信实现-Logic analyzer infrared source, with 2051 with PC through serial communication
Platform: | Size: 12288 | Author: 周涌 | Hits:

[SCMffyk

Description: 使用Mega16单片机接收红外遥控器信号,并通过232串口送到PC机上,显示所读取的按键的用户码和数据码,相当的准确。晶振为11.0592Mhz。希望对红外遥控信号学习者有所帮助!-Mega16 use single-chip infrared remote control signal receiver, and through serial port 232 to the PC, shows that the key to read the user code and data codes, rather accurate. Crystal for 11.0592Mhz. Infrared remote control signals would like to help learners!
Platform: | Size: 1024 | Author: 乖乖猫 | Hits:

[assembly languageYk_Check

Description: 红外遥控码形检测,通过串口发送数据到PC机 9600,n,8,1,每位+1表示14us-Infrared remote control code type detection, through the serial port to send data to the PC-9600, n, 8,1, each+1 that 14us
Platform: | Size: 4096 | Author: 程威 | Hits:

[Other Embeded programWILLEND

Description: 功能完善的直流电机控制系统 具体功能如下: 1、上位机控制 2、远距离红外遥控 3、7级调速 4、测速 5、堵转自停机 6、停机缓冲 7、所有信息均通过LCD显示 -Functional DC motor control system specific functions as follows: 1, 2, PC control, remote infrared remote control speed regulation 4, 3,7, 5 speed, blocking switched down 6 down 7 buffer, all information through the LCD display
Platform: | Size: 159744 | Author: 王于行 | Hits:

[SCMynxf

Description: 单片机控制红绿灯\栏杆机\红外光幕,显示屏 本程序接受上位机发来的命令:根据命令控制继电器,采用光偶技术控制栏杆机,采用lm339接受红外光墓信息,通过上位机发送汉字信息,在led上显示汉字信息,可以显示任意汉字(最大16*64点阵).-SCM control traffic lights \ railings \ infrared screens, the display of the program accepts commands sent to the host computer: Under the command and control relays, the use of dual technology control railings light, infrared light received by lm339 Tomb of information sent through the PC character information, led display Chinese characters, you can display any character (up to 16* 64 lattice).
Platform: | Size: 2048 | Author: | Hits:

[SCMInfrared-mouse

Description: 用普通遥控器做的电脑鼠标,遥控器发送数据,51单片机解码,通过串口发送到上位机上,在上位机上运行程序,实现鼠标控制-Do with an ordinary remote control computer mouse, the remote control to send data, 51 single-chip decoder, sent through the serial port to the PC, run the program on the host computer, mouse control
Platform: | Size: 9699328 | Author: yumingzhu | Hits:

[SCMIR2PC

Description: 定时器模拟串口红外接收数据,并通过标准串口发送到电脑-Timer analog serial infrared receiver data, and sent to the PC through a standard serial port
Platform: | Size: 10240 | Author: 杜伟 | Hits:

[SCMIRDA

Description: 红外通信,红外接受器接收解码程序,并将接受的红外线码通过串口发送给PC机-Infrared communication, infrared receiver receiver decoding process, and will accept the IR codes sent to the PC through the serial port
Platform: | Size: 33792 | Author: jnss | Hits:

[OtherPL2303HX_BC7210A-SW-V1.0

Description: 红外遥控码解码芯片采集数据,通过UART口上传到PC的VB程序界面。达到直观的测码功能。-Infrared remote control code decoding chip data, uploaded to the PC through the UART port interface of VB program.Achieve visual measurement code function.
Platform: | Size: 9216 | Author: 姚盛华 | Hits:

[Windows Develop红外线上位机

Description: 通过MSCOMM实现串口对SMT32 红外线发射下位机的管理,具备以下功能: 1.串口选择 2.获取下位机接收的遥控器键值 3.设定下位机发送按键的方式,如随机或重复 备注:此工具需配合“红外线发射下位机”工程使用,使用VS2008开发。(Through MSCOMM to manage the lower machine that is SMT32 infrared emission tool,with the following functions: 1. serial port selection 2. get the remote control key received from lower machine 3. set the lower machine to send keys, such as random or repeated Note: This tool should be used in conjunction with "infrared emission lower computer". Developed by VS2008.)
Platform: | Size: 189440 | Author: robinyang | Hits:
« 12 »

CodeBus www.codebus.net