Location:
Search - switch control
Search list
Description: 小程序， 驱动器开关控制程序CDROM-Control
CDROM-Control.rar-small program Drivers switch control procedures CDROM-Control CDROM - Control.rar
Platform: |
Size: 54215 |
Author: Vendow |
Hits:
Description: 自定义的Tabcontrol，非常好看，功能很多，一般的tab控件只能将切换面板放在最上面，这个控件不但可以将面板放在下面而且可以做成非常漂亮的形式，类似语microsoft visual studio下面的输出和调试面板-Tabcontrol, very good looking, a lot of functions, the general tab will only switch control panels on the most above, the control panel will not only be on the bottom but can cause very beautiful form, similar language microsoft visual studio the following output and debugging panels
Platform: |
Size: 4068352 |
Author: 李酒 |
Hits:
Description: DSP, 三相交流异步电机控制程序, C语言, 空间矢量SPWM, 内含PI算法及三相桥开关控制-DSP, 3-phase AC induction motor control procedures, C language, space vector SPWM, intron PI algorithm and switch control of three-phase bridge
Platform: |
Size: 452608 |
Author: 真实 |
Hits:
Description: 小程序， 驱动器开关控制程序CDROM-Control
CDROM-Control.rar-small program Drivers switch control procedures CDROM-Control CDROM- Control.rar
Platform: |
Size: 1902592 |
Author: |
Hits:
Description: 设计一个交通信号灯类：
（1）变量：位置、颜色（红、黄、绿）、显示时间（秒）。
（2）方法：切换信号灯。
创建并启动两个线程（东西向、南北向）同时运行。
3．实验要求
（1）设计线程。
（2）设计路口信号灯示意图界面。
（3）进一步将每个方向的信号灯分成3种车道灯：左转、直行和右转。
（4）根据车流量进行时间的模糊控制。
-design of a traffic signal categories : (1) variables : location, color (red, yellow, green), indicating that time (seconds). (2) Method : Switch lights. Create and start two threads (to the East and West, North and the South to) the same time. 3. Experimental requirements (1) design thread. (2) design matrix interface signal junctions. (3) Further to the signal in each direction, divided into three lanes of lights : turn left, turn right and go straight. (4) According to vehicular traffic for the time of fuzzy control.
Platform: |
Size: 27648 |
Author: 行风 |
Hits:
Description: 基于比例的切换控制函数的滑模控制！对设计倒立摆很有用的！过段时间上传倒立摆程序！正在写中-Based on the ratio of switch control function of the sliding mode control! The design of an inverted pendulum useful! Over time From the inverted pendulum process! Are written in
Platform: |
Size: 3072 |
Author: 刘田 |
Hits:
Description: 光驱开关控制程序
能够自由控制光驱,操作方便-Optical switch control procedures can freely control the drive, convenient operation
Platform: |
Size: 55296 |
Author: 陳勇華 |
Hits:
Description: 51单片机继电器开关控制源码，有注释，编译通过可直接使用。-Source relay switch control 51 single-chip, with annotations, compiled by direct use.
Platform: |
Size: 6144 |
Author: wong santiago |
Hits:
Description: 多路开关控制的proteus仿真电路及C语言程序设计，已经通过调试验证，请放心使用-Multi-switch control of the proteus simulation circuit and the C programming language, has been verified through debugging, please be assured use
Platform: |
Size: 46080 |
Author: 郑威 |
Hits:
Description: 功能简介：
DIP拨码开关控制8个LED灯演示程序
跳线设置：
将将LED、K1~K5左边前4个端子、SW端子用短路冒短接，并将其他无关模块的短路冒拔除
从拨码开关的上侧看去，程序拨码状态，经过BCD译码之后，转化为16进制显示在指示灯上-Features:
DIP DIP switch control 8 LED lights demo
Jumper settings:
Will be LED, K1 ~ K5 left in the four terminals, SW terminals connected by a short circuit risk, and other unrelated modules take the removal of short-circuit
DIP switch from the side looked on, the program code state allocation, through BCD decoding, the conversion of 16 hexadecimal display on the indicator
Platform: |
Size: 8192 |
Author: 小雪 |
Hits:
Description: 在VHDL语言中拨码开关控制米字管的方法-VHDL language in the code switch control method of tube m word
Platform: |
Size: 9216 |
Author: 周明炜 |
Hits:
Description: 《单片机C语言程序设计实训100例——基于8051+Proteus仿真》案例压缩包 第 02 篇 第 02 篇 硬件应用 17 开关控制12864LCD串行模式显示-" Microcontroller C Programming Language Training 100 cases- based on 8051+ Proteus simulation," Case No. 02 cabinet hardware application No. 02 17 switch control 12864LCD serial mode display
Platform: |
Size: 23552 |
Author: 唐虎 |
Hits:
Description: 这是光驱开关控制程序，vc6.0可编译通过。-This is a CD-ROM drive switch control procedures vc6.0 can be compiled by
Platform: |
Size: 55296 |
Author: 董恒 |
Hits:
Description: HF-ExBoard实验板 MC9S12XS128拨码开关控LED源代码-the xs128 DIP switch control LED source code
Platform: |
Size: 198656 |
Author: KY.Qi |
Hits:
Description: Multiple switch control lights
Platform: |
Size: 7168 |
Author: byr2012 |
Hits:
Description: 单片机继电器开关控制程序,C51代码写的.-MCU RELAY switch control code,c51.
Platform: |
Size: 5120 |
Author: pyx1 |
Hits:
Description: Multiple switch control lights
Platform: |
Size: 7168 |
Author: pressbri |
Hits:
Description: 开关控制LED（输入输出概念）是初学者对51单片机必须掌握的一部分-Switch control LED (input/output concept) is part of the beginners of 51 single-chip microcomputer must master
Platform: |
Size: 10240 |
Author: zhang |
Hits:
Description: 关于开关控制的c源文件，可以控制灯自锁、点控。-C source files on the switch control, can control the lamp self-locking, point control.
Platform: |
Size: 1024 |
Author: 罗先谱 |
Hits:
Description: 开关控制LED自动闪烁或由加速度计数值决定是否点亮LED(Switch control LED automatically scintillation or determine whether to light LED by accelerometer value.)
Platform: |
Size: 46080 |
Author: NorthernIO |
Hits:
« 12
3
4
5
6
7
8
9
10
...
50
»