Location:
Search - VHDL FRAME
Search list
Description: 帧同步模块的Veriolog源码。
在ModelSim下的一个工程。有测试文件。-frame synchronization module Veriolog source. The ModelSim of a project. A test document.
Platform: |
Size: 24576 |
Author: 刘仪 |
Hits:
Description: 帧同步检测源码,包括同步跟踪模块,fifo,分频模块,还有系统的测试平台-frame synchronization source detection, including synchronous tracking module, fifo, frequency module, and system test platform
Platform: |
Size: 6144 |
Author: liu |
Hits:
Description: This example streams input from a ADC source to a DAC.
An analog signal is acquired block-by-block into SDRAM from the ADC (an AD9244 in this example).
The frames are then output with a one-frame delay to the DAC (an AD9744 in this example).
In this example, no processing is done on the frames. They are passed unaltered.
Platform: |
Size: 23552 |
Author: gaofeng |
Hits:
Description: 实现一个用于CDMA2000系统的短帧交织器,计算比较了12*16,13*15,14*14三种交织形式的性能!-CDMA2000 system for the realization of a short interleaver frame, the calculation compares the 12* 16,13* 15:14* 14 three intertwined forms of performance!
Platform: |
Size: 2048 |
Author: 刘思成 |
Hits:
Description: 用FPGA实现了RS232异步串行通信,所用语言是VHDL,另外本人还有Verilog的欢迎交流学习,根据RS232 异步串行通信来的帧格式,在FPGA发送模块中采用的每一帧格式为:1位开始位+8位数据位+1位奇校验位+1位停止位,波特率为2400。由设置的波特率可以算出分频系数,具体算法为分频系数X=CLK/(BOUND*2)。-Using FPGA to achieve the RS232 asynchronous serial communication, the language used is VHDL, In addition, I also welcome the exchange of learning Verilog, according to RS232 asynchronous serial communication to the frame format, in the FPGA module used to send each frame format : the beginning of a bit+ 8-bit data bit+ 1 bit odd parity bit+ 1 bit stop bit, baud rate for 2400. By setting the baud rate can be calculated at the frequency coefficient, the specific algorithm for the sub-frequency coefficient X = CLK/(BOUND* 2).
Platform: |
Size: 1024 |
Author: saibei007 |
Hits:
Description: TCP/IP Frame Package distributor engine
Platform: |
Size: 208896 |
Author: You |
Hits:
Description: MPEG-2TS 流嵌入控制数据的设计,设计的要求是用控制数据替换MPEG-2 TS 流中的空帧-MPEG-2TS control data stream embedded in the design, the design requirements is to control data to replace MPEG-2 TS stream of the air frame
Platform: |
Size: 251904 |
Author: wq |
Hits:
Description: SDH是现代光纤通信中广泛应用的数据传输格式,在SDH帧结构中,前9列为开销字节,它包含了很多重要的信息,本程序为SDH开销的接收处理,查找帧头,分频,勤务话字节E1异步fifo。可拆为三段源代码,不知道能不能抵三个程序-SDH is a modern optical fiber communication is widely used in data transmission format, in the SDH frame structure, as the former 9 overhead bytes, it contains a lot of important information, the procedures for receiving SDH overhead processing, search header, sub-frequency ,勤務if E1 asynchronous byte fifo. Removable for three source code, I do not know the three procedures can be arrived
Platform: |
Size: 6144 |
Author: 韩冰 |
Hits:
Description: 处理整帧数据的FIFO的巧妙控制设计,能给大家一个参考-To deal with the entire frame of data FIFO control ingenious design, give you a reference
Platform: |
Size: 232448 |
Author: jeff |
Hits:
Description: hdlc帧接收器
包含文件:
设计代码
测试代码
综合脚步
说明文档-HDLC frame receiver include file: design code test code Comprehensive documentation footsteps
Platform: |
Size: 447488 |
Author: wangjie |
Hits:
Description: 使用FPGA/CPLD设置语音AD、DA转换芯片AIC23,FPGA/CPLD系统时钟为24.576MHz
1、AIC系统时钟为12.288MHz,SPI时钟为6.144MHz
2、AIC处于主控模式
3、input bit length 16bit output bit length 16bit MSB first
4、帧同步在96KHz-The use of FPGA/CPLD set voice AD, DA conversion chip AIC23, FPGA/CPLD system clock for the 24.576MHz 1, AIC system clock is 12.288MHz, SPI clock is 6.144MHz 2, AIC is in master mode 3, input bit length 16bit output bit length 16bit MSB first 4, frame synchronization at 96KHz
Platform: |
Size: 2048 |
Author: 张键 |
Hits:
Description: Single power supply operation
— Full voltage range: 2.7 to 3.6 volt read, erase, and
program operations
— Separate VCCQ for 5 volt I/O tolerance
n Automated Program and Erase
— Page program: 512 + 16 bytes
— Block erase: 8 K + 256 bytes
n Block architecture
— 8 Kbyte blocks + 256 byte spare area
(separately erasable, readable, and programmable)
— 512 byte page + 16 byte spare area for ECC and other
system overhead information
n Fast read and program performance (typical values)
— Read: < 7 μs initial, < 50 ns sequential
— Program: 200 μs (full page program at 400 ns/byte)
— Erase: < 2 ms/8 Kbyte block
n Pinout and package
— Industry Standard NAND compatible pinout with 8-bit
I/O bus and control signals
— TSOP-II 44/40 pin package (standard and reverse)
with copper lead frame for higher reliability
— 40-ball FBGA package provides higher reliability-Single power supply operation
— Full voltage range: 2.7 to 3.6 volt read, erase, and
program operations
— Separate VCCQ for 5 volt I/O tolerance
n Automated Program and Erase
— Page program: 512+ 16 bytes
— Block erase: 8 K+ 256 bytes
n Block architecture
— 8 Kbyte blocks+ 256 byte spare area
(separately erasable, readable, and programmable)
— 512 byte page+ 16 byte spare area for ECC and other
system overhead information
n Fast read and program performance (typical values)
— Read: < 7 μs initial, < 50 ns sequential
— Program: 200 μs (full page program at 400 ns/byte)
— Erase: < 2 ms/8 Kbyte block
n Pinout and package
— Industry Standard NAND compatible pinout with 8-bit
I/O bus and control signals
— TSOP-II 44/40 pin package (standard and reverse)
with copper lead frame for higher reliability
— 40-ball FBGA package provides higher reliability
Platform: |
Size: 847872 |
Author: enyou |
Hits:
Description: 由于目前基于CameraLink接口的各种相机都不能直接显示,因此本文基于Xilinx公司的Spartan 3系列FPGAXC3S1000-6FG456I设计了一套实时显示系统,该系统可以在不通过系统机的情况下,完成对相机CameraLink信号的接收、缓存、读取并显示 系统采用两片SDRAM作为帧缓存,将输入的CameraLink信号转换成帧频为75Hz,分辨率为1 024×768的XGA格式信号,并采用ADV7123JST芯片实现数模转换,将芯片输出的信号送到VGA接口,通过VGA显示器显示出来-As the CameraLink interface is currently based on a variety of cameras can not directly display, this article based on Xilinx' s Spartan 3 series FPGAXC3S1000-6FG456I designed a set of real-time display system, the system can be achieved without machine case through the system to complete the CameraLink cameras signal reception, cache, read and display systems use two SDRAM frame buffer as the input signals into the CameraLink frame rate of 75Hz, a resolution of 1 024 × 768 for XGA format signal, and using ADV7123JST chip digital-analog conversion, the chip output signal to the VGA port, through the VGA display monitor
Platform: |
Size: 13312 |
Author: lilei |
Hits:
Description: 高级链路层协议的实现,vhdl,fpga-- 8 bit parallel backend interface
- use external RX and TX clocks
- Start and end of frame pattern generation
- Start and end of frame pattern checking
- Idle pattern generation and detection (all ones)
- Idle pattern is assumed only after the end of a frame which is signaled by an abort signal
- Zero insertion
- Abort pattern generation and checking
- Address insertion and detection by software
- CRC generation and checking (Optional, external, since CRC-16 or CRC-32 can be used)
- FIFO buffers and synchronization (External)
- Byte aligned data (if data is not aligned to 8-bits extra random bits are inserted)
- Q.921, LAPB and LAPD compliant.
- For complete specifications refer to spec document
Platform: |
Size: 188416 |
Author: |
Hits:
Description: PCM采编器,帧长64字,字长为8位,地址分配如下: 帧同步码 0,1路 模拟通道 2-50路 数字通道 51-63路,串行输出数据,输出地址,模拟通道片选,数字通道片选-PCM editing device, frame length 64 characters, word length of 8-bit address as follows: frame synchronization yards 0,1 analog channels 2-50 channel digital channels 51-63 Lu, serial output data, output address, analog channel film election, the digital channel chip select
Platform: |
Size: 4096 |
Author: 虎 |
Hits:
Description: 一个关于SDH中TU-12解帧的VHDL代码-On the SDH in a solution of TU-12 frame VHDL code for
Platform: |
Size: 1698816 |
Author: liyuan |
Hits:
Description: 在国际标准组织开放式系统互联(OSI)参考模型下,以太网是第二层协议。10G以太网使用IEEE(电气与电子工程师学会)802.3以太网介质访问控制协议(MAC)、IEEE 802.3以太网帧格式以及IEEE 802.3最小和最大帧尺寸。-In the International Standards Organization Open Systems Interconnect (OSI) reference model, Ethernet is the second-layer protocol. 10G Ethernet using the IEEE (Institute of Electrical and Electronics Engineers) 802.3 Ethernet Media Access Control Protocol (MAC), IEEE 802.3 Ethernet frame format, as well as the minimum and maximum IEEE 802.3 frame size.
Platform: |
Size: 1723392 |
Author: guoguo |
Hits:
Description: The Serial Peripheral Interface Bus or SPI bus is a synchronous serial data link standard named by Motorola that operates in full duplex mode. Devices communicate in master/slave mode where the master device initiates the data frame. Multiple slave devices are allowed with individual slave select (chip select) lines. Sometimes SPI is called a "four wire" serial bus, contrasting with three, two, and one wire serial buses.-The Serial Peripheral Interface Bus or SPI bus is a synchronous serial data link standard named by Motorola that operates in full duplex mode. Devices communicate in master/slave mode where the master device initiates the data frame. Multiple slave devices are allowed with individual slave select (chip select) lines. Sometimes SPI is called a "four wire" serial bus, contrasting with three, two, and one wire serial buses.
Platform: |
Size: 478208 |
Author: wei |
Hits:
Description: ofdm系统中的完整帧同步模块,基于verilog实现。-ofdm system full frame synchronization module, based on verilog implementation.
Platform: |
Size: 571392 |
Author: 罗云 |
Hits:
Description: 基于VHDL帧同步提取建模与设计 该设计主要是在一帧数据的前后插入巴克码-Based on VHDL frame synchronization extraction modeling and design
Platform: |
Size: 51200 |
Author: 启哈发 |
Hits: