Location:
Search - flash erase
Search list
Description: ti公司的TMS320C6711的flash擦写程序
Platform: |
Size: 7038 |
Author: 赵杰 |
Hits:
Description: 对norflash进行擦初、编程的源码-right norflash rub for the early programming source
Platform: |
Size: 8192 |
Author: 孔凡清 |
Hits:
Description: TI54X 擦除FLASH代码-TI54X erase FLASH code
Platform: |
Size: 8192 |
Author: 马俊 |
Hits:
Description: 此程序为16位Flash擦除烧写的程序实例,可以在51和avr下的c语言跑通-this procedure to erase 16 Flash burning examples of procedures, and 51 avr in the run-language c
Platform: |
Size: 16384 |
Author: 网依 |
Hits:
Description: flash的擦除和写程序参考代码。各位大侠可以根据自己的情况修改即可以使用了-flash erase and write procedures reference code. You can be heroes to their own circumstances that can be used to amend the
Platform: |
Size: 2048 |
Author: 张飞 |
Hits:
Description: This leon3 design is tailored to the Altera NiosII Startix2
Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM.
As of this time, the DDR interface only works up to 120 MHz.
At 130, DDR data can be read but not written.
NOTE: the test bench cannot be simulated with DDR enabled
because the Altera pads do not have the correct delay models.
* How to program the flash prom with a FPGA programming file
1. Create a hex file of the programming file with Quartus.
2. Convert it to srecord and adjust the load address:
objcopy --adjust-vma=0x800000 output_file.hexout -O srec fpga.srec
3. Program the flash memory using grmon:
flash erase 0x800000 0xb00000
flash load fpga.srec-This leon3 design is tailored to the Altera NiosII Startix2
Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM.
As of this time, the DDR interface only works up to 120 MHz.
At 130, DDR data can be read but not written.
NOTE: the test bench cannot be simulated with DDR enabled
because the Altera pads do not have the correct delay models.
* How to program the flash prom with a FPGA programming file
1. Create a hex file of the programming file with Quartus.
2. Convert it to srecord and adjust the load address:
objcopy--adjust-vma=0x800000 output_file.hexout-O srec fpga.srec
3. Program the flash memory using grmon:
flash erase 0x800000 0xb00000
flash load fpga.srec
Platform: |
Size: 114688 |
Author: |
Hits:
Description: 对FLASH对擦除程序，上传给大家相互学习，我用过，可以实现功能-On the erasure of the FLASH program, upload to the U.S. to learn from each other, I used, you can realize the functional
Platform: |
Size: 7168 |
Author: snowmancj |
Hits:
Description: flash文件系统的驱动，包括flash的擦除，flash写，读。id识别等以及文件系统建立。-flash file system drivers, including the flash erase, flash write, read. id identification and documentation system.
Platform: |
Size: 3072 |
Author: 刘利娟 |
Hits:
Description: ti公司的TMS320C6711的flash擦写程序-ti s TMS320C6711 the flash write process
Platform: |
Size: 7168 |
Author: 赵杰 |
Hits:
Description: LPC2200 flash read/erase/write tools, include data check
Platform: |
Size: 18432 |
Author: Chen Kang |
Hits:
Description: msp430f169的flash初始化，ＦＬＡＳＨ擦除＼读ＦＬＡＳＨ
＼写ＦＬＡＳＨ．-msp430f169 the flash initialization, FLASH erase \ Reading FLASH \ write FLASH.
Platform: |
Size: 1024 |
Author: dcpowersupply |
Hits:
Description: cs850实验板的flash存储器编程，实现NOR闪存芯片的厂商ID读取、区块（sector）擦除、字节编程等基本的闪存操作-cs850 experiment board flash memory programming, the realization of NOR flash memory chip maker ID read, block (sector) erase, byte programming flash memory and other basic operations
Platform: |
Size: 3072 |
Author: 王昊 |
Hits:
Description: 对C8051F310 FLASH的在线读写，可无需编程器对FLASH擦除和写入-C8051F310 FLASH on-line reading and writing, without a programmer for FLASH erase and write
Platform: |
Size: 18432 |
Author: wusong |
Hits:
Description: ti tms320c6211 刷写flash的代码，对初学DSP开发者是不错的学习资料-ti tms320c6211 brush flash write code for DSP novice developers is a good learning materials
Platform: |
Size: 124928 |
Author: 小蔡 |
Hits:
Description: K9F1208U0M 的ALE、CLE分别由DSP 的A1 和A0 控制。DSP的低8位数据线直接与闪存的I/O0-I/O7 相连，实现命令、地址和数据的传输； DSP的通用I/O口IOA2 接R/B，监测存储器的工作状态，当R/ B 处于低电平时,表示有编程、擦除或随机读操作正在进行；操作完成后, R/ B 会自动返回高电平。DSP的W E 、R D 分别接FLASH的W E 、R E ， 控制读、写操作。CS2接闪存的片选线CE。-K9F1208U0M the ALE, CLE by the DSP-A1 and A0 control. DSP s low-8 data lines directly connected with the memory of I/O0-I/O7 to achieve order, address and data transmission DSP Universal I/O port IOA2 then R/B, monitoring the work of the state of memory, when R/B at a low level indicates that there are programming, erase or random read operation is ongoing to operate after the completion, R/B will automatically return to high level. DSP-WE, RD, respectively, then FLASH the WE, RE, control of reading and writing operations. CS2 access memory chip line selection CE.
Platform: |
Size: 2048 |
Author: 卢昌荣 |
Hits:
Description: CC1110 CC2510 片上flash操作工程实例
可能过串口终端完成片上flash的擦除或写入动作。-CC1110 CC2510 chip flash operation project examples may be too serial terminal to complete the on-chip flash erase or write action.
Platform: |
Size: 72704 |
Author: 阿伟 |
Hits:
Description: FLASH读写操作，实现对flash空间的擦除和烧写。-FLASH read and write operations, the realization space of flash erase and programmer.
Platform: |
Size: 172032 |
Author: 风 |
Hits:
Description: c8051f020 的flash擦除，读取和写入程序，经实践检验无误。-c8051f020 the flash erase, read and write procedures of proven correct.
Platform: |
Size: 1024 |
Author: 张强 |
Hits:
Description: keil对stm32 ARM单片机编程，实现向Flash中的确定地址进行擦除、读、写操作，并对写入的数据进行校对，最后读出写入到Flash的值并通过串口和LCD打印出来-keil on stm32 ARM microcontroller programming, to determine the address of the Flash erase, read, write, proofread and write data, read the last value written to the Flash and printed through the serial port and LCD
Platform: |
Size: 31744 |
Author: ak |
Hits:
Description: 五屏Flash随机擦除效果的幻灯焦点图,适用于网站首页的幻灯之制作-Flash erase the effect of random five-screen slideshow focus map for the slide of making Home
Platform: |
Size: 141312 |
Author: zhuwenjing |
Hits:
« 12
3
4
5
6
7
8
9
10
...
15
»